0
登录后你可以
  • 下载海量资料
  • 学习在线课程
  • 观看技术视频
  • 写文章/发帖/加入社区
会员中心
创作中心
发布
  • 发文章

  • 发资料

  • 发帖

  • 提问

  • 发视频

创作活动
TPAC300P

TPAC300P

  • 厂商:

    TOTAL-POWER

  • 封装:

  • 描述:

    TPAC300P - UNIVERSAL AC INPUT HARMONIC CORRECTION AC-DC HOT-SWAP CompactPCI QUAD OUTPUT 300 WATTS AC...

  • 详情介绍
  • 数据手册
  • 价格&库存
TPAC300P 数据手册
UNIVERSAL AC INPUT HARMONIC CORRECTION AC-DC HOT-SWAP CompactPCI QUAD OUTPUT 300 WATTS ACTIVE CURRENT SHARING SWITCHING POWER SUPPLIES TPAC300P SERIES FEATURES: 300W 6U X 8HP EUROCARD PACKAGE MEET IEC1000-3-2 HARMONIC CORRECTION INTERNAL OR-ING DIODES FOR N+1 REDUNDANCY HOT-SWAPPABLE THIRD-WIRE CURRENT SHARING EMI MEET EN 55022 / FCC CLASS B CE MARKING COMPLIANCE FULLY COMPLIANT WITH PICMG TOTAL POWER INT'L SPECIFICATION INPUT SPECIFICATION Input Voltage: Typ. 90-264Vac. Input On/Off switch: Option. Power Factor Correction: Meet Harmonic Correction IEC1000-3-2. Power Factor typ.0.99. Input Connector: Positronic 47-pin PCIH47M400A1. Input Frequency: 47-63Hz. Inrush Current: Typ. 30A @ 230Vac.(Active). Input Current: Typ. 4.0A@115Vac/2.0A @ 230Vac. Dielectric Withstand: Meet IEC950 regulation. Transient Protection: MOV withstands transient as specified by EN61000-4-4 level 3. EMI: Meet EN55022 / FCC Class B. Hold-up Time: Typ. 30mS @ 115Vac,34mS @ 230Vac. Remote ON/OFF: Available at [INH#] & [EN#] pins. Power Fail Signal: Available at [FAL#] pin. Status LED: means valid input voltage. means a critical fault. Thermal Protection (OTP): Installed NTC and thermostat for thermal sensor at [DEG#] pin. Power OK: Installed at all outputs. Leakage Current: Typ. 0.7A @ 230Vac. OUTPUT SPECIFICATION Output Voltage: See Ratings Chart. Output Current: See Ratings Chart. Output Power: Typ. 300W continuous. Output Connector: Positronic 47-pin PCIH47M400A1. Line Regulation: Typ. 0.1%. Load Regulation: VO1 & VO2 typ.±0.5-1.0%. VO3 & VO4 typ.±1.0-3.0%. Noise & Ripple: Typ. 1% peak-peak or 50mV,which is greater. OVP: Built-in at all outputs. Adjustability: Available at VO1, 2 &3. Output Trim: Electrical trim available at VO1 / VO2.[ADJ #]. Remote Sensing: Available at VO1,VO2 & VO3. Hot-Swap: Available N+1 Redundancy: Installed with internal OR-ing diodes at all outputs and third-wire current sharing method for N+1 redundancy operation. Current Sharing: Third-wire current sharing at VO1,2&3. DC OK Signal: Available for all outputs. Power OK Signal: Available for all outputs. Over Current Protection (OCP): Installed at each rail. Overload Protection (OLP): Fully protected against output overload or short circuit. Typ. 120-130% max. load. Consult the factory for special OLP setting. GENERAL SPECIFICATION Efficiency: Typ. 80-83 %. Switching Frequency: 120K Hz. Circuit Topology: Forward circuit. Transient Response: Peak transient less than 200mV and returns to within 1% less than 250µS for 25% load-change. Safety Standard: IEC60950 Class I. Construction: Eurocard 6U X 8HP X 160mm CompactPCI format. Front Panel with Extractor handle. Operating Temperature: 0 to +50 °C at full load with specified air flow. Derates linearly to 50% at +70 °C Storage Temperature: -40 to +85 °C. Temperature Coefficient: Typ. ±0.02% / °C. Cooling: At least 20 cfm moving air is required to achieve full rating power 300W in a confined area. Power Density: 2.70 Watts/ Cubic Inch. Remark: All measurements are at nominal input, full load and +25°C unless otherwise specifications. TOTAL POWER, INT. Tel: 877-646-0900 Fax: 978-453-7395 Email: sales@total-power.com http://www.total-power.com -1- OUTPUT VOLTAGE/CURRENT RATINGS CHART QUAD OUTPUT MODEL NO. TPAC300P-490 MAIN +VO1 @★#≡⊙ Min. Typ. 2A 20A Volt. +5V Max. 35A AUX. +VO2 ▲@★#≡⊙ Min. 0A Typ. AUX. +VO3 ▲≡#⊙★@ AUX. –VO4 ●⊙★ Volt. Max. Min. Typ. Volt. Max. Pk. Min. Typ. Volt. Max. Pk. 0A 10A +12V 12A 15A 0A 0.8A -12V 1A 1.5A 20A +3.3V 25A Symbol: "★" OVP built-in. "@" Adjustable. "#" Remote sensing. "≡" 3rd-wire Load Sharing. "⊙" Installed with Or-ing diode. "▲" Magnetic Amplifier. "●" Installed with Post-regulator. "■" Common Choke. Remark: Peak load less than 60sec. with duty cycle
TPAC300P
1. 物料型号: - 型号为TPAC300P系列,这是一个300瓦特的6U X 8HP EUROCARD封装的AC-DC电源模块。

2. 器件简介: - 该器件是一个通用AC输入谐波校正AC-DC电源模块,具有热插拔功能和四路输出。它满足IEC1000-3-2谐波校正标准,并具有N+1冗余和热插拔能力。

3. 引脚分配: - 输入引脚包括L(火线)、N(零线)和G(地线),分别对应47、46和45号引脚。 - 输出引脚为VO1、VO2、VO3和VO4,分别对应1-4、13-18、33和32号引脚。 - 状态/控制引脚包括EN#、DEG#、INH#和FAL#,分别对应36、21、27和38号引脚。

4. 参数特性: - 输入电压范围为90-264Vac。 - 功率因数校正满足IEC1000-3-2标准,功率因数典型值为0.99。 - 输入频率为47-63Hz。 - 效率典型值为80-83%。 - 开关频率为120KHz。 - 电路拓扑为前向电路。

5. 功能详解: - 该电源模块具有远程开关功能、电源故障信号、热保护和过流保护等功能。 - 支持N+1冗余操作,具有内部OR-ing二极管和第三线电流共享方法。 - 具有过压保护(OVP)和远程感测功能。

6. 应用信息: - 适用于需要高功率密度、高效率和热插拔能力的工业、通信和计算应用。 - 工作温度范围为0到+50°C,在指定气流下可满负载运行。

7. 封装信息: - 封装为6U X 8HP X 160mm CompactPCI格式,前面板带有提取手柄。 - 重量为1.7kg(3.75 lb)。
TPAC300P 价格&库存

很抱歉,暂时无法提供与“TPAC300P”相匹配的价格&库存,您可以联系我们找货

免费人工找货