STD22NM20NT4

STD22NM20N N-CHANNEL 200V - 0.088Ω - 22A DPAK ULTRA LOW GATE CHARGE MDmesh™ II MOSFET Table 1: General Features TYPE STD22NM20N ■ ■ ■ ■ ■ Figure 1: Package VDSS RDS(on) ID 200 V < 0.105 Ω 22 A WORLDWIDE LOWEST GATE CHARGE TYPICAL RDS(on) = 0.088 Ω HIGH dv/dt and AVALANCHE CAPABILITIES LOW INPUT CAPACITANCE LOW GATE RESISTANCE DESCRIPTION This 200V MOSFET with a new advanced layout brings all unique advantages of MDmesh technology to lower voltages. The device exhibits worldwide lowest gate charge for any given onresistance. Its use is therefore ideal as primary switch in isolated DC-DC converters for Telecom and Computer applications. Used in combination with secondary-side low-voltage STripFET™ products, it contributes to reducting losses and boosting effeciency. 3 1 DPAK c u d e t le ) s t( o r P Figure 2: Internal Schematic Diagram o s b O - APPLICATIONS The MDmesh™ family is very suitable for increasing power density allowing system miniaturization and higher efficiencies ) s ( ct u d o r P e t e l o s b O Table 2: Order Codes SALES TYPE MARKING PACKAGE PACKAGING STD22NM20NT4 D22NM20N DPAK TAPE & REEL Rev. 5 November 2005 1/10 STD22NM20N Table 3: Absolute Maximum ratings Symbol VDS VDGR VGS ID Parameter Value Unit 200 V Drain-gate Voltage (RGS = 20 kΩ) 200 V Gate- source Voltage ± 20 V Drain Current (continuous) at TC = 25° Drain Current (continuous) at TC = 100° 22 13.7 A A Drain-source Voltage (VGS = 0) IDM (*) Drain Current (pulsed) 88 A PTOT Total Dissipation at TC = 25°C 100 W Derating Factor 0.8 W/°C 14 V/ns 150 -65 to 150 °C °C dv/dt (2) Tj Tstg Peak Diode Recovery voltage slope Storage Temperature Max Operating Junction Temperature (*) ISD ≤ 22A, di/dt ≤ 400A/µs, VDD = 80% V(BR)DSS Table 4: Thermal Data Rthj-case Thermal Resistance Junction-case Max 1.25 Rthj-amb Thermal Resistance Junction-ambient Max 100 Thermal Resistance Junction-pcb (*) Maximum Lead Temperature For Soldering Purpose 43 275 Rthj-ambTl r P e t le (*) When mounted on 1 inch² FR-4 board, 2 oz Cu, t ≤ 10 sec Table 5: Avalanche Characteristics Symbol IAS Avalanche Current, Repetitive or Not-Repetitive (pulse width limited by Tj max) EAS Single Pulse Avalanche Energy (starting Tj = 25 °C, ID = 22 A, VDD = 50 V) ) s ( ct u d o r P e t e l o s b O 2/10 so Parameter b O - od uc ) s t( °C/W °C/W °C/W °C Max Value Unit 22 A 380 mJ STD22NM20N ELECTRICAL CHARACTERISTICS (TCASE =25°C UNLESS OTHERWISE SPECIFIED) Table 6: On/Off Symbol V(BR)DSS Parameter Test Conditions Min. Typ. Max. 200 Unit Drain-source Breakdown Voltage ID = 1mA, VGS = 0 IDSS Zero Gate Voltage Drain Current (VGS = 0) VDS = Max Rating VDS = Max Rating, TC = 125 °C 1 10 µA µA IGSS Gate-body Leakage Current (VDS = 0) VGS = ± 20V 100 nA VGS(th) Gate Threshold Voltage VDS = VGS, ID = 250 µA 4.2 5 V RDS(on) Static Drain-source On Resistance VGS = 10V, ID = 11 A 0.088 0.105 Ω Typ. Max. Unit 3.5 V Table 7: Dynamic Symbol gfs (2) Parameter Test Conditions Min. Forward Transconductance VDS = 15 V, ID=11 A Input Capacitance Output Capacitance Reverse Transfer Capacitance VDS = 25V, f = 1 MHz, VGS = 0 Equivalent Output Capacitiance VGS = 0 V, VDS = 0 V to 400 V Gate Input Resistance f= 1MHz Gate DC Bias = 0 Test Sgnal Level = 20 mV Open Drain td(on) tr tr(Voff) tf Turn-on Delay Time Rise Time Turn-off Delay Time Fall Time VDD = 100 V, ID = 11 A RG = 4.7Ω VGS = 10 V (see Figure 15) Qg Qgs Qgd Total Gate Charge Gate-Source Charge Gate-Drain Charge VDD = 100 V, ID = 20 A, VGS = 10 V (see Figure 19) Ciss Coss Crss Coss eq. (**) RG 8 800 330 130 S c u d ro P e let so ) s ( ct ) s t( b O - pF pF pF 225 pF 5 Ω 40 15 40 11 ns ns ns ns 32 6 25 50 nC nC nC (**) Coss eq. is defined as a constant equivalent capacitance giving the same charging time as Coss when VDS increases from 0 to 80% VDSS u d o Table 8: Source Drain Diode r P e Symbol Parameter Test Conditions Min. Typ. Max. Unit 22 88 A A ISD ISDM (1) Source-drain Current Source-drain Current (pulsed) VSD (2) Forward On Voltage ISD = 20 A, VGS = 0 Reverse Recovery Time Reverse Recovery Charge Reverse Recovery Current ISD = 20 A, di/dt = 100 A/µs VDD = 100V, Tj = 25°C (see test circuit, Figure 17) 160 960 12.8 ns µC A Reverse Recovery Time Reverse Recovery Charge Reverse Recovery Current ISD = 20 A, di/dt = 100 A/µs VDD = 100V, Tj = 150°C (see test circuit, Figure 17) 225 1642 15 ns µC A t e l o trr Qrr s b O IRRM trr Qrr IRRM 1.3 V (1) Pulse width limited by safe operating area. (2) Pulsed: Pulse duration = 300 µs, duty cycle 1.5 % 3/10 STD22NM20N Figure 3: Safe Operating Area Figure 6: Thermal Impedance Figure 4: Output Characteristics Figure 7: Transfer Characteristics c u d e t le Figure 5: Transconductance u d o ) s ( ct r P e t e l o s b O 4/10 ) s t( o r P o s b O - Figure 8: Static Drain-source On Resistance STD22NM20N Figure 9: Gate Charge vs Gate-source Voltage Figure 12: Capacitance Variations Figure 10: Normalized Gate Thereshold Voltage vs Temperature Figure 13: Normalized On Resistance vs Temperature c u d e t le ) s ( ct o r P o s b O - Figure 11: Source-Drain Diode Forward Characteristics u d o ) s t( Figure 14: Normalized BVdss vs Temperature r P e t e l o s b O 5/10 STD22NM20N Figure 15: Unclamped Inductive Load Test Circuit Figure 18: Unclamped Inductive Wafeform Figure 16: Switching Times Test Circuit For Resistive Load Figure 19: Gate Charge Test Circuit c u d e t le ) s ( ct u d o r P e o s b O - Figure 17: Test Circuit For Inductive Load Switching and Diode Recovery Times t e l o s b O 6/10 o r P ) s t( STD22NM20N TO-252 (DPAK) MECHANICAL DATA mm DIM. MIN. TYP. inch MAX. MIN. A 2.20 2.40 0.087 TYP. 0.094 MAX. A1 0.90 1.10 0.035 0.043 A2 0.03 0.23 0.001 0.009 B 0.64 0.90 0.025 0.035 B2 5.20 5.40 0.204 0.213 C 0.45 0.60 0.018 0.024 C2 0.48 0.60 0.019 0.024 D 6.00 6.20 0.236 0.244 E 6.40 6.60 0.252 G 4.40 4.60 0.173 H 9.35 10.10 0.368 L2 0.8 e t le L4 0.60 1.00 0.024 V2 0o 8o 0o ) s ( ct o s b O - Pr od uc ) s t( 0.260 0.181 0.398 0.031 0.039 0o u d o r P e t e l o s b O P032P_B 7/10 STD22NM20N DPAK FOOTPRINT All dimensions are in millimeters TAPE AND REEL SHIPMENT ) s t( REEL MECHANICAL DATA DIM. A B inch MAX. TAPE MECHANICAL DATA mm DIM. MIN. MIN. MAX. A0 6.8 7 10.4 10.6 0.409 0.417 12.1 0.476 1.6 0.059 0.063 1.85 0.065 0.073 1.5 1.5 t e l o 1.65 P0 P1 P2 1.9 E F K0 0.267 0.275 u d o r P e D D1 8/10 MAX. B0 B1 s b O ) s ( ct inch 0.059 7.4 7.6 0.291 0.299 2.55 2.75 0.100 0.108 3.9 4.1 0.153 0.161 7.9 8.1 0.311 0.319 2.1 0.075 0.082 R 40 W 15.7 1.574 16.3 0.618 0.641 b O - C 12.8 D 20.2 G 16.4 N 50 T MIN. ro 330 1.5 P e let so c u d mm MIN. MAX. 12.992 0.059 13.2 0.504 0.520 18.4 0.645 0.724 0.795 1.968 22.4 0.881 BASE QTY BULK QTY 2500 2500 STD22NM20N Table 9: Revision History Date Revision 31-May-2004 15-Mar-2005 09-May-2005 09-Jun-2005 04-Nov-2005 1 2 3 4 5 Description of Changes First Release. Update version. Complete version. New update Corrected value on Table 8 c u d e t le ) s ( ct ) s t( o r P o s b O - u d o r P e t e l o s b O 9/10 STD22NM20N c u d e t le ) s ( ct ) s t( o r P o s b O - u d o r P e Information furnished is believed to be accurate and reliable. However, STMicroelectronics assumes no responsibility for the consequences of use of such information nor for any infringement of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of STMicroelectronics. Specifications mentioned in this publication are subject to change without notice. This publication supersedes and replaces all information previously supplied. STMicroelectronics products are not authorized for use as critical components in life support devices or systems without express written approval of STMicroelectronics. t e l o s b O The ST logo is a registered trademark of STMicroelectronics All other names are the property of their respective owners © 2005 STMicroelectronics - All Rights Reserved STMicroelectronics group of companies Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan Malaysia - Malta - Morocco - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America www.st.com 10/10