STEVAL-IHM010V1

STEVAL-IHM010V1 ST7MCx control board with motor control connector Data brief Features ■ 5 V power supply connector ■ 34-pin dedicated motor control connector ■ Serial communication interface connector ■ Programming and debug support via 10-pin ICC connector ■ On-board 2 Kb (256 byte) serial memory ■ 4 potentiometers for runtime settings ■ Start / stop button ■ Reset button ■ Debug pins available ■ RoHS compliant ) s ( ct u d o r P e t e l o Description ) (s s b O STEVAL-IHM010V1 The STEVAL-IHM010V1 demonstration board is a complete development platform for STMicroelectronics' 8-bit ST7MCx microcontroller with 16 KB internal Flash memory. Based on a cost-effective, flexible and open design, the board helps demonstrate the ST7MCx's capabilities and enables rapid evaluation of the microcontroller's motor-control peripherals. t c u d o r P e t e l o The STEVAL-IHM010V1 has a motor-control connector and hardware features for developing motor control applications based on ST7MCx peripherals, including the motor-control peripheral (MTC) and serial communication interface (SCI). In addition, it uses an in-circuit communication (ICC) standard interface to connect to a host PC via in-circuit debuggers/programmers such as the inDART-STX board from Softec. s b O November 2010 Doc ID 18276 Rev 1 For further information contact your local STMicroelectronics sales office. 1/4 www.st.com 4 2/4 #()0 3%,%#4 Doc ID 18276 Rev 1  1 633 7 '2%%.,%$ $ 2%$,%$ $   3 $!4! #+ (/,$ 6##     # N& (%!$%2 3$)     *0 #43 34&-#34                        2$) 4$/ s b O 2 + 2 +   0 2"# #43 -##&) -#)! -#)" -#)# (6"US (EATSINKTEMPERATURE ) (s -#/(3 -#/(3 -#/(3 -#/(3 -#/(3 -#/(3 -#%3 600 /3# 0%)#!0?" /3# 0%)#!0?" 6SS? 0%/#-0?" 6DD? 0%/(3 /#-0?" 0!07-!). 0$(3 4$/ 0!!24)#!). 0$(3 2$) 0"-#62%& 0$!).)##$!4! 0$%84#,+?!!).)###,+ 0"-#)! 0"-#)" 0$)#!0?!!). 0$)#!0?!-#:%-!). 0"-#)# 0"-)3/ 0$(3 /#-0?!-#07-6-#$%0"-/3)!). 0$/#-0?!!). 0"(3 3#+ 2%3%4 0"(3 33!). 6$$? 0#/!0 633? 0#/!. 633! /!:-##&)!). 6!2%& 0#-#07-7!). 0#-##2%& *  0&#?07"UTTON 0&#?39.# 6A2EF 0 t e l o r P e *  6ARIABLE  0 #()0 3%,%#4 $EBUGPINS -#$%- -#:%- # N&6 2 +  *  * 2 + K 0 N& #   + # N& N& # 6 !DJUSTABLE   2 + 0   # N& # N& 0 "UTTON 2ESET 37 K  N& # 2 + K    # U& 2 2 37 0USHBUTTON 0 0 0 0 6A2EF STEVAL-IHM010V1 circuit schematic - -.403 5 ,%$#42                       2 +  Figure 1.  # P& N& # 6 -#%3 # N& 5 2 +  Schematic diagram  8  -#)#           *  )##CONNECTOR(%MALETYPE 1 # P& 2 - #/.4 2 + t c u #34#3 -8 #/.   07-! ( 07-! , 07-" ( 07-" , 07-# ( 07-# , 2"#  0&#?39.# 0&#?07-#)! -#)" -##&) -#%3 s b O                  d o r   * * P e t e l o (EATSINKTEMPERATURE (6"US                  Schematic diagram STEVAL-IHM010V1 ) s ( ct u d o !-V STEVAL-IHM010V1 2 Revision history Revision history Table 1. Document revision history Date Revision 24-Nov-2010 1 Changes Initial release. ) s ( ct u d o r P e t e l o ) (s s b O t c u d o r P e t e l o s b O Doc ID 18276 Rev 1 3/4 STEVAL-IHM010V1 ) s ( ct Please Read Carefully: u d o Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any time, without notice. r P e All ST products are sold pursuant to ST’s terms and conditions of sale. Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no liability whatsoever relating to the choice, selection or use of the ST products and services described herein. t e l o No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such third party products or services or any intellectual property contained therein. ) (s s b O UNLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT. t c u UNLESS EXPRESSLY APPROVED IN WRITING BY AN AUTHORIZED ST REPRESENTATIVE, ST PRODUCTS ARE NOT RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY, DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER’S OWN RISK. d o r P e t e l o Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, any liability of ST. s b O ST and the ST logo are trademarks or registered trademarks of ST in various countries. Information in this document supersedes and replaces all information previously supplied. The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners. © 2010 STMicroelectronics - All rights reserved STMicroelectronics group of companies Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan Malaysia - Malta - Morocco - Philippines - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America www.st.com 4/4 Doc ID 18276 Rev 1