TMV2405D

DC/DC Converters TMV Series, 1 Watt compliant RoHS Features ◆ Single-in-Line (SIL) Package ◆ Isolated Single and Dual Output Models ◆ I/O-Isolation 3‘000 VDC ◆ High Efficiency up to 81% ◆ Extended Temperature Range –40°C to +85°C ◆ ◆ ◆ ◆ Pin-compatible with other Manufacturers 100% Burn-in (8 h) Lead free Design, RoHS compliant 3 Year Product Warranty The TMV series are miniature, isolated 1 W DC/DC-converters with high isolation in a Single-in-Line package (SIP). Requiring only 1.2 cm2 board space they offer the ideal solution in many space critical applications for board level power distribution. The use of SMD-technology makes it possible to offer a product with high performance at low cost. Models Ordercode TMV 0505S TMV 0512S TMV 0515S TMV 0505D TMV 0512D TMV 0515D TMV 1205S TMV 1212S TMV 1215S TMV 1205D TMV 1212D TMV 1215D TMV 2405S TMV 2412S TMV 2415S TMV 2405D TMV 2412D TMV 2415D http://www.tracopower.com 24 VDC ±10% 12 VDC ±10% 5 VDC ±10% Input voltage Output voltage 5 VDC 12 VDC 15 VDC ± 5 VDC ±12 VDC ±15 VDC 5 VDC 12 VDC 15 VDC ± 5 VDC ±12 VDC ±15 VDC 5 VDC 12 VDC 15 VDC ± 5 VDC ±12 VDC ±15 VDC Output current max. 200 mA 80 mA 65 mA ±100 mA ± 40 mA ± 30 mA 200 mA 80 mA 65 mA ±100 mA ± 40 mA ± 30 mA 200 mA 80 mA 65 mA ±100 mA ± 40 mA ± 30 mA Efficiency typ. 71 % 78 % 78 % 72 % 78 % 79 % 73 % 80 % 80 % 74 % 81 % 81 % 71 % 78 % 79 % 72 % 79 % 80 % Page 1 of 3 DC/DC Converters TMV Series Input Specifications Input current no load /full load 5 Vin models 30 mA / 260 mA typ. 12 Vin models 12 mA / 110 mA typ. 24 Vin models 7 mA / 50 mA typ. 5 Vin models 9 V max. 12 Vin models 18 V max. 24 Vin models 30 V max. 0.3 A max. can be reduced by ext. 1–3.3 µF polyester film capacitor internal capacitor ±3% ± 1 % max. ± 1.2 % / 1 % change Vin ± 10 % max. 100 mV pk-pk max. ± 0.02 % / K limited 1 sec. max. single output models: 680 µF max. dual output models: 220 µF max. – Operating – Case temperature – Storage –40 °C ... +85 °C +95 °C max. –40 °C ... +105 °C 95 % rel H max. >2’000’000 h @ 25 °C 3‘000 VDC 60 pF typ. >10‘000 M Ohm 100 kHz typ. ( Frequency modulation) ± 30 % max. Input/Output Input/Output Input/Output – Input variation – Load variation 20 – 100 % 1 Watt Surge voltage (1 sec. max.) Reverse voltage protection Reflected input ripple current* Input filter Output Specifications Voltage set accuracy Voltage balance ( dual output models) Regulation Ripple and noise (20 MHz Bandwidth) Temperature coefficient Short circuit protection Capacitive load General Specifications Temperature ranges Humidity (non condensing) Reliability, calculated MTBF ( MIL-HDBK-217E) Isolation voltage Isolation capacity Isolation resistance Switching frequency Frequency change over line and load All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated. http://www.tracopower.com Page 2 of 3 DC/DC Converters TMV Series Physical Specifications Case material Package weight Soldering temperature – Single output models – Dual output models non conductive FR4 (UL 94V-0 rated) 2.1 g (0.07 oz) 2.6 g (0.09 oz) max. 265°C / 10 sec 1 Watt Outline Dimensions mm (inches) Pin-Out 10.2 (0.4) Pin 1 2 5 3.2 (0.13) 6 7 Single +Vin (Vcc) –Vin (GND) –Vout No pin +Vout Dual +Vin (Vcc) –Vin (GND) –Vout Common +Vout 0.5 (0.02) 0.5 (0.02) 2.3 ±0.4 (0.09 ±0.02) 2.54 (0.1) 7.62 (0.3) 19.5 (0.77) 2.54 2.54 (0.1) (0.1) 0.5 (0.02) 1 2 5 6 0.5 (0.02) 7 1.25 Tolerances ±0.25 (0.01) pins ±0.05 (0.002) Specifications can be changed without notice Rev. 10/05.1 Jenatschstrasse 1 · CH-8002 Zurich · Switzerland Tel. +41 43 311 45 11 · Fax +41 43 311 45 45 · info@traco.ch · www.tracopower.com (0.05) 6.1 (0.24) Bottom view 24 V Models 0.25 (0.01) 4.75 (0.19) 5.75 (0.23) 7.1 (0.28) Page 3 of 3