TC7SB66FU

TC7SB66FU TOSHIBA CMOS DIGITAL INTEGRATED CIRCUIT SILICON MONOLITHIC TC7SB66FU Single Bus Switch The TC7SB66FU is a low on-resistance, high-speed CMOS 1-bit bus switch. This bus switch allows the connections or disconnections to be made with minimal propagation delay while maintaining Low power dissipation which is the feature of CMOS. When output enable (OE) is at High level, the switch is on; when at Low level, the switch is off. P-MOS and N-MOS channel block means the device is suitable for analog signal transmission. All inputs are equipped with protector circuits to protect the device from static discharge. Weight: 0.006 g (typ.) Features • • • • • • • Operating voltage: VCC = 2~5.5 V High speed operation: tpd = 0.25 ns (max) Ultra-low on resistance: RON = 5 Ω (typ.) Electro-static discharge (ESD) performance: ±200 V or more (JEITA) ±2000 V or more (MIL) High noise margin: VNIL = VNIH = 28% VCC (min) Power-down protection for inputs (control inputs only) Package: USV Pin Assignment (top view) VCC 5 OE 4 J9 1 A 2 B 3 GND 1 2001-09-12 TC7SB66FU Truth Table Inputs OE H L A port = B port Disconnect Function System Diagram A B OE Maximum Ratings Characteristics Power supply voltage Control pin input voltage Switch terminal I/O voltage Clump diode current Switch I/O current Power dissipation DC VCC/GND current Storage temperature Control input pin Switch terminal IIK IS PD ICC/IGND Tstg Symbol VCC VIN VS Rating −0.5~7.0 −0.5~7.0 −0.5~VCC + 0.5 −50 ±50 128 200 ±100 −65~150 Unit V V V mA mA mW mA °C Recommended Operating Conditions Characteristics Power supply voltage Control pin input voltage Switch I/O voltage Operating temperature Control pin input rise/fall time Symbol VCC VIN VS Topr dt/dv Rating 2.0~5.5 0~5.5 0~VCC −40~85 0~10 Unit V V V °C ns/V 2 2001-09-12 TC7SB66FU Electrical Characteristics DC Characteristics (Ta = −40~85°C) Characteristics Symbol Test Condition VCC (V) “H” level Control pin input voltage “L” level Control pin input leakage current Off-state leakage current (switch off) ISZ VIH VIL IIN VIN = 0~5.5 V A, B = 0~VCC, OE = GND VIS = 0 V, IIS = 30 mA VIS = 4.5 V, IIS = 30 mA ON resistance (Note 2) RON VIS = 2.4 V, IIS = 15 mA VIS = 0 V, IIS = 24 mA VIS = 3 V, IIS = 24 mA VIS = 0 V, IIS = 8 mA VIS = 2 V, IIS = 8 mA Quiescent supply current ICC VIN = VCC or GND, IOUT = 0   2.0~5.5 2.0~5.5 2.0~5.5 0.7 × VCC            Min Typ. (Note 1)     3 5 6 4 7 6 10  Max  0.3 × VCC ±1.0 ±1.0 7 15 12 9 20 12 30 10 µA Ω V Unit µA µA 2.0~5.5 4.5 4.5 4.5 3.0 3.0 2.0 2.0 5.5 Note 1: The typical values are at Ta = 25°C. Note 2: Apply the specified current to the switch, then measure the voltages on pins A and B. The on-resistance is the lower of the two. AC Characteristics (Ta = −40~85°C) Characteristics Symbol Test Condition VCC (V) 2.0 Propagation delay time (bus to bus) tpLH tpHL Figure 1, Figure 2 (Note 3) 3.3 ± 0.3 5.0 ± 0.5 2.0 Output enable time tpZL tpZH Figure 1, Figure 3 3.3 ± 0.3 5.0 ± 0.5 2.0 Output disable time tpLZ tpHZ Figure 1, Figure 3 3.3 ± 0.3 5.0 ± 0.5          0.5 0.35 0.25 8 5 4.5 8 6.5 5 ns ns ns Min Max Unit Note 3: The propagation delay time is calculated by the RC (on-resistance and load capacitance) time constant. Capacitive Characteristics (Ta = 25°C) Characteristics Control pin input capacitance Switch terminal capacitance Symbol CIN CI/O OE = GND Test Condition VCC (V) (Note 4) (Note 4) 5.0 5.0 3 10 pF pF Typ. Unit Note 4: Guaranteed by design. 3 2001-09-12 TC7SB66FU AC Test Circuit Open 2 × VCC GND Measure CL = 50 pF RL = 500 Ω CL RL Switch RL Parameter tpLH, tpHL tpLZ, tpZL tpHZ, tpZH Switch Open 2 × VCC GND Output Figure 1 AC Waveform tr 2.5 ns Input (A, B) tf 2.5 ns 90% 50% 10% VCC GND Output (B, A) tpLH VOH 50% tpHL VOL Figure 2 tpLH, tpHL tf 2.5 ns Output Enable (OE) tpLZ Output (A, B) Low to Off to Low tpHZ Output (A, B) High to Off to High Outputs enabled 90% tr 2.5 ns 90% 50% 10% tpZL VOH 50% 10% tpZH VOL VOH 50% VOL Outputs disabled Outputs enabled VCC GND Figure 3 tpLZ, tpHZ, tpZL, tpZH 4 2001-09-12 TC7SB66FU Package Dimensions Weight: 0.006 g (typ.) 5 2001-09-12 TC7SB66FU RESTRICTIONS ON PRODUCT USE 000707EBA • TOSHIBA is continually working to improve the quality and reliability of its products. Nevertheless, semiconductor devices in general can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical stress. It is the responsibility of the buyer, when utilizing TOSHIBA products, to comply with the standards of safety in making a safe design for the entire system, and to avoid situations in which a malfunction or failure of such TOSHIBA products could cause loss of human life, bodily injury or damage to property. In developing your designs, please ensure that TOSHIBA products are used within specified operating ranges as set forth in the most recent TOSHIBA products specifications. Also, please keep in mind the precautions and conditions set forth in the “Handling Guide for Semiconductor Devices,” or “TOSHIBA Semiconductor Reliability Handbook” etc.. • The TOSHIBA products listed in this document are intended for usage in general electronics applications (computer, personal equipment, office equipment, measuring equipment, industrial robotics, domestic appliances, etc.). These TOSHIBA products are neither intended nor warranted for usage in equipment that requires extraordinarily high quality and/or reliability or a malfunction or failure of which may cause loss of human life or bodily injury (“Unintended Usage”). Unintended Usage include atomic energy control instruments, airplane or spaceship instruments, transportation instruments, traffic signal instruments, combustion control instruments, medical instruments, all types of safety devices, etc.. Unintended Usage of TOSHIBA products listed in this document shall be made at the customer’s own risk. • The products described in this document are subject to the foreign exchange and foreign trade laws. • The information contained herein is presented only as a guide for the applications of our products. No responsibility is assumed by TOSHIBA CORPORATION for any infringements of intellectual property or other rights of the third parties which may result from its use. No license is granted by implication or otherwise under any intellectual property or other rights of TOSHIBA CORPORATION or others. • The information contained herein is subject to change without notice. 6 2001-09-12