TPAC200P-490

UNIVERSAL AC INPUT HARMONIC CORRECTION AC-DC HOT-SWAP CompactPCI QUAD OUTPUT 200 WATTS ACTIVE CURRENT SHARING SWITCHING POWER SUPPLIES TPAC200P SERIES FEATURES: 200W 3U X 8HP EUROCARD PACKAGE MEET IEC1000-3-2 HARMONIC CORRECTION INTERNAL OR-ING DIODES FOR N+1 REDUNDANCY HOT-SWAPPABLE THIRD-WIRE CURRENT SHARING EMI MEET EN 55022 / FCC CLASS A CE MARKING COMPLIANCE FULLY COMPLIANT WITH PICMG TOTAL POWER INT'L SPECIFICATION INPUT SPECIFICATION Input Voltage: Typ. 90-264Vac. Power Factor Correction: Meet Harmonic Correction IEC1000-3-2.Power Factor typ. 0.96-0.98. Input Connector: Positronic 47-pin PCIH47M400A1. Input Frequency: 47-63Hz. Inrush Current: Less than 30.6A @ 230Vac. Input Current: 2.3A @115Vac/1.2A @230Vac. Dielectric Withstand: Meet IEC950 regulation. EMI: Meet EN55022 / FCC Class A. Hold-up Time: 10mS after power fail signal. Turn-on Delay/Rise Time: 1 Sec./20 mS. Earth Leakage: Less than 0.5mA @230Vac. Remote ON/OFF: Available at [INH#] & [EN#] pins. Power Fail Signal: Available at [FAL#] pin. Status LED: means valid input voltage. means a critical fault. Thermal Protection (OTP): Installed NTC and thermostat. for thermal sensor at [DEG#] pin. Leakage Current: Typ. 0.5A. Power OK Signal: Available at all output. Over Current Protection (OCP): Installed in each rail. OUTPUT SPECIFICATION Output Voltage: See Ratings Chart. Output Current: See Ratings Chart. Output Wattage: Typ. 200W continuous. Output Connector: Positronic 47-PIN PCIH47M400A1 connector. Line Regulation: Typ. 0.1%. Load Regulation: VO1 & VO2 typ. ±1.0%. VO3 & VO4 typ. ±2.0%. Noise & Ripple: Typ. 1% peak to peak or 50mV, which is greater. OVP: Built-in at all outputs. Adjustability: Available at VO1,2&3. Output Trim: Electrical trim available at VO1&2. [ADJ #]. Remote Sensing: Available at VO1,VO2 & VO3. Hot-Swap: Available. N+1 Redundancy: Installed with internal OR-ing diodes at all outputs for N+1 redundancy operation. Current Sharing: Third-wire current sharing at VO1,2 & 3. Overload Protection (OLP): Fully protected against output overload or short circuit. Typ. set at 130% max. load. Consult the factory for special OLP setting. Operating Temperature: 0 to +50 °C at full load with specified air flow. Derates linearly to 50% at +70°C. Storage Temperature: -40 to +85 °C. Temperature Coefficient: Typ. ±0.02% / °C. Cooling: At least 20cfm (600 lfm) moving air is required to achieve full rating power 200W in a confined area. Power Density: 3.73 Watts/ Cubic Inch. GENERAL SPECIFICATION Efficiency: Typ. 76-79 %. Switching Frequency: 130K Hz. Circuit Topology: Forward circuit. Transient Response: Peak transient less than 100mV and recovers within 3mS after 25% load-change. Safety Standard: IEC60950 Class I. Construction: Eurocard 3U X 8HP X 160mm CompactPCI format. Front Panel with either Ordinary handle or Extractor handle. Remark: All measurements are at nominal input, full load and +25°C unless otherwise specifications. In application TOTAL POWER, INT. Tel: 877-646-0900 Fax: 978-453-7395 Email: sales@total-power.com http://www.total-power.com -1- OUTPUT VOLTAGE/CURRENT RATINGS CHART QUAD OUTPUT MODEL NO. TPAC200P-490(E) TPAC200P-490(O) MAIN +VO1 @★#≡⊙ Min. 2.0A 2.0A Typ. 25.0A 25.0A Volt. +5V +5V Max. 33.0A 33.0A AUX. +VO2 ▲@★#≡⊙ Typ. 10.0A 10.0A Volt. +3.3V +3.3V Max. 33.0A 33.0A AUX. +VO3 ▲≡#⊙@ Typ. 3.0A 3.0A Volt. +12V +12V Max. 5.0A 5.0A Peak 6.0A 6.0A AUX. –VO4 ●⊙■= Typ. 0.5A 0.5A Volt. -12V -12V Max. 1.0A 1.0A Peak. 1.0A 1.0A Symbol: "★" OVP built-in. "@" Adjustable. "#" Remote sensing. "≡" 3rd- wire Load Sharing. "=" Droop Current Sharing. "⊙" Installed with Or-ing diode. "▲" Magnetic Amplifier. "●" Installed with Post-regulator. "■" Common Choke. Remark: Peak load less than 60sec. with duty cycle