TS834_01

TS834 MICROPOWER VOLTAGE SUPERVISOR RESET ACTIVE LOW OR HIGH INTEGRATED TIMER s ULTRA LOW POWER CONSUMPTION : 12µA max. @ VCC = 5V s BOTH ACTIVE HIGH AND ACTIVE LOW OUTPUTS s RESET TIMER WITH DISABLE FUNCTION s PRECISION RESET THRESHOLD (guaranteed over Temperature) s 4.33V typ. THRESHOLD VOLTAGE s GUARANTEED RESET OPERATION DOWN TO 1.5V s OPEN DRAIN OUTPUT WITH s Vol = 450mV typ.@ Iol = 8mA & VCC = 4V s FAST RESPONSE TIME : 20µs FOR A 10mV OVERDRIVE D SO8 (Plastic Micropackage) s 100mV INTERNAL HYSTERESIS P TSSOP8 (Thin Shrink Small Outline Package) DESCRIPTION The TS834 is a voltage supervisor providing two different outputs (one active low and one active high) with an integrated timer that can be disabled. It incorporates a high stability bandgap voltage reference and a comparator with open drain output. The threshold voltage is set at 4.33V by internal thermally matched resistors. The comparator exhibits a 20µs response (with 10mV overdrive). An internal hysteresis of 100mV increases the comparator noise margin and prevents false reset operation. ORDER CODE Package Part Number TS834-5I Temperature Range D -40, +85°C • P • D = Small Outline Package (SO) - also available in Tape & Reel (DT) P = T hin Shrink Small Outline Package (TSSOP) - only available in Tape & Reel (PT) PIN CONNECTIONS (top view) Reset Low 1 8 Reset High NC Vcc 2 7 APPLICATION s s s s s Computers Microcontrollers Microprocessor systems Intelligent instruments Power failure detection NC 3 6 NC Gnd 4 5 Timer Control* * This pin must be connected to Vcc or Gnd January 2001 1/7 TS834 ABSOLUTE MAXIMUM RATINGS Symbol VCC Vout Iout Pd Toper Tstg Supply Voltage Output Current Power Dissipation 2) 1) Parameter Value 7 -0.3 to Vcc + 0.3 20 Unit V V mA mW °C °C Output Voltage - See note 1 SO8 TSSOP8 700 625 -40 to +85 -65 to +150 Operating Free Air Temperature Range Storage Temperature 1. All voltages values, except differential voltage are with respect to network ground terminal. 2. T j = 150°C, Tamb = 25oC with Rthja = 175oC/W for SO8 package Rthja = 200oC/W for TSSOP8 package OPERATING CONDITIONS Symbol VCC Toper Supply Voltage Operating Free Air Temperature Range Parameter Value 1.5 to 5.5 -40 to +85 Unit V °C TS834-5 ELECTRICAL CHARACTERISTICS Tamb = 25°C (unless otherwise specified) Symbol Vthi Parameter Threshold Voltage - VCC Increasing Tamb = 25°C -40°C ≤ Tamb ≤ +85°C Threshold Voltage - VCC Decreasing Tamb = 25°C -40°C ≤ Tamb ≤ +85°C Hysteresis Voltage Current Consumption Low Level Output Voltage (OUTPUT 1) Low Level Output Voltage (OUTPUT 2) Low Level Output Voltage (OUTPUT 1) Low Level Output Voltage (OUTPUT 2) VCC = 5V VCC = 4V, IOL = 8mA -40°C ≤ Tamb ≤ +85°C VCC = 5V, IOL = 8mA -40°C ≤ Tamb ≤ +85°C VCC = 5V -40°C ≤ Tamb ≤ +85°C VCC = 4V -40°C ≤ Tamb ≤ +85°C 450 450 2 2 Min. Typ. 4.33 4.10 4.23 4.10 50 100 4.46 200 12 800 1000 800 1000 40 1000 40 1000 mV µA mV mV nA nA µs ms 125 300 500 4.46 V Max. Unit V Vthd Vhys ICC VOL1 VOL2 IOH1 IOH2 tphl trst Response Time High to Low RL = 10kΩ, CL = 15pF, VCC = Vthd -10mV Reset Pulse width (Timer enabled) -40°C ≤ Tamb ≤ +85°C 20 2/7 TS834 TIMING DIAGRAMS All the timung diagrams are given with outputs loaded by 10 kΩ resistors to VCC Vcc+ Input Vcc Timer Control RESET OUTPUT Timer Vcc RESET OUTPUT Timer enable : timer control to Vcc Timer disable : timer control to Gnd Vref GND Active Low Reset, Timer Enabled Active High Reset, Timer Enabled Active Low Reset, Timer Disabled Active High Reset, Timer Disabled 3/7 TS834 Voltage Threshold (Vthi) vs Temperature Vol vs Temperature Current Consumption vs Temperature Output Voltage vs Input Timer Period (trst) vs Temperature Output Voltage vs Input 4/7 TS834 Vol vs Isink Reset High After Vcc Tansition (timer disabled) Schematic to Measure Vol vs Isink Reset Low After Vcc Tansition (timer disabled) Vcc Vcc=4V TS834 Reset Vin Gnd Reset Isink Reset =low Vcc=5V Vcc TS834 Reset Vin Gnd Reset Isink Reset=low 5/7 TS834 PACKAGE MECHANICAL DATA 8 PINS - PLASTIC MICROPACKAGE (SO) Millimeters Dim. Min. A a1 a2 a3 b b1 C c1 D E e e3 F L M S 0.1 0.65 0.35 0.19 0.25 4.8 5.8 1.27 3.81 3.8 0.4 4.0 1.27 0.6 8° (max.) 0.150 0.016 Typ. Max. 1.75 0.25 1.65 0.85 0.48 0.25 0.5 45° (typ.) 5.0 6.2 0.189 0.228 Min. 0.004 0.026 0.014 0.007 0.010 Inches Typ. Max. 0.069 0.010 0.065 0.033 0.019 0.010 0.020 0.197 0.244 0.050 0.150 0.157 0.050 0.024 6/7 TS834 PACKAGE MECHANICAL DATA 8 PINS - THIN SHRINK SMALL OUTLINE PACKAGE k c 0.25mm .010 inch GAGE PLANE L1 L L L1 E1 SEATING PLANE A A2 A1 5 D b 8 8 C E 4 e 5 PIN 1 IDENTIFICATION Millimeters Dim. Min. A A1 A2 b c D E E1 e k l L L1 0.05 0.80 0.19 0.09 2.90 4.30 0° 0.50 0.45 Typ. Max. 1.20 0.15 1.05 0.30 0.20 3.10 4.50 8° 0.75 0.75 Min. 0.01 0.031 0.007 0.003 0.114 0.169 0° 0.09 0.018 1 4 1 Inches Typ. Max. 0.05 0.006 0.041 0.15 0.012 0.122 0.177 8° 0.030 0.030 1.00 0.039 3.00 6.40 4.40 0.65 0.60 0.600 1.000 0.118 0.252 0.173 0.025 0.0236 0.024 0.039 Information furnished is believed to be accurate and reliable. However, STMicroelectronics assumes no responsibility for the consequences of use of such information nor for any infringement of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of STMicroelectronics. Specifications mentioned in this publication are subject to change without notice. This publication supersedes and replaces all information previously supplied. STMicroelectronics products are not authorized for use as critical components in life support devices or systems without express written approval of STMicroelectronics. © The ST logo is a registered trademark of STMicroelectronics © 2001 STMicroelectronics - Printed in Italy - All Rights Reserved STMicroelectronics GROUP OF COMPANIES Australia - Brazil - China - Finland - France - Germany - Hong Kong - India - Italy - Japan - Malaysia - Malta - Morocco Singapore - Spain - Sweden - Switzerland - United Kingdom © http://www.st.com 7/7