Aluminum Electrolytic Capacitors
Capacitors with screw terminals
Series/Type:
Ordering code:
B43458
B43458S0608M001
Date:
Version:
July 14, 2009
1
EPCOS AG 2008. Reproduction, publication and dissemination of this publication, enclosures hereto and the information
contained therein without EPCOS' prior express consent is prohibited.
Aluminum Electrolytic Capacitors
B43458S0608M001
Capacitors with screw terminals
B43458
85 °C / 12000 h
• Extremely compact
• High ripple current
Preliminary part no.:
Development code:
Customer:
Insulated case base
B43458S0608M001
PA06922
Saft Power / China
Dimensions (mm) with insulating sleeve
d+0/-0.7
l±1
76.9
221.2
l1±1
227
l2 +0/-1
17
d1
M12
Terminal
M6
a+0.2/-0.4
d2 max
17.7
31.7
B43458S0608M001
Technical data
Rated capacitance
CR
100 Hz, 20 °C
6000 µF
Capacitance tolerance
±20%
Rated voltage
VR
315 V
Surge voltage
VS
362 V
Operating temperature range
–40 / +85 °C
lleak
5 min, 20 °C
Typical ESR
ESRtyp
100 Hz, 20 °C
18 m
Maximum ESR
ESRmax
100 Hz, 20 °C
26 m
Maximum impedance
Zmax
10 kHz, 20 °C
21 m
Rated ripple current
IAC,R
100 Hz, 85 °C
23 A
IAC,max
100 Hz, 40 °C
57 A
Maximum leakage current
Maximum ripple current
Voltage endurance test
6 mA
85 °C, VR
2000 h
After test:
|∆C/C| ≤ 10% of initial value
ESR ≤ 1.3 x initial spec. limit
Ileak ≤ initial spec. limit
Useful life
85 °C, VR, IAC,R
12000 h
55 °C, VR, 32 A300Hz
149000 h
After test:
|∆C/C| ≤ 20% of initial value
ESR ≤ 2 x initial spec. limit
Ileak ≤ initial spec. limit
Other specifications
IEC 60384-4, CECC 30301-803, Data Book 2007, RoHS-compatible
Cautions and warnings: see Data Book 2007 or www.epcos.com
KO A D&A
Please read Important notes
at the end of this document.
July 14, 2009
Page 2 of 3
Important notes
The following applies to all products named in this publication:
1. Some parts of this publication contain statements about the suitability of our products for
certain areas of application. These statements are based on our knowledge of typical
requirements that are often placed on our products in the areas of application concerned. We
nevertheless expressly point out that such statements cannot be regarded as binding
statements about the suitability of our products for a particular customer application. As a
rule, EPCOS is either unfamiliar with individual customer applications or less familiar with them
than the customers themselves. For these reasons, it is always ultimately incumbent on the
customer to check and decide whether an EPCOS product with the properties described in the
product specification is suitable for use in a particular customer application.
2. We also point out that in individual cases, a malfunction of electronic components or failure
before the end of their usual service life cannot be completely ruled out in the current state
of the art, even if they are operated as specified. In customer applications requiring a very high
level of operational safety and especially in customer applications in which the malfunction or
failure of an electronic component could endanger human life or health (e.g. in accident
prevention or life-saving systems), it must therefore be ensured by means of suitable design of the
customer application or other action taken by the customer (e.g. installation of protective circuitry
or redundancy) that no injury or damage is sustained by third parties in the event of malfunction or
failure of an electronic component.
3. The warnings, cautions and product-specific notes must be observed.
4. In order to satisfy certain technical requirements, some of the products described in this
publication may contain substances subject to restrictions in certain jurisdictions (e.g.
because they are classed as hazardous). Useful information on this will be found in our Material
Data Sheets on the Internet (www.epcos.com/material). Should you have any more detailed
questions, please contact our sales offices.
5. We constantly strive to improve our products. Consequently, the products described in this
publication may change from time to time. The same is true of the corresponding product
specifications. Please check therefore to what extent product descriptions and specifications
contained in this publication are still applicable before or when you place an order.
We also reserve the right to discontinue production and delivery of products. Consequently,
we cannot guarantee that all products named in this publication will always be available.
The aforementioned does not apply in the case of individual agreements deviating from the
foregoing for customer-specific products.
6. Unless otherwise agreed in individual contracts, all orders are subject to the current version of
the “General Terms of Delivery for Products and Services in the Electrical Industry”
published by the German Electrical and Electronics Industry Association (ZVEI).
7. The trade names EPCOS, BAOKE, Alu-X, CeraDiode, CSSP, CTVS, DSSP, MiniBlue, MKK,
MLSC, MotorCap, PCC, PhaseCap, PhaseMod, SIFERRIT, SIFI, SIKOREL, SilverCap, SIMDAD,
SIMID, SineFormer, SIOV, SIP5D, SIP5K, ThermoFuse, WindCap are trademarks registered or
pending in Europe and in other countries. Further information will be found on the Internet at
www.epcos.com/trademarks
Page 3 of 3
