P-NUCLEO-IHM002

P-NUCLEO-IHM001 P-NUCLEO-IHM002 STM32 Nucleo packs FOC and 6-step motor control platform for three-phase, low-voltage and low-current motor Data brief Features • X-NUCLEO-IHM07M1: – Three-phase driver board for BLDC/PMSM motors based on L6230 – Nominal operating voltage range from 8 V to 48 V DC – 2.8 A output peak current (1.4 A RMS) – Non-dissipative overcurrent detection and protection – Full compatible with ST 6-step or ST-FOC-control algorithm – Full support for sensorless and sensor mode – 3-Shunt and 1-Shunt configurable jumpers for motor current sensing – Hall encoder motor sensor connector and circuit – Potentiometer available for speed regulation – Compatible with STM32 Nucleo boards – Equipped with ST morpho connectors • NUCLEO-F302R8: – STM32F302R8 32-bit Microcontroller based on ARM® Cortex®-M4 core (72 MHz max) with 64-Kbyte Flash memory and 16Kbyte SRAM – Two types of extension resources: Arduino™ UNO Revision 3 connectivity and ST morpho extension pin headers for full access to all STM32 I/Os – Mbed-enabled (http://mbed.org) – On-board ST-LINK/V2-1 debugger/programmer with SWD connector: selection-mode switch to use the kit as a standalone ST-LINK/V2-1 – Two push-buttons: USER and RESET • Three-phase motor: – Bull-Running model BR2804-1700 kV – Nominal voltage 11.1 V DC (battery up to 3 S) July 2016 1. Pictures not contractual. – Maximum DC current: 5 A – Seven pole pairs • DC power supply: – Nominal output voltage: 12 V DC – Maximum output current: 2 A – Nominal input voltage: 100-240 V AC – Nominal frequency: 50/60 Hz DocID028298 Rev 2 For further information contact your local STMicroelectronics sales office. 1/6 www.st.com Description 1 P-NUCLEO-IHM001 P-NUCLEO-IHM002 Description The STM32 Nucleo pack P-NUCLEO-IHM001 is a kit composed of: the X-NUCLEO-IHM07M1 board, the NUCLEO-F302R8 board and the motor (refer to the first figure on the cover page). The STM32 Nucleo pack P-NUCLEO-IHM002 is a kit composed of: the X-NUCLEO-IHM07M1 board, the NUCLEO-F302R8 board, the motor and the DC power supply (refer to both figures on the cover page). This platform provides a motor control solution for three-phase, low-voltage and low-current DC brushless motor. It is based on the L6230 driver (belonging to STSPIN family) and on the STM32F302R8 MCU. The L6230 driver is a DMOS fully integrated device for three-phase brushless PMSM motor, with integrated overcurrent and thermal protection. The STM32F302R8 is a 32-bit microcontroller based on a high-performance ARM® Cortex®-M4 32-bit RISC core, with floating point unit (FPU), operating at a frequency of up to 72 MHz and embedding an advanced analog peripheral set. The X-NUCLEO-IHM07M1 board is fully configurable and ready to support different closed loop control, FOC or 6-step, based on sensorless or sensor mode. It is compatible with three shunts or single shunt for current sense measuring. The NUCLEO-F302R8 board provides an affordable and flexible way for users to try out new concepts and to build prototypes with STM32 MCU. It does not require any separate probe as it integrates the ST-LINK/V2-1 debugger and programmer. Only for the P-NUCLEO-IHM002 pack the included power supply unit provides the appropriate power. 2 System architecture of the STM32 Nucleo packs The P-NUCLEO-IHM001 pack is composed of three main blocks (see Figure 1): • Control block: NUCLEO-F302R8 MCU board • Power block: X-NUCLEO-IHM07M1 • PMSM motor: Bull-Running BR2804-1700 kV The P-NUCLEO-IHM002 pack is composed of four main blocks (see Figure 2): 2/6 • Control block: NUCLEO-F302R8 MCU board • Power block: X-NUCLEO-IHM07M1 • PMSM motor: Bull-Running BR2804-1700 kV • Power supply unit (12 V, 2 A) DocID028298 Rev 2 P-NUCLEO-IHM001 P-NUCLEO-IHM002 System architecture of the STM32 Nucleo packs Figure 1. P-NUCLEO-IHM001 pack main blocks Figure 2. P-NUCLEO-IHM002 pack main blocks 3RZHU6XSSO\8QLW DocID028298 Rev 2 3/6 6 Ordering information 3 P-NUCLEO-IHM001 P-NUCLEO-IHM002 Ordering information Table 1. Ordering information Order code 4/6 Board P-NUCLEO-IHM001 X-NUCLEO-IHM07M1, NUCLEO-F302R8 P-NUCLEO-IHM002 X-NUCLEO-IHM07M1, NUCLEO-F302R8 DocID028298 Rev 2 DC Power Supply Not provided Provided (12 V, 2 A) P-NUCLEO-IHM001 P-NUCLEO-IHM002 4 Revision history Revision history Table 2. Document revision history Date Revision Changes 09-Sep-2015 1 Initial release. 22-Jul-2016 2 Updated Features and Section 2: System architecture of the STM32 Nucleo packs to introduce the Nucleo pack with the power supply unit. DocID028298 Rev 2 5/6 6 P-NUCLEO-IHM001 P-NUCLEO-IHM002 IMPORTANT NOTICE – PLEASE READ CAREFULLY STMicroelectronics NV and its subsidiaries (“ST”) reserve the right to make changes, corrections, enhancements, modifications, and improvements to ST products and/or to this document at any time without notice. Purchasers should obtain the latest relevant information on ST products before placing orders. ST products are sold pursuant to ST’s terms and conditions of sale in place at the time of order acknowledgement. Purchasers are solely responsible for the choice, selection, and use of ST products and ST assumes no liability for application assistance or the design of Purchasers’ products. No license, express or implied, to any intellectual property right is granted by ST herein. Resale of ST products with provisions different from the information set forth herein shall void any warranty granted by ST for such product. ST and the ST logo are trademarks of ST. All other product or service names are the property of their respective owners. Information in this document supersedes and replaces information previously supplied in any prior versions of this document. © 2016 STMicroelectronics – All rights reserved 6/6 DocID028298 Rev 2