FLAX287R00F

FLA, FLB, FLC Series Precision Resistor (Conformally Coated) TCR, RESISTANCE RANGE, TOLERANCE, RATED POWER FLC FLB Type TCR (ppm/°C) –25°C to +125°C* Resistance Range (Ω) 0±5 (X) 0±2.5 (Y) 10 to 30 ±0.5 (D) ±1.0 (F) FLA 30 to 100 ±0.1 (B) ±0.5 (D) 100 to 100k ±0.05 (A) ±0.1 (B) FLB 0±5 (X) 0±2.5 (Y) FLA COMPOSITION OF TYPE NUMBER FLC FLA X 500R00 B 0±5 (X) 0±2.5 (Y) Resistance Tolerance (%)*† 10 to 30 ±0.5 (D) ±1.0 (F) 30 to 100 ±0.1 (B) ±0.5 (D) 100 to 150k ±0.05 (A) ±0.1 (B) 10 to 30 ±0.5 (D) ±1.0 (F) 30 to 100 ±0.02 (Q) ±0.05 (A) ±0.1 (B) ±0.5 (D) 100 to 200k ±0.01 (T) ±0.02 (Q) ±0.05 (A) ±0.1 (B) Rated Power (W) at 70°C 0.125 0.25 0.25 * Symbols parenthesized are for type number composition. † Resistance figures are the values obtained by measuring at the point 2.5±1.0 mm below the shoulder of leads. POWER DERATING CURVE Resistance value, in ohm, is expressed by a series of six characters, five of which represent significant digits. R or K is a dual-purpose letter that designates both the value range (R for ohmic; K for kilo-ohm) and the location of decimal point. CONFIGURATION (DIMENSIONS IN mm) Type FLA L W FLB 5.6±0.5 6.2±0.5 8.2±0.5 T F 6.2±0.5 2.2±0.5 2.54±0.25 5.08±0.25 ℓ 5±1 t 0.3±0.05 a 1.0±0.05 b 0.65±0.05 c 0.4±0.05 www.alpha-elec.co.jp 16 FLC 7.5±0.5 For any questions, contact sales-alpha@alpha-elec.co.jp Document No.: 67003 Revision: 25-Apr-2016 FLA, FLB, FLC Series PERFORMANCE Parameters ALPHA Specification Test Condition Maximum Rated Operating Temperature Working Temperature Range Maximum Working Voltage ALPHA Typical Test Data 70°C –25°C to +155°C FLA=250V, FLB/FLC=300V Temperature Cycling Overload Solderability Resistance to Solvents Low Temperature Storage Terminal Strength Dielectric Withstanding Voltage Insulation Resistance Resistance to Soldering Heat Moisture Resistance Shock Vibration Life (Rated Load) –25°C/30 min., Room Temperature/5 min., +155°C/30 min., 5 cycles ±0.05% ±0.01% Rated Voltage x 2.5, 5 sec. ±0.05% ±0.0025% 235°C, 2 sec. over 75% coverage over 75% coverage ➊ lsopropyl Alcohol ➋ Trichloroethylene no damage no damage –25°C, No Load, 2 hrs. ±0.05% ±0.0025% 0.908 kg (2 pounds), 10 sec. ±0.05% ±0.0025% Atmo. Pres.: AC 300V, 1 min. ±0.03% ±0.0025% DC 100V, 1 min. over 10,000 MΩ over 10,000 MΩ 350°C, 3 sec. ±0.03% ±0.0025% +65°C to –10°C, 90% RH to 98% RH, Rated Voltage,10 cycles (240 hrs.) ±0.1% ±0.015% 50G, 11 ms, Half-Sine Wave, X, Y, Z, each 3 shocks ±0.03% ±0.005% 20G, 10 Hz to 55 Hz to 10 Hz, 1 min., X, Y, Z, each 2 hrs. ±0.03% ±0.005% 70°C, Rated Power, 1.5 hr. – ON, 0.5 hr. – OFF, 1,000 hrs. ±0.1% ±0.01% Life (Moisture Load) 40°C, 90% RH to 95% RH, Rated Power, 1.5 hr. – ON, 0.5 hr. – OFF, 1,000 hrs. ±0.05% ±0.01% Storage Life High Temperature Exposure 15°C to 35°C, 15% RH to 75% RH, No Load, 10,000 hrs. 155°C, No Load, 1,000 hrs. ±0.02% ±0.05% ±0.005% ±0.01% Current Noise Pressure Cooker Test 121°C, 100% RH, 2 atmospheric, No Load, 100 hrs. -25 dB ±0.5% -42 dB ±0.1% FREQUENCY CHARACTERISTICS TEMPERATURE OF RESISTOR SURFACE (%)  FLB 150   R(AC)/R(DC) 10Ω 100Ω 100 1 kΩ 10 kΩ 50 1 Document No.: 67003 Revision: 25-Apr-2016 5 10 Frequency 50 100 40 kΩ (MHz) For any questions, contact sales-alpha@alpha-elec.co.jp www.alpha-elec.co.jp 17 Legal Disclaimer Notice Vishay Precision Group, Inc. Disclaimer ALL PRODUCTS, PRODUCT SPECIFICATIONS AND DATA ARE SUBJECT TO CHANGE WITHOUT NOTICE. Vishay Precision Group, Inc., its affiliates, agents, and employees, and all persons acting on its or their behalf (collectively, “VPG”), disclaim any and all liability for any errors, inaccuracies or incompleteness contained herein or in any other disclosure relating to any product. The product specifications do not expand or otherwise modify VPG’s terms and conditions of purchase, including but not limited to, the warranty expressed therein. VPG makes no warranty, representation or guarantee other than as set forth in the terms and conditions of purchase. To the maximum extent permitted by applicable law, VPG disclaims (i) any and all liability arising out of the application or use of any product, (ii) any and all liability, including without limitation special, consequential or incidental damages, and (iii) any and all implied warranties, including warranties of fitness for particular purpose, non-infringement and merchantability. Information provided in datasheets and/or specifications may vary from actual results in different applications and performance may vary over time. Statements regarding the suitability of products for certain types of applications are based on VPG’s knowledge of typical requirements that are often placed on VPG products. It is the customer’s responsibility to validate that a particular product with the properties described in the product specification is suitable for use in a particular application. You should ensure you have the current version of the relevant information by contacting VPG prior to performing installation or use of the product, such as on our website at vpgsensors.com. No license, express, implied, or otherwise, to any intellectual property rights is granted by this document, or by any conduct of VPG. The products shown herein are not designed for use in life-saving or life-sustaining applications unless otherwise expressly indicated. Customers using or selling VPG products not expressly indicated for use in such applications do so entirely at their own risk and agree to fully indemnify VPG for any damages arising or resulting from such use or sale. Please contact authorized VPG personnel to obtain written terms and conditions regarding products designed for such applications. Product names and markings noted herein may be trademarks of their respective owners. Copyright Vishay Precision Group, Inc., 2014. All rights reserved. Document No.: 63999 Revision: 15-Jul-2014 www.vpgsensors.com 1