AVS12CB

AVS12 ® AUTOMATIC VOLTAGE SWITCH (SMPS < 500W) CONTROLLER 50/60Hz FULL COMPATIBILITY INTEGRATED VOLTAGE REGULATOR TRIGGERING PULSE TRAIN OF THE TRIAC PARASITIC FILTER LOW POWER CONSUMPTION ■ ■ ■ ■ A2 ■ TRIAC HIGH EFFICIENCY AND SAFETY SWITCHING UNINSULATED PACKAGE : AVS12CB VDRM = ± 600 V IT(RMS) : 12A A1 ■ G A2 ■ ■ ■ DESCRIPTION The AVS12 kit is an automatic mains selector (110/220V AC) to be used in SMPS < 500 W. It is composed of 2 devices : The Controller is optimized for low consumption and high security triggering of the triac. When connected to VSS, the mode input activates an additional option. If the main power drops from 220V to 110V, the triac control remains locked to the 220V mode and avoids any high voltage spike when the voltage is restored to 220V. When connected to VDD, the mode input desactivates this option. The TRIAC is specially designed for this application. An optimization between sensitivity and dynamic parameters of the triac gate highly reduces the losses of supply resistor and allows excellent immunity against disturbances. ■ ■ January 2002 - Ed: 3C AVS1ACP08 DIP-8 AVS12CB TO-220AB PIN CONNECTION VSS 1 8 VM Osc / In 2 7 Mode Osc / Out 3 6 N.C. VDD 4 5 VG 1/7 AVS12 BLOCK DIAGRAM AVS1ACP08 MODE AVS12CB Supply Reset A2 Peak Voltage Detector Parasitic Filter Mains mode Controller CP Zero Crossing Detector Q S CP OSC/IN Triggering Q Time Controller A1 Oscillator OSC/OUT ABSOLUTE MAXIMUM RATINGS CONTROLLER AVS1ACP08 Symbol VSS Parameter Min. Max. Unit -12 0.5 V VI / VO I / O voltage VSS -0.5 0.5 V I I / IO I / O current -40 +40 mA Tstg Storage Temperature -60 +150 °C 0 +70 °C Toper Supply voltage Value Operating Temperature code ''C'' TRIAC AVS12CB Tj = +25°C (unless otherwise specified) Symbol Parameter Value Unit ± 600 V VDRM Repetitive peak off-state voltage (2) IT(RMS) RMS on-state current (360° conduction angle) TC = 70°C 12 A Non repetitive surge peak on-state current ( Tj initial = 25°C ) t = 8.3ms t = 10ms 105 100 A I2t value t = 10ms 50 A2s Repetitive F = 50Hz 20 A/µs Non Repetitive 100 Tj = 110°C 50 V/µs - 40 + 150 0 + 125 °C ITSM I2t dI / dt Critical rate of rise of on-state current (1) dV/dt * Linear slope up to 0.67 VDRM Tstg Tj Storage Temperature Junction Temperature Range (1) Gate supply : IG = 100mA – di/dt = 1A/µs (2) Tj = 110°C 2/7 Gate open * For either polarity of electrode A2 voltage with reference to electrode A1 AVS12 THERMAL RESISTANCE TRIAC AVS12CB Symbol Parameter Value Unit Junction to ambient 60 °C/W Rth (j-c) DC Junction to case for DC 3 °C/W Rth (j-c) AC Junction to case for 360° conduction angle (F = 50Hz) 2.3 °C/W Rth (j-a) DC GENERAL ELECTRICAL CHARACTERISTICS TRIAC AVS12CB Value Symbol Parameter Unit Min. VGD Max. VD = VDRM RL = 3.3kΩ Pulse duration > 20µs Tj = 110°C VTM * ITM = 17A Tj = 25°C 1.75 V IDRM * VDRM rated Tj = 25°C 10 µA Tj = 110°C 500 tp = 10ms Gate open 0.2 V * For either polarity of electrode A2 voltage with reference to electrode A1 Fig. 1: Maximum RMS power dissipation versus RMS on-state current (F = 60Hz). (Curves are cut off by (dI/dt)c limitation) Fig. 2: Correlation between maximum mean power dissipation and maximum allowable temperature (Tamb and Tcase) for different thermal resistances heatsink + contact. 3/7 AVS12 Fig. 3: Non repetitive surge peak on-state current for a sinusoidal pulse with width: t≤10ms, and corresponding value of I2t. Fig. 4: On-state characteristics (maximum values). DC GENERAL ELECTRICAL CHARACTERISTICS (continued) CONTROLLER AVS1ACP08 Toper = 25°C (unless otherwise specified) Value Symbol Parameter Unit Min. Typ. Max. -9 -8 V 30 mA 0.7 mA VSS (pin 1) (Vreg) Shunt regulator -10 ISS (pin 1) (Vreg) (@ VSS = 9V) Supply current 0.4 ISS (pin 1) (@ triac gate non connected) Quiescent current F (pin 3) (@ R = 91kΩ) (C = 100pF) Oscillator frequency 42 44 46 KHz VM (pin 8) Vth (3) Peak voltage of detection high-threshold 4.08 4.25 4.42 V VM (pin 8) Vh (3) Peak voltage of detection hysteresis 0.370 0.4 0.420 V Zero-crossing detection high-threshold 95 110 125 mV Zero-crossing detection hysteresis 27 50 80 mV (1) VM (pin 8) VM (pin 8) Vth (3) Vh (3) (2) Vrazht (4) Power-on-reset activation threshold (2) Vrazlt (4) Power-down-reset activation threshold Mode (pin 7) VIL VIH (4) (4) Vreg x 0.89 3 V 6.5 V 0.3 Vreg V 0.7 Vreg NOTE: (1) : This value gives a typical noise immunity on the zero-crossing detectionof 110mV x 1018/18 = 6.20V on the main supply (2) : See following diagram (3) : Voltage referred to VSS (4) : Voltage referred to VDD 4/7 AVS12 POWER-ON AND POWER-OFF RESET BEHAVIOUR Normal operation Undetermined Power-on reset Power-off reset Undetermined 0V 0V -2.7V -2.7V Vrazlt Vrazht Vreg = VSS - VDD TYPICAL APPLICATION 110 V or 220V NTC NTC 1N 4007 2 x 9.1KΩ 1W R1 1MΩ 1% R2 18KΩ 1% option VDD VM VSS 390Ω 7 8 5 AVS1ACP08 3 2 91kΩ 1 % 100pF 5 % AVS12CB 1 VG A2 G A1 4V DD VSS 33µF 16V AVS12 5/7 AVS12 ORDERING INFORMATION AVS12 CONTROLLER TRIAC AVS 1A C P08 AUTOMATIC VOLTAGE SWITCH AVS 12 C B AUTOMATIC VOLTAGE SWITCH PACKAGE: DIP-8 IDENTIFICATION IDENTIFICATION OPERATING TEMPERATURE C = 0/70°C PACKAGE B: TO-220AB OPERATING TEMPERATURE C = 0/70°C PACKAGE MECHANICAL DATA DIP-8 Plastic (controller) DIMENSIONS REF. B1 B b Typ. Max. Min. L F a1 0.70 0.027 B 1.39 1.65 0.055 0.065 B1 0.91 1.04 0.036 0.041 b Z E b1 0.5 0.38 D 8 5 1 4 0.020 0.50 0.015 0.020 9.80 0.385 E 8.8 0.346 e 2.54 0.100 e3 7.62 0.300 F 7.1 0.280 I 4.8 0.189 L Z 6/7 Typ. Max. b1 e e3 D Inches Min. I a1 Millimetres 3.3 0.44 0.130 1.60 0.017 0.063 AVS12 PACKAGE MECHANICAL DATA TO-220AB (Plastic) (Triac) DIMENSIONS REF. B Millimeters Inches Min. Typ. Max. Min. Typ. Max. C b2 A 15.20 a1 L 15.90 0.598 3.75 0.625 0.147 a2 13.00 14.00 0.511 0.551 B 10.00 10.40 0.393 0.409 b1 0.61 0.88 0.024 0.034 b2 1.23 1.32 0.048 0.051 C 4.40 4.60 0.173 0.181 c1 0.49 0.70 0.019 0.027 c2 2.40 2.72 0.094 0.107 e 2.40 2.70 0.094 0.106 F 6.20 6.60 0.244 0.259 I 3.75 3.85 0.147 0.151 I4 15.80 16.40 16.80 0.622 0.646 0.661 F I A l4 c2 a1 l3 l2 a2 b1 L 2.65 2.95 0.104 0.116 l2 1.14 1.70 0.044 0.066 l3 1.14 1.70 0.044 0.066 M c1 e M ■ ■ ■ 2.60 0.102 Cooling method: C Recommended torque value: 0.8 m.N Maximum torque value: 1 m.N OTHER INFORMATION Part Number Marking Weight Base Qty Packing mode AVS12CB AVS12CB 2.3 g 1000 Tube AVS1ACP08 AVS1ACP08 0.6 g 2000 Tube Information furnished is believed to be accurate and reliable. However, STMicroelectronics assumes no responsibility for the consequences of use of such information nor for any infringement of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of STMicroelectronics. Specifications mentioned in this publication are subject to change without notice. This publication supersedes and replaces all information previously supplied. STMicroelectronics products are not authorized for use as critical components in life support devices or systems without express written approval of STMicroelectronics. The ST logo is a registered trademark of STMicroelectronics © 2002 STMicroelectronics - Printed in Italy - All rights reserved. STMicroelectronics GROUP OF COMPANIES Australia - Brazil - Canada - China - Finland - France - Germany Hong Kong - India - Israel - Italy - Japan - Malaysia - Malta - Morocco - Singapore Spain - Sweden - Switzerland - United Kingdom - United States. http://www.st.com 7/7