943-SP-370808SM2-SMK

Stewart Connector 1 37 SERIES SHIELDED UNIBODY PLUG ASSEMBLY INSTRUCTIONS 11118 Susquehanna Trail South Glen Rock, PA 17327 2 Strip off approx. 2” of cable jacket 3 Fold shield back over jacket Wrap drain wire around cable and trim insulating film layer 0.6” 4 Untwist and Straighten pairs 7 Slide wires into place. Hold housing at slight angle to cable as shown Page 1 of 1 5 6 Arrange pairs (TIA 568-B shown) and trim at 0.6” Insert wires into housing 8 At least one wrap of drain wire should be inside plug body 9 Make sure all wires are visible through end of plug, then crimp contacts and strain relief, then trim shield and drain wire. MN370058-A2