PB137

PB137 POSITIVE VOLTAGE REGULATOR FOR BATTERY CHARGER s s s s s REVERSE LEAKAGE CURRENT LESS THAN 10 µA THREE TERMINAL FIXED VERSION (13.7V) OUTPUT CURRENT IN EXCESS OF 1.5A AVAILABLE IN ± 1% (AC) SELECTION AT 25°C TYPICAL DROPOUT VOLTAGE 2V TEMPERATURE RANGE 0°C TO 150°C DESCRIPTION The PB137 is a positive voltage regulator able to provide 1.5A, at VO = 13.7V and is intended as a charger for lead acid battery. The main feature is a reverse leakage current (Max 10µA at TJ = 0 to 40°C VI = floating and VO = 13.7V). It is available in TO-220 and it employs internal current limiting, thermal shut-down and safe area protection, making it essentially indestructible. If adequate heat-sinking is provided, they can deliver over 1A output current. TO-220 SCHEMATIC DIAGRAM June 2003 1/8 PB137 ABSOLUTE MAXIMUM RATINGS Symbol VI IO Ptot Tstg Top DC Input Voltage Output Current Power Dissipation Storage Temperature Range Operating Junction Temperature Range Parameter² Value 40 Internally Limited Internally Limited -65 to 150 0 to 150 Unit V mA mW °C °C Absolute Maximum Ratings are those values beyond which damage to the device may occur. Functional operation under these condition is not implied. THERMAL DATA Symbol Rthj-case Rthj-amb Parameter Thermal Resistance Junction-case Thermal Resistance Junction-ambient TO-220 3 50 Unit °C/W °C/W CONNECTION DIAGRAM (top view) ORDERING CODES TYPE PB137ACV OUTPUT VOLTAGE 1.5 V APPLICATION CIRCUIT 2/8 PB137 ELECTRICAL CHARACTERISTICS OF PB137 (refer to the test circuits, VI = 18V, IO = 500mA, TJ = 0 to 150°C, CO = 10µF unless otherwise specified) Symbol VO ∆VO ∆VO Id ∆Id ∆ Id Vd Isc eN SVR IREV S Parameter Output Voltage Line Regulation Load Regulation Quiescent Current Delta Quiescent Current vs Line Delta Quiescent Current vs Load Dropout Voltage Short Circuit Current Output Noise Voltage Supply Voltage Rejection Reverse Leakage Current Long Term Stability TJ = 25°C VI = 16 to 28.7 V, IO = 5 to 1500 mA, TJ = 25°C VI = 16 to 28.7 V IO = 5 to 1000 mA IO =1 A VI - VO = 5V B =10Hz to 10KHz, f = 120 Hz, TJ = 25°C TJ = 25°C TJ = 25°C TJ = 25°C 2.1 2.2 300 58 0.1 10 0.5 TJ = 25°C TJ = 25°C Test Conditions Min. 13.56 13.43 Typ. 13.7 13.7 60 65 4 Max. 13.84 13.97 150 100 8 4 1.2 2.6 Unit V mV mV mA mA mA V A µVrms dB µA % VO = 13.7 V, VI = floating TJ = 0 to 40°C TJ = 125°C 1000Hrs 3/8 PB137 TYPICAL PERFORMANCE CHARACTERISTICS (TJ = 25°C) Figure 1 : Output Voltage vs Temperature Figure 4 : Load Regulation vs Temperature Figure 2 : Output Voltage vs Input Voltage Figure 5 : Line Regulation vs Temperature Figure 3 : Output Voltage vs Output Current Figure 6 : Dropout Voltage vs Temperature 4/8 PB137 Figure 7 : Dropout Voltage vs Output Current Figure 10 : Reverse Leakage Current vs Temperature Figure 8 : Short Circuit Current vs Dropout Voltage Figure 11 : Quiescent Current vs Temperature Figure 9 : Short Circuit Current vs Temperature Figure 12 : Quiescent Current vs Output Current 5/8 PB137 Figure 13 : Quiescent Current vs Input Voltage Figure 16 : Supply Voltage Rejection vs Temperature Figure 14 : Thermal Protection Figure 17 : Line Transient Response VI = 17 to 28.4V, I O = 0.5A, CO = 10µF Figure 15 : Supply Voltage Rejection vs Output Current Figure 18 : Load Transient Response VI = 18V, I O = 5 to 1.5A, CI = 1µF, CO=10µF 6/8 PB137 TO-220 MECHANICAL DATA DIM. A C D D1 E F F1 F2 G G1 H2 L2 L4 L5 L6 L7 L9 DIA. 13.0 2.65 15.25 6.2 3.5 3.75 0.49 0.61 1.14 1.14 4.95 2.4 10.0 16.4 14.0 2.95 15.75 6.6 3.93 3.85 0.511 0.104 0.600 0.244 0.137 0.147 mm. MIN. 4.40 1.23 2.40 1.27 0.70 0.88 1.70 1.70 5.15 2.7 10.40 0.019 0.024 0.044 0.044 0.194 0.094 0.393 0.645 0.551 0.116 0.620 0.260 0.154 0.151 TYP MAX. 4.60 1.32 2.72 MIN. 0.173 0.048 0.094 0.050 0.027 0.034 0.067 0.067 0.203 0.106 0.409 inch TYP. MAX. 0.181 0.051 0.107 P011C 7/8 PB137 Information furnished is believed to be accurate and reliable. However, STMicroelectronics assumes no responsibility for the consequences of use of such information nor for any infringement of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of STMicroelectronics. Specifications mentioned in this publication are subject to change without notice. This publication supersedes and replaces all information previously supplied. STMicroelectronics products are not authorized for use as critical components in life support devices or systems without express written approval of STMicroelectronics. © The ST logo is a registered trademark of STMicroelectronics © 2003 STMicroelectronics - Printed in Italy - All Rights Reserved STMicroelectronics GROUP OF COMPANIES Australia - Brazil - Canada - China - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan - Malaysia - Malta - Morocco Singapore - Spain - Sweden - Switzerland - United Kingdom - United States. © http://www.st.com 8/8