TPS842A

TPS842A(F),TPS844(F) TOSHIBA Photo-IC Silicon Epitaxial Planar TPS842A(F),TPS844(F) Lead(Pb)-Free Photoelectric Switches Copiers, Printers, and Facsimiles Vending Machines Handy Terminals The TPS842A(F) and TPS844(F) represent a Si photo IC of digital output type that integrates a photodiode, amplifier circuit, and Schmitt trigger circuit into a single chip. These devices are low voltage drive types, and they allow construction of low voltage systems which thus consume less power. These devices respond faster than the phototransistor type. They output a low when light is input. • • • • • • Compact side-view epoxy resin package Operates over a wide supply voltage range : VCC = 2.7 to 15 V High speed response : tpLH = 15 μs, tpHL = 9 μs (max) High sensitivity: 0.3 mW/cm2 (max) Can be directly connected to TTL and CMOS. Digital output: TPS842A(F) …. open collector TPS844(F) …. with a pull-up resistor Unit: mm TOSHIBA Weight: 0.12 g (typ.) 0-3H1 Absolute Maximum Ratings (Ta = 25°C) Characteristics Supply voltage Output voltage Output current Output current derating (Ta > 25°C) Power dissipation Power dissipation derating (Ta > 25°C) Operating temperature range Storage temperature range Soldering temperature (5s) (Note 1) TPS842A(F) TPS844(F) Symbol VCC VO IO ΔIO/°C P ΔP/°C Topr Tstg Tsol Rating 15 15 =VCC 16 −0.213 250 −3.33 −30 to 95 −40 to 100 260 Unit V V mA mA/°C mW mW/°C °C °C °C Note: Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum ratings and the operating ranges. Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook (“Handling Precautions”/“Derating Concept and Methods”) and individual reliability data (i.e. reliability test report and estimated failure rate, etc). Note 1: At the location of 1.3 mm from the resin package bottom. 1 2007-10-01 TPS842A(F),TPS844(F) Pin Connection TPS842A(F) TPS844(F) (Ta = −30 to 95°C, VCC = 2.7 to 15 V, typical values are all at 25°C.) Characteristics Supply voltage High level supply current Low level supply current High level output current High level output voltage TPS842A(F) TPS844(F) TPS842A(F) TPS844(F) Symbol VCC ICCH ICCL IOH VOH VOL EHL EHL/ELH λP “L→H” “H→L” tpLH tpHL tr tf Ta = 25°C VCC = 3.3 V 2 E = 2 mW/cm RL = 10 kΩ E=0 E = 2 mW/cm 2 Opto-Electrical Characteristics Test Condition ⎯ Min 2.7 ⎯ (Note 2) ⎯ ⎯ ⎯ 0.9*VCC Typ. ⎯ 0.5 0.9 2.9 ⎯ ⎯ 0.07 0.2 ⎯ 1.5 900 ⎯ ⎯ 0.8 0.02 Max 15 1.2 2 4 6.3 ⎯ 0.4 0.3 0.6 2 ⎯ 15 9 3 0.5 Unit V mA mA μA V V mW/ 2 cm ⎯ nm VO = 15 V, E = 0 E=0 E = 2 mW/cm IOL = 16 mA Ta = 25°C ⎯ Ta = 25°C ⎯ 2 Low level output voltage “H→L” Threshold radiant incidence Hysteresis ratio Peak sensitivity wavelength Propagation delay time Rise time Fall time (Note 2) ⎯ ⎯ ⎯ 1.1 ⎯ ⎯ ⎯ Switching time (Note 3) ⎯ ⎯ μs Note 2: CIE standard light source A (standard tungsten bulb) with color temperature = 2856 K. 2 2007-10-01 TPS842A(F),TPS844(F) Note 3: Switching time measurement circuit and waveform. TPS842A(F) VOL.REG. AMP (INFRARED LED) (TPS842A(F)) TPS844(F) VOL.REG. AMP (INFRARED LED) (TPS844(F)) Precautions • • • • When you consider a combined use with an LED, be sure to use an infrared LED. Visible rays in wavelength of less than 700 nm cannot be detected. Make sure the shielding plate that is used to detect positions is manufactured from materials with superior light-shielding characteristics. Insufficient shield can cause malfunction. Photo ICs contain a high-sensitivity amplifier. Toshiba recommends connecting a capacitor of about 0.01 μF that has good high-frequency characteristics between VCC and GND near the device to prevent unwanted oscillation. Please install so that disturbance light is not irradiated by these products. When disturbance light (incandescence light etc.) 700 nm or more is detected, it may incorrect-operate. Please perform sufficient evaluation and verification by set. During 100 μs after turning on VCC, output voltage changes for stabilizing the inner circuit. • 3 2007-10-01 TPS842A(F),TPS844(F) P – Ta 300 20 IO – Ta Allowable power dissipation P (mW) 250 IO (mA) Allowable output current 0 20 40 60 80 100 16 200 12 150 8 100 50 4 0 −20 0 −20 0 20 40 60 80 100 Ambient temperature Ta (°C) Ambient temperature Ta (°C) VOL – IOL 1 VCC = 3.3V Ta = 25°C (typ.) 1000 VOL – Ta VOL (mV) VCC = 3.3 V (typ.) VOL (V) 100 IOL = 16 mA 8 mA 5 mA 1 mA Low level output voltage 0.1 Low level output voltage 10 1 −40 0.01 1 10 100 −20 0 20 40 60 80 100 Ambient temperature Ta (°C) Low level output current IOL (mA) Relative ELH, EHL – VCC 1.4 Ta = 25°C (typ.) 1.8 1.6 1.4 1.2 1.0 0.8 0.6 0.4 0.2 0 −40 −20 Relative ELH, EHL – Ta VCC = 3.3 V (typ.) Relative threshold radiant incidence 1.2 EHL 1.0 0.8 0.6 0.4 0.2 0 0 ELH Relative threshold radiant incidence EHL ELH 4 8 12 16 20 0 20 40 60 80 100 120 Supply voltage VCC (V) Ambient temperature Ta (°C) 4 2007-10-01 TPS842A(F),TPS844(F) tpLH, tpHL – E/EHL 10 (typ.) 10 VCC = 3.3 V Ta = 25°C E = 2 mW/cm2 tr, tf – RL (typ.) Propagation delay time tpLH, tpHL (μs) 9 8 7 6 5 4 3 2 1 0 1 VCC = 3.3 V RL = 10 kΩ Ta = 25°C tpLH Rise and fall time tr, rf (μs) 1 tr 0.1 tpHL tf 10 100 Threshold radiant incidence ratio E/EHL 0.01 0.1 1 10 100 Load resistance RL (kΩ) Directional sensitivity characteristic Spectral response (typ.) (typ.) Relative sensitivity wavelength λ (nm) Relative sensitivity 5 2007-10-01 TPS842A(F),TPS844(F) RESTRICTIONS ON PRODUCT USE • The information contained herein is subject to change without notice. 20070701-EN GENERAL • TOSHIBA is continually working to improve the quality and reliability of its products. Nevertheless, semiconductor devices in general can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical stress. It is the responsibility of the buyer, when utilizing TOSHIBA products, to comply with the standards of safety in making a safe design for the entire system, and to avoid situations in which a malfunction or failure of such TOSHIBA products could cause loss of human life, bodily injury or damage to property. In developing your designs, please ensure that TOSHIBA products are used within specified operating ranges as set forth in the most recent TOSHIBA products specifications. Also, please keep in mind the precautions and conditions set forth in the “Handling Guide for Semiconductor Devices,” or “TOSHIBA Semiconductor Reliability Handbook” etc. • The TOSHIBA products listed in this document are intended for usage in general electronics applications (computer, personal equipment, office equipment, measuring equipment, industrial robotics, domestic appliances, etc.).These TOSHIBA products are neither intended nor warranted for usage in equipment that requires extraordinarily high quality and/or reliability or a malfunction or failure of which may cause loss of human life or bodily injury (“Unintended Usage”). Unintended Usage include atomic energy control instruments, airplane or spaceship instruments, transportation instruments, traffic signal instruments, combustion control instruments, medical instruments, all types of safety devices, etc.. Unintended Usage of TOSHIBA products listed in his document shall be made at the customer’s own risk. • The products described in this document shall not be used or embedded to any downstream products of which manufacture, use and/or sale are prohibited under any applicable laws and regulations. • The information contained herein is presented only as a guide for the applications of our products. No responsibility is assumed by TOSHIBA for any infringements of patents or other rights of the third parties which may result from its use. No license is granted by implication or otherwise under any patents or other rights of TOSHIBA or the third parties. • Please contact your sales representative for product-by-product details in this document regarding RoHS compatibility. Please use these products in this document in compliance with all applicable laws and regulations that regulate the inclusion or use of controlled substances. Toshiba assumes no liability for damage or losses occurring as a result of noncompliance with applicable laws and regulations. 6 2007-10-01