TLX9160T(TPL,F

TLX9160T TOSHIBA Photocoupler Photorelay TLX9160T Battery Control in Automotive Equipment Fuel Battery Control in Automotive Equipment Application for Electrical Vehicle Unit: mm The Toshiba TLX9160T consists of an infrared emitting diode optically coupled to a photo-MOSFET in a SO16L-T package. This coupler uses high voltage MOSFET between output terminals. It adequate for the automotive control applications with a battery voltage of 1000V or less in an environment with a pollution degree 2 since the creepage distance on the detector side is 5mm or more. • Normally open (1-Form-A) device • Peak off-state voltage: 1500 V (min) • Trigger LED current: 3 mA (max) • On-state current: 50 mA (max) • On-state resistance: 250 Ω (max)(@ t < 1 s) • Isolation voltage: 5000 Vrms (min) • Clearance distance: 8mm (min) • Creepage distance: 8mm (min) • JEDEC ― Insulation thickness: 0.4mm (min) JEITA ― • Outer resin: CTI>600 • AEC-Q101 qualified TOSHIBA 11-10N1A Weight: 0.42 g (typ.) Pin Configuration (top view) 1: NC 2: NC 3: NC 4: Anode 5: Cathode 6: Anode 7: NC 8: NC 9: Drain 10: Drain 15: Drain 16: Drain © 2021 Toshiba Electronic Devices & Storage Corporation 1 2021-04-01 TLX9160T Absolute Maximum Rating (Unless otherwise specified, Ta = 25°C) (Note) Characteristics Symbol Rating Unit IF 30 mA ∆IF/°C -0.8 mA/°C VR 5 V Forward current Forward current derating (Ta ≥ 100°C) LED Reverse voltage Input Power Dissipation Input Power Dissipation Derating (Ta ≥ 100 °C) PD 50 mW ∆PD/°C -1.3 mW/°C Tj 135 °C 50 mA 20 mA 10 mA -0.5 mA/℃ 150 mA 60 mA 30 mA Junction temperature Ta = 25 °C On-state current ION Ta = 105 °C Ta = 125 °C On-state current derating On-state current Detector (Peak) (Note 3) Ta-45°C ⊿ION/℃ Ta = 25 °C Ta = 105 °C IONpk Ta = 125 °C Avalanche current (Note 1) IAV 0.6 mA Output power dissipation PO 600 mW ∆PO/°C -7 mW/℃ Tj 135 °C Storage temperature Tstg -55 to 150 °C Operating temperature Topr -40 to 125 °C Output power dissipation derating (Ta ≥ 47 °C) Junction temperature Lead soldering temperature (10 s) Tsol 260 °C Isolation voltage (AC, 60 s, R.H. ≤ 60%) (Note 2) BVS 5000 Vrms Note: Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum ratings. Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook (“Handling Precautions”/“Derating Concept and Methods”) and individual reliability data (i.e. reliability test report and estimated failure rate, etc). Note: This product is more sensitive than conventional products to electrostatic discharge (ESD). It is therefore all the more necessary to observe general precautions regarding ESD when handling this component. Note 1: 1min (max. continuous), Duty cycle=0.1%, 5 time over lifetime. Note 2: LED pins are shorted together. Detector pins are also shorted together. Note 3: Exponential curve, pulse width < 1ms, f ≤150Hz Recommended Operating Conditions (Note) Characteristics Symbol Min Typ. Max Unit Supply voltage VDD ― ― 1000 V Forward current IF 5 10 20 mA On-state current ION ― ― 50 mA Operating temperature Topr -40 ― 125 °C Note: Recommended operating conditions are given as a design guideline to obtain expected performance of the device. Additionally, each item is an independent guideline respectively. In developing designs using this product, please confirm specified characteristics shown in this document. © 2021 Toshiba Electronic Devices & Storage Corporation 2 2021-04-01 TLX9160T Electrical Characteristics (Unless otherwise specified, Ta = 25°C) Characteristics LED Symbol Test Condition Min Typ. Max IF = 10 mA 1.5 1.65 1.8 IF = 10 mA , Ta = -40 to 125 °C 1.4  1.95 Unit V Forward voltage VF Reverse current IR VR = 5 V   10 μA Capacitance CT V = 0 V, f = 1 MHz  45  pF 1500   V VOFF = 1000 V , Ta = 25 °C   100 VOFF = 1000 V , Ta = 105 °C   1000 VOFF = 1000 V , Ta = 125 °C   5000 VOFF = 0 V, f = 1 MHz  100  pF Min Typ. Max Unit Output withstand voltage VOFF Detector Off-state current IOFF Capacitance COFF IOFF=10uA, Ta=25 °C (Note1) nA Note 1: Reliability test of applying high voltage is demonstrated at 1200V. Coupled Electrical Characteristics Characteristics Trigger LED current Return LED current Symbol IFT IFC Test Condition ION = 50 mA , Ta=25 °C , t = 10 ms   3 ION = 20 mA , Ta= -40 to 105 °C, t = 10 ms   3 ION = 10 mA, Ta= -40 to 125 °C, t = 10 ms   3 0.05     250   350   400 Min Typ. Max Unit 0.9  pF 10  Ω   Vrms IOFF = 100 μA, Ta= -40 to 125 °C, t = 40 ms ION = 50 mA, IF = 10 mA, Ta = 25 °C, t < 1 s On-state resistance RON ION = 20 mA, IF = 10 mA, Ta = 105 °C, t < 1 s ION = 10 mA, IF = 10 mA, Ta = 125 °C, t