2STF2360

2STF2360 Low voltage fast-switching PNP power transistors Datasheet - production data Applications • Emergency lighting 4 3 • LED 2 1 • Voltage regulation • Relay drive SOT-89 Figure 1. Internal schematic diagram Description The device is PNP transistor manufactured using new “PB-HDC” (power bipolar high density current) technology. The resulting transistor shows exceptional high gain performances coupled with very low saturation voltage. Features • Very low collector-emitter saturation voltage • High current gain characteristic • Fast-switching speed Table 1. Device summary Order code Marking Package Packaging 2STF2360 2360 SOT-89 Tape and reel December 2014 This is information on a product in full production. DocID13309 Rev 6 1/11 www.st.com Contents 2STF2360 Contents 1 Absolute maximum ratings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 2 Electrical characteristics . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 3 2.1 Typical characteristics (curves) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 2.2 Test circuits . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Package mechanical data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 3.1 4 2/11 SOT-89 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Revision history . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 DocID13309 Rev 6 2STF2360 1 Absolute maximum ratings Absolute maximum ratings Table 2. Absolute maximum ratings Symbol Parameter Value Unit VCBO Collector-base voltage (IE = 0) -60 V VCEO Collector-emitter voltage (IB = 0) -60 V VEBO Emitter-base voltage -6 V Collector current -3 A Collector peak current (tP < 5 ms) -5 A Base current -0.2 A Base peak current (tP < 5 ms) -0.4 A Total dissipation at Tamb = 25 °C 1.4 W -65 to 150 °C 150 °C IC ICM IB IBM PTOT Tstg TJ (IC = 0) Storage temperature Max. operating junction temperature Table 3. Thermal data Symbol RthJA(1) Parameter Thermal resistance junction-ambient ___ _Max SOT-89 Unit 89 °C/W 1. Device mounted on a PCB area of 1 cm2 DocID13309 Rev 6 3/11 11 Electrical characteristics 2 2STF2360 Electrical characteristics TCASE = 25°C; unless otherwise specified. Table 4. Electrical characteristics Symbol Parameter Test conditions Typ. Max. Unit ICBO Collector cut-off current (IE = 0) VCB = - 60 V -100 nA IEBO Emitter cut-off current (IC = 0) VEB = - 6 V -100 nA Base-emitter on voltage VCE = - 2 V IC = - 100 mA -650 -730 mV VCE(sat)(1) Collector-emitter saturation voltage IC = - 2 A IC = - 3 A _ IB = - 100 mA IB = - 150 mA -200 -300 -320 -500 mV mV VBE(sat) (1) Base-emitter saturation voltage IC = - 2 A _ IB = -100 mA -0.9 -1.2 V DC current gain IC = - 100 mA_ VCE = - 2 V IC = - 1 A _ VCE = - 2 V IC = - 3 A VCC = - 10 V IB(on) = - IB(off) = - 300 mA VBE(off) = 5 V tf Resistive load Delay time Rise time Storage time Fall time 10 75 250 35 fT Transition frequency IC = - 0.1 A __ VCE = - 10 V 130 VBE(on) hFE (1) td tr ts 1. Pulse test: pulse duration ≤ 300 µs, duty cycle ≤ 2 % 4/11 Min. DocID13309 Rev 6 -630 200 160 400 15 100 350 50 ns ns ns ns MHz 2STF2360 2.1 Electrical characteristics Typical characteristics (curves) Figure 2. DC current gain (VCE = - 2 V) Figure 3. DC current gain (VCE = - 5 V) Figure 4. Collector emitter saturation voltage Figure 5. Base emitter saturation voltage 9&(VDW  >9@ 7- ƒ& 7- ƒ&  7- ƒ&      ,F>$@  Figure 6. Resistive load switching on Figure 7. Resistive load switching off DocID13309 Rev 6 5/11 11 Electrical characteristics 2STF2360 Figure 8. Capacitances 2.2 Test circuits Figure 9. Resistive load switching 1. Fast electronic switch 2. Non-inductive resistor 6/11 DocID13309 Rev 6 2STF2360 3 Package mechanical data Package mechanical data In order to meet environmental requirements, ST offers these devices in different grades of ECOPACK® packages, depending on their level of environmental compliance. ECOPACK® specifications, grade definitions and product status are available at: www.st.com. ECOPACK® is an ST trademark. 3.1 SOT-89 Figure 10. SOT-89 package outline B5(9B( DocID13309 Rev 6 7/11 11 Package mechanical data 2STF2360 Table 5. SOT-89 mechanical data mm Dim. Min. Typ. A 1.40 1.60 B 0.44 0.56 B1 0.36 0.48 C 0.35 0.44 C1 0.35 0.44 D 4.40 4.60 D1 1.62 1.83 D3 8/11 Max. 0.90 E 2.29 2.60 e 1.42 1.57 e1 2.92 3.07 H 3.94 4.25 H1 2.70 3.10 K 1° 8° L 0.89 1.20 R 0.25 b 90° DocID13309 Rev 6 2STF2360 Package mechanical data Figure 11. SOT-89 recommended footprint )RRWSULQW DocID13309 Rev 6 9/11 11 Revision history 4 2STF2360 Revision history Table 6. Document revision history Date Revision 13-Sep-2006 1 Initial release 02-Mar-2007 2 New graphics have been added 23-Jan-2009 3 Updated mechanical data 09-Oct-2009 4 Added 2STD2360T4 in TO-252 (DPAK) package 14-Oct-2009 5 Modified Table 1 on page 1. 6 Removed SOT-223 and TO-250 (DPAK) packages. Update description in cover page, Table 1: Device summary, Section 1: Absolute maximum ratings, Table 4: Electrical characteristics, Section 2.1: Typical characteristics (curves) and Section 3: Package mechanical data. Minor text changes. 05-Dec-2014 10/11 Changes DocID13309 Rev 6 2STF2360 IMPORTANT NOTICE – PLEASE READ CAREFULLY STMicroelectronics NV and its subsidiaries (“ST”) reserve the right to make changes, corrections, enhancements, modifications, and improvements to ST products and/or to this document at any time without notice. Purchasers should obtain the latest relevant information on ST products before placing orders. ST products are sold pursuant to ST’s terms and conditions of sale in place at the time of order acknowledgement. Purchasers are solely responsible for the choice, selection, and use of ST products and ST assumes no liability for application assistance or the design of Purchasers’ products. No license, express or implied, to any intellectual property right is granted by ST herein. Resale of ST products with provisions different from the information set forth herein shall void any warranty granted by ST for such product. ST and the ST logo are trademarks of ST. All other product or service names are the property of their respective owners. Information in this document supersedes and replaces information previously supplied in any prior versions of this document. © 2014 STMicroelectronics – All rights reserved DocID13309 Rev 6 11/11 11