LM393TS8-XX-TR70

Voltage Comparator LM393 Voltage Comparator General Description • The TCI LM393 consist of two independent voltage comparator, designed specifically to operate from a single power supply over a wide voltage range. • The LM393 is available in standard DIP-8, SOP-8 and TSSOP-8 packages. . DIP-8 SOP-8 TSSOP-8 Features • Single or dual supply operation • Wide operating supply range (VCC=2V ~ 36V or ±1 ~ ±18V) • • • • • Applications • • • • • Battery Charger Cordless Telephone Switching Power Supply PC Motherboard Communication Equipment Input common-mode voltage includes ground Low supply current drain ICC=0.8mA (Typical) Low input bias current IBIAS=25nA (Typical) Output compatible with TTL, DTL, and CMOS logic system RoHS Compliance Ordering Information TAITRON COMPONENTS INCORPORATED www.taitroncomponents.com Tel: Fax: (800)-TAITRON (800)-824-8766 (800)-TAITFAX (800)-824-8329 (661)-257-6060 (661)-257-6415 Rev. A/DX 2007-06-04 Page 1 of 11 Voltage Comparator LM393 Pin Configuration Block Diagram Rev. A/DX 2007-06-04 www.taitroncomponents.com Page 2 of 11 Voltage Comparator LM393 Absolute Maximum Ratings Symbol VCC VI(DIFF) VIN PD Description Supply Voltage Differential Input Voltage Input Voltage TSSOP-8 Power Dissipation SOP-8 DIP-8 TJ TOPR TSTG Operating Junction Temperature Operating Temperature Range Storage Temperature Range LM393 ±18 or 36 36 -0.3 ~ 36 570 660 780 150 -40 ~ 85 -65 ~ 150 °C °C °C mW Unit V V V Note: Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied. Electrical Characteristics (VCC=5.0V, TA=25ºC, all voltage referenced to GND unless otherwise specified) Symbol VI(OFF) VSAT VI(CM) GV ICC II(OFF) II(BIAS) IO(SINK) IO(LEAK) tR tR Description Input Offset Voltage Output Saturation Voltage Input Common Mode Voltage Large Signal Voltage Gain Power Supply Current Input Offset Current Input Bias Current Output Sink Current Output Leakage Current LM393 Min. Typ. Max. Unit mV mV V Conditions VCM=0V to VCC-1.5V VO(P)=1.4V,RS=0Ω VI(-)>1V, VI(+)=0V, ISINK=4mA VCC=30V 0 50 6 - 1.0 160 200 0.8 0.6 5 65 18 0.1 - 5.0 400 VCC -1.5 V/mV VCC=15V, RL≥15KΩ 2.5 RL=∞, VCC=30V mA 1.0 R L=∞ 50 nA 250 nA mA VI(-)>1V, VI(+)=0V, VO(P)