LM833

LM833 LOW NOISE DUAL OPERATIONAL AMPLIFIERS . . . . . . LOW VOLTAGE NOISE : 4.5nV/√Hz   HIGH GAIN BANDWIDTH PRODUCT : 15MHz HIGH SLEW RATE : 7V/µs LOW DISTORTION : 0.002% EXCELLENT FREQUENCY STABILITY ESD PROTECTION 2kV N DIP8 (Plastic Package) D SO8 (Plastic Micropackage) DESCRIPTION The LM833 is a monolithic dual operational amplifier dedicated to audio applications. The LM833 offers low voltage noise (4.5nV/√ ) and high  Hz frequency performances (15MHz gain bandwidth product, 7V/µs slew rate). In additionthe LM833 has also a very low distortion (0.002%) and excellent phase/gain margins. PIN CONNECTIONS (top view) ORDER CODES Part Number LM833 Temperature Range -40, +105 oC Package N • D • Output 1 Inverting input 1 Non-invertinginput 1 1 2 3 -4 8 + + VCC+ Output 2 Inverting input 2 Non-inverting input 2 7 6 5 V CC December 1997 1/5 LM833 SCHEMATIC DIAGRAM (1/2 LM833) VCC Output Inverting Input Non-inverting Input VCC ABSOLUTE MAXIMUM RATINGS Symbol VCC Vid Vi Toper Tj Tstg Ptot Notes : Parameter Supply Voltage Differential Input Voltage - (note 1) Input Voltage - (note 1) Output Short-Circuit Duration - (note 2) Operating Free-air Temperature Range Maximum Junction Temperature Storage Temperature Maximum Power Dissipation - (note 2) Value ±18 or +36 ± 30 ± 15 Infinite -40 to +105 +150 -65 to +150 500 Unit V V V o o o C C C mW 1. Either or both input voltages must not exceed the magnitude of VCC+ or VCC2. Power dissipation must be considered to ensure maximum junction temperature (T j) is not exceeded OPERATING CONDITIONS Symbol VCC Supply Voltage Parameter Value ±2.5 to ± 15 Unit V 2/5 LM833 ELECTRICAL CHARACTERISTICS VCC+ = +15V, VCC- = -15V, Tamb = 25oC (unless otherwise specified) Symbol Vio DVio Iio Iib Vicm Avd ±Vopp Parameter Input Offset Voltage (Rs = 10Ω, Vo = 0V, Vic = 0V) Input Offset Voltage Drift Rs = 10Ω, Vo = 0V, Tmin. ≤ Tamb ≤ Tmax. Input Offset Current (Vic = 0V, VO = 0V) Input Bias Current (Vic = 0V, VO = 0V) Common Mode Input Voltage Range Large Signal Voltage Gain (RL = 2kΩ, VO = ±10V) Output Voltage Swing (Vid = ±1V) R L = 2.0kΩ R L = 2.0kΩ R L = 10kΩ R L = 10kΩ ±12 90 10 12 80 80 Min. Typ. 0.3 2 25 300 ±14 100 13.7 -14 13.9 -14.4 100 105 4 5 10 7 15 9 60 4.5 0.5 0.002 120 120 dB kHz MHz MHz Degrees nV  Hz √ pA  Hz √ % 8 mA V/µs 200 1000 nA nA V dB V -10 -12 dB dB Max. 5 Unit mV µV/oC CMR SVR ICC SR GBP B ∅m en in THD VO1/VO2 FPB Common Mode Rejection Ratio (Vic = ±12V) Supply Voltage Rejection Ratio + VCC / VCC = +15V / -15V to +5V / -5V Supply current (VO = 0V, All Amplifiers) Slew Rate Vi = -10V to +10V, RL = 2kΩ, AV = +1V) Gain Bandwidth Product (f = 100kHz, R L = 2kΩ, CL = 100pF) Unity Gain Bandwidth (Open loop) Phase Margin Equivalent Input Noise Voltage (R S = 100Ω, f = 1kHz) Equivalent Input Noise current (f = 1kHz) Total Harmonic Distortion RL = 2kΩ, f = 20Hz to 20kHz, VO = 3Vrms, AV = +1 Channel Separation (f = 20Hz to 20kHz) Full Power Bandwidth (VO = 27Vpp, RL = 2kΩ, THD ≤ 1%) 3/5 LM833 PACKAGE MECHANICAL DATA 8 PINS - PLASTIC DIP Dim. A a1 B b b1 D E e e3 e4 F i L Z Millimeters Min. 0.51 1.15 0.356 0.204 7.95 2.54 7.62 7.62 6.6 5.08 3.18 3.81 1.52 0.125 1.65 0.55 0.304 10.92 9.75 0.313 Typ. 3.32 0.020 0.045 0.014 0.008 Max. Min. Inches Typ. 0.131 0.065 0.022 0.012 0.430 0.384 0.100 0.300 0.300 0260 0.200 0.150 0.060 DIP8.TBL Max. 4/5 PM-DIP8.EPS LM833 PACKAGE MECHANICAL DATA 8 PINS - PLASTIC MICROPACKAGE (SO) Dim. A a1 a2 a3 b b1 C c1 D E e e3 F L M S Min. 0.1 0.65 0.35 0.19 0.25 4.8 5.8 Millimeters Typ. Max. 1.75 0.25 1.65 0.85 0.48 0.25 0.5 45 (typ.) 5.0 6.2 o Min. 0.004 0.026 0.014 0.007 0.010 0.189 0.228 Inches Typ. Max. 0.069 0.010 0.065 0.033 0.019 0.010 0.020 0.197 0.244 1.27 3.81 3.8 0.4 4.0 1.27 0.6 8 (max.) o 0.050 0.150 0.150 0.016 0.157 0.050 0.024 Information furnished is believed to be accurate and reliable. However, SGS-THOMSON Microelectronics assumes no responsibility for the consequences of use of such information nor for any infringement of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of SGS-THOMSON Microelectronics. Specifications mentioned in this publication are subject to change without notice. This publication supersedes and replaces all information previously supplied. SGS-THOMSON Microelectronics products are not authorized for use as critical components in life support devices or systems without express written approval of SGS-THOMSON Microelectronics. ORDER CODE : © 1997 SGS-THOMSON Microelectronics – Printed in Italy – All Rights Reserved SGS-THOM SON Microelectronics GROUP OF COMPANIES Australia - Brazil - Canada - China - France - Germany - Italy - Japan - Korea - Malaysia - Malta - Morocco The Netherlands - Singapore - Spain - Sweden - Switzerland - Taiwan - Thailand - United Kingdom - U.S.A. 5/5 SO8.TBL PM-SO8.EPS