940-SP-361010-A108

Stewart Connector 36 SERIES SHIELDED PLUG W/-A108 LOAD BAR ASSEMBLY INSTRUCTIONS 11118 Susquehanna Trail South Glen Rock, PA 17327 36 SERIES SHIELDED PLUG WITH –A108 LOAD BAR ASSEMBLY INSTRUCTIONS Assembly steps 1 – 11: 1 Slide strain relief over cable 2 3 Trim off 1” to 2” of cable jacket Fold back shield and drain wire 78 12 4 Slide ferrule over jacket and shield. Do no trap any insulation between shield and ferrule Crimp ferrule. Position pairs 12 and 78 to the outside 7 Untwist and straighten pairs Page 1 of 2 6 5 8 Align pairs (568-B shown) Remove excess shield. Remove plastic foil insulation if present 9 Place wires into –A108 load bar. Trim wires flush with end of load bar MN360015-A1 Stewart Connector 36 SERIES SHIELDED PLUG W/-A108 LOAD BAR ASSEMBLY INSTRUCTIONS 11118 Susquehanna Trail South Glen Rock, PA 17327 36 SERIES SHIELDED PLUG WITH –A108 LOAD BAR ASSEMBLY INSTRUCTIONS Assembly steps 1 – 11 (Cont.): 10 Insert load bar and wires into plug housing 11 Verify wire ends are visible through plug housing 12 Terminate housing onto cable 13 Slide strain relief over housing. Assembly is now complete Page 2 of 2 MN360015-A1