T3AFG30

T3AFG30 / T3AFG60 Data Sheet Function/Arbitrary Waveform Generators Debug with Confidence 30 MHz – 60 MHz Teledyne Test Tools T3AFG30 and T3AFG60 range of function/arbitrary generators are a series of dual-channel waveform generators with specifications of up to 60 MHz maximum bandwidth, 150 MSa/s maximum sampling rate and 14-bit vertical resolution. The proprietary Arbitrary & Pulse techniques used in the T3AFG30 / T3AFG60 models helps to solve the weaknesses inherent in traditional DDS generators when generating arbitrary, square and pulse waveforms. With the above advantages the T3AFG30 and T3AFG60 generators can provide users with a variety of high fidelity and low jitter signals, which can meet the growing requirements of a wide range of complex applications. Tools for Improved Debugging ● ●Deep Memory – 16 kpts/Ch. ● ●Wide Range of Modulation Types – AM, DSB-AM, FM, PM, FSK,ASK, PWM, Sweep, Burst, and PSK. ● ●High Resolution – 14 bit resolution. ● ●Bandwidth Models of 30 MHz and 60 MHz. Generatecomplex arbitrary waveforms. Quickly set up modulated waveforms. Generatewaveforms with low noise, low spurious signal content and high dynamic range. Wide choice of bandwidths. Other models available up to 500 MHz. ● ●Built In Arbitrary Waveforms. Load and replay built in Arbitrary Waveforms. ● ●User Defined Waveforms. Store and recall user defined waveforms. ● ●Lower cost 5 MHz and 10 MHz single channel models are also available. Key Specifications Bandwidth 30 MHz, 60 MHz Channels 2 Independent Channels Memory 16 kpts/Ch Sample Rate 150 MS/s Display 4.3 inch TFT LCD Display Connectivity USB Host, USB Device, LAN Enquire about the T3AFG5 and T3AFG10. PRODUCT OVERVIEW Ordering Information Model Bandwidth Channel Memory per Ch Sample Rate per Ch T3AFG30 30 MHz 2 16 kpts 150 MS/s T3AFG60 60 MHz 2 16 kpts 150 MS/s Function T3AFG30, T3AFG60 Built-in Waveforms 5 Standard, 196 Arbitrary Input/Output 2 Waveform Outputs, Counter Input, Aux In/Out, 10 MHz Clock In/Out Modulation Functions AM, DSB-AM, FM, PM, FSK,ASK,PSK,PWM, Sweep, Burst, Harmonic TrueArb and EasyPulse Yes Maximum Amplitude Output < 10 MHz: 10 Vpp at 50 Ohms, 20 Vpp at HiZ > 10 MHz: 5 Vpp at 50 Ohms, 10 Vpp at HiZ Vertical D/A Resolution 14 Bits Display Size 4.3” Color TFT Excellent Performance Great Connectivity ● ●Model bandwidths from 30 MHz to 60 MHz ● ●All Models have 2 Channels ● ●16 kpts/Channel memory ● ●USB host The rise/fall times can be set independently to a minimum of 16.8 ns at any frequency and to a maximum of 22.4s. The T3AFG range of Function/Arbitrary Waveform Generators support a wide range of modulation types including AM, FM, PM, FSK,ASK,PSK and DSB-AM. Burst mode supports ‘N Cycle’and ‘Gated’ modes with the Burst source being configured as ‘Internal’, ‘External’ or ‘Manual’. Output amplitude into a high impedance load can be as high 20 Vpp at frequencies up to 10 MHz, and 10 Vpp for frequencies greater than 20 MHz. 2 port for mass storage ● ●USB device port (USBTMC) ● ●LAN port Low Jitter Sweep mode supports ‘Linear’ and ‘Log’ sweep, with ‘Up’ and ‘Down’ direction, and Sweep source can be configured as ‘Internal’, ‘External’ or ‘Manual’. The Teledyne Test Tools T3AFG30 and T3AFG60,with its low jitter design, can generate waveforms with exceptional edge stability. With better jitter performance comes better edge stability, and higher confidence in Sine wave output exhibits almost no spurious artefacts at 60 MHz and 0 dBm. your circuit design. Smart Capabilities ● ●Sweep output carrier can be Sine,Square, Ramp and Arbitrary waveforms ● ●Burst output under internal or external signal control ● ●Waveforms ● ●Frequency types include DC Resolution 1 µHz ● ●DSB-AM: Double ● ●Harmonic The counter functionality, accessed via the rear panel BNC,gives a DCor AC coupled counter capability from 100 mHz to 200 MHz. Sideband AM modulation Function Function generating up to 16 harmonics ● ●Multi-Language User Interface I/O Connectivity ● ●LAN ● ●10 and USB connection MHz Reference Input/Output ● ●Aux Input/Output ● ●External modulation input ● ●External burst/sweep ● ●External trigger input gate input ● ●The Aux Input/Output will output a trigger pulse when an internal source is used ● ●External Counter input 3 SPECIFICATIONS Frequency Specification Model T3AFG30 Waveform Sine Square Pulse Ramp/Triangular Noise Arbitrary Resolution Accuracy Sine, Square, Ramp, Pulse, Noise, Arbitrary 1 μHz - 30 MHz 1 μHz - 30 MHz 1 μHz - 12.5 MHz 1 μHz - 500 kHz 60 MHz (-3 dB) 1 μHz - 6 MHz 1 μHz 1st year aging +/- 2 5 ppm at 0 - 40 Degrees C T3AFG60 1 μHz - 60 MHz 1 μHz - 60 MHz Sine Wave Harmonic Distortion DC - 10 MHz 10 MHz - 30 MHz 30 MHz - 60 MHz