SDR12G

SDR12 Series Solid State Devices, Inc. 14830 Valley View Blvd * La Mirada, Ca 90638 Phone: (562) 404-7855 * Fax: (562) 404-1773 ssdi@ssdi-power.com * www.ssdi-power.com Designer’s Data Sheet • • • • • • • • FEATURES: Standard Recovery: 5 µsec maximum PIV up to 800 Volts High Current Operation up to 12 A Hermetically Sealed Single Chip Construction Low Thermal Resistance TX, TXV, and Space Level Screening Available Fast and Ultrafast Recovery Versions Available. Contact Factory. 12 AMPS 200 - 1000 VOLTS 5 µsec STANDARD RECOVERY RECTIFIER Axial Surface Mount Square Tab (SMS) MAXIMUM RATINGS Peak Repetitive Reverse Voltage and DC Blocking Voltage Average Rectified Forward Current (Resistive Load, 60 Hz, Sine Wave, TA = 55oC) Peak Surge Current (8.3 ms Pulse, Half Sine Wave, Superimposed on IO, allow junction to reach equilibrium between pulses, TA = 25oC) Operating and Storage Temperature Maximum Thermal Resistance Junction to Lead, L = 0.125” (Axial Lead) Junction to End Tab (Surface Mount ) SDR12D SDR12G SDR12J SDR12K SDR12M Symbol VRRM VRWM VR IO IFSM TOP & Tstg RθJL RθJE Value 200 400 600 800 1000 12 150 -65 to +175 6 4 Units Volts Amps Amps o C o C/W NOTE: All specifications are subject to change without notification. SCD's for these devices should be reviewed by SSDI prior to release. DATA SHEET #: RC0091A DOC SDR12 Series Solid State Devices, Inc. 14830 Valley View Blvd * La Mirada, Ca 90638 Phone: (562) 404-7855 * Fax: (562) 404-1773 ssdi@ssdi-power.com * www.ssdi-power.com ELECTRICAL CHARACTERISTICS Instantaneous Forward Voltage Drop (IF = 12 Amps, TA = 25oC, 300µsec Pulse) Reverse Leakage Current (At Rated VR, 300µsec pulse minimum) Junction Capacitance (VR = 10 VDC, TA = 25oC, f = 1 MHz) Reverse Recovery Time (IF = 500 mA, IR = 1 A, IRR = 250 mA, TA = 25oC) Case Outline: (Axial) TA = 25oC TA = -55oC TA = 25oC TA = 100oC Symbol VF1 VF2 IR1 IR2 CJ trr Min –– –– –-–– –– –– Max 1.30 1.50 5.0 200 80 5 MIN –– 0.140” 0.057” 0.500” Unit Volts Volts µA µA pF µs MAX 0.190” 0.180” 0.063” –– DIM A B C D Case Outline: (SMS) DIM A B C D MIN 0.195” 0.190” 0.020” 0.002” MAX 0.210” 0.230” 0.030” –– Note: Dimensions prior to soldering. NOTES: Consult manufacturing for operating curves.