B32529C0562J189

Film Capacitor Metallized Polyester Film Capacitor (MKT) Series/Type: Ordering code: B32529 B32529C0562+289 Date: Version: 24-03-2014 2 Content of header bars 1 and 2 of data sheet will be automatically entered in headers and footers! Please fill in the table and then change the color to "white". This ensures that the table disappears (invisible) for the customer PDF. Don't change formatting when entering or pasting text in the table and don't add any cell or line in and to it! Identification/Classification 1 (header 1 + top left bar): Film Capacitor Identification/Classification 2 (header 2 + bottom left header bar): Metallized Polyester Film Capacitor (MKT) Ordering code: (top right header bar) B32529C0562+289 Series/Type: (top right header bar) B32529 Preliminary data (optional): (if necessary) Department: FILM EDC Date: 24-03-2014 Version: 2 Issued by Roberto Stoll Changes Unification of datasheets for K and J tolerances  EPCOS AG 2009. Reproduction, publication and dissemination of this publication, enclosures hereto and the information contained therein without EPCOS' prior express consent is prohibited Film Capacitor Metallized Polyester Film Capacitor (MKT) B32529C0562+289 B32529 Applications Blocking Coupling, decoupling Bypassing RFI for automotive Construction Dielectric: metallized polyethylene teraphthalate (polyester, PET) Stacked-film technology Plastic case (UL 94 V-0) Epoxy resin sealing Features High pulse strength High contact reliability RoHS compatible Delivery mode Ammo pack Dimensions Lead spacing (e): Width max. (w): Height max. (h): Length max. (l): Lead diam. (∅d1): 5.0 ± 0.4 mm 2.5 mm 6.5 mm 7.3 mm 0.5 ± 0.05 mm Terminals Parallel wire leads, tinned FILM EDC Please read Cautions and warnings and Important notes at the end of this document. 24-03-2014 Page 2 of 4 Film Capacitor Metallized Polyester Film Capacitor (MKT) B32529C0562+289 B32529 Electrical Characteristics Rated Capacitance C 5.6 nF Capacitance tolerance J = ±5% ; K = ±10% ; M = ±20% Rated DC voltage Urdc 63 Vdc Rated AC voltage Urac (50-60 Hz) 40 Vac Climatic category according to IEC 68-1 55/125/56 Lower category temperature Tmin -55 °C Upper category temperature Tmax +125 °C Voltage derating TA ≤ 85 °C: VC = VR 85 °C ≤ TA ≤ 125 °C : VC = (165 - TA) / 80 Pulse handling capability (dV/dt) 250 V/µs Pulse characteristic K0 30 000 V²/µs Loss factor (tan δ) @ 20°C, 65% r.h., 1 kHz ≤ 8 E-3 Loss factor (tan δ) @ 20°C, 65% r.h., 10 kHz ≤ 15 E-3 Loss factor (tan δ) @ 20°C, 65% r.h., 100 kHz ≤ 30 E-3 Isolation resistance Ris @ 20 °C, 100 V, relative humidity ≤ 65 %, 1min±5s > 3750 MΩ FILM EDC Please read Cautions and warnings and Important notes at the end of this document. 24-03-2014 Page 3 of 4 Important notes The following applies to all products named in this publication: 1. Some parts of this publication contain statements about the suitability of our products for certain areas of application. These statements are based on our knowledge of typical requirements that are often placed on our products in the areas of application concerned. We nevertheless expressly point out that such statements cannot be regarded as binding statements about the suitability of our products for a particular customer application. As a rule, EPCOS is either unfamiliar with individual customer applications or less familiar with them than the customers themselves. For these reasons, it is always ultimately incumbent on the customer to check and decide whether an EPCOS product with the properties described in the product specification is suitable for use in a particular customer application. 2. We also point out that in individual cases, a malfunction of electronic components or failure before the end of their usual service life cannot be completely ruled out in the current state of the art, even if they are operated as specified. In customer applications requiring a very high level of operational safety and especially in customer applications in which the malfunction or failure of an electronic component could endanger human life or health (e.g. in accident prevention or life-saving systems), it must therefore be ensured by means of suitable design of the customer application or other action taken by the customer (e.g. installation of protective circuitry or redundancy) that no injury or damage is sustained by third parties in the event of malfunction or failure of an electronic component. 3. The warnings, cautions and product-specific notes must be observed. 4. In order to satisfy certain technical requirements, some of the products described in this publication may contain substances subject to restrictions in certain jurisdictions (e.g. because they are classed as hazardous). Useful information on this will be found in our Material Data Sheets on the Internet (www.epcos.com/material). Should you have any more detailed questions, please contact our sales offices. 5. We constantly strive to improve our products. Consequently, the products described in this publication may change from time to time. The same is true of the corresponding product specifications. Please check therefore to what extent product descriptions and specifications contained in this publication are still applicable before or when you place an order. We also reserve the right to discontinue production and delivery of products. Consequently, we cannot guarantee that all products named in this publication will always be available. The aforementioned does not apply in the case of individual agreements deviating from the foregoing for customer-specific products. 6. Unless otherwise agreed in individual contracts, all orders are subject to the current version of the “General Terms of Delivery for Products and Services in the Electrical Industry” published by the German Electrical and Electronics Industry Association (ZVEI). 7. The trade names EPCOS, BAOKE, Alu-X, CeraDiode, CSMP, CSSP, CTVS, DSSP, MiniBlue, MiniCell, MKK, MLSC, MotorCap, PCC, PhaseCap, PhaseCube, PhaseMod, PhiCap, SIFERRIT, SIFI, SIKOREL, SilverCap, SIMDAD, SIMID, SineFormer, SIOV, SIP5D, SIP5K, ThermoFuse, WindCap are trademarks registered or pending in Europe and in other countries. Further information will be found on the Internet at www.epcos.com/trademarks. Page 4 of 4