MM4XXG-10

Double Balanced Mixer Multi-Octave Band Electrical Specifications: (1) Model MM4xxG-10 RF 2.0 to 8.0 GHz Conditions Parameter SSB Conversion loss: (2) (3) Isolation LO to RF: LO to IF: RF to IF: Input 1 dB Compression Point: Input Third Order Intercept Point: LO Power: (4) 2.0-8.0 2.0-8.0 RF (GHz) 2.0-8.0 2.0-8.0 2.0-8.0 LO (GHz) 2.0-8.0 2.0-8.0 2.0-8.0 2.0-8.0 2.0-3.0 3.0-8.0 2.0-8.0 DC-1500 IF (MHz) DC-500 DC-1200 DC-1500 Min Specifications Typical 5.4 dB 6.4 dB 6.7 dB 33 dB 24 dB 34 dB 22 dB +1 dBm +4 dBm +8 dBm +12 dBm +11 dBm +14 dBm +18 dBm +22 dBm +7 dBm +10 dBm +14 dBm +19 dBm Max 7.5 dB 8.5 dB 9.0 dB Model MM4xxG-10 LO Power 3 = +7 dBm 4 = +10 dBm 6 = +14 dBm 7 = +19 dBm Drop-In Module or With SMA(F) Connectors M = Module P = With Connectors 25 dB 18 dB 25 dB 2.0-8.0 2.0-8.0 DC-1500 2.0-8.0 2.0-8.0 DC-1500 MM43 MM44 MM46 MM47 MM43 MM44 MM46 MM47 MM43 MM44 MM46 MM47 Notes: 1. Specifications are guaranteed when tested as a downconverter in a 50 Ohm system from -55˚ C to +100˚ C with the nominal LO power. Specifications indicated as typical are not guaranteed. 2. Noise figure is typically within ±0.5 dB of conversion loss for IF frequencies greater than 10 MHz. 3. Conversion loss typically degrades less than 0.5 dB at +100˚ C and improves less than 0.5 dB at -55˚ C. 4. Usable LO drives are up to 2 dB below and 3 dB above nominal. MM4xxG-10 Outline: G Typical Performance at 25˚C “MG” WITHOUT CONNECTORS “PG” WITH REMOVABLE CONNECTORS All dimensions are in inches and [mm]. Spectrum M icrowave · 2 144 F ranklin D rive N .E. · P alm B a y, F L 3 2905 · P H ( 888) 5 53-7531 · F ax ( 888) 5 53-753 2 Rev. 2/8/07 www.SpectrumMicrowave.com Spectrum M icrowave (Europe) · 2 707 Black Lake Place · P hiladelphia, PA 19154 · P H ( 215) 464-4000 · F ax ( 215) 464-4001