TS64MDOM44H

Transcend 44-Piin IIDE Fllash Modulle Transcend 44-P n DE F ash Modu e TS32M ~ 64MDOM44H TS32M ~ 64MDOM44H Description With an IDE interface and strong data retention ability, 44-Pin IDE Flash Modules are ideal for use in the harsh environments where Industrial PCs, Set-Top Boxes, etc. are used. Features • • • • • • • RoHS compliant products Storage Capacity: 32MB ~ 64MB Operating Voltage: 3.3V ± 5% or 5V ± 10% Operating Temperature: 0°C ~ 70°C Endurance: 1,000,000 Program/Erase cycles Durability of Connector: 5,000 times Fully compatible with devices and OS that support the IDE standard (pitch = 2.00mm) Built-in ECC function assures high reliability of data transfer Auto Sleep and Power-Down modes supported Supports up to PIO mode 2 Placement • • • Dimensions Side A B C D E F G (Diameter) H I J K L M Millimeters 46.00 ± 0.40 28.00 ± 0.20 5.77 ± 0.10 4.50 ± 0.10 7.12 ± 0.10 22.12 ± 0.20 3.30 ± 0.10 4.00 ± 0.10 3.50 ± 0.10 4.00 ± 0.10 2.19 ± 0.05 2.00 ± 0.05 1.00 ± 0.05 Inches 1.81 ± 0.02 1.10 ± 0.01 0.23 ± 0.005 0.18 ± 0.005 0.28 ± 0.005 0.87 ± 0.01 0.13 ± 0.005 0.16 ± 0.005 0.14 ± 0.005 0.16 ± 0.005 0.08 ± 0.003 0.08 ± 0.003 0.04 ± 0.003 Transcend Information Inc. 1 Ver 1.1 Transcend 44-Piin IIDE Fllash Modulle Transcend 44-P n DE F ash Modu e TS32M ~ 64MDOM44H TS32M ~ 64MDOM44H Pin Assignments Pin No. Pin Name Pin Pin Pin No. Name No. 11 12 13 14 15 16 17 18 19 20 HD3 HD12 HD2 HD13 HD1 HD14 HD0 HD15 GND VCC 21 22 23 24 25 26 27 28 29 30 Pin Name NC GND IOWB GND IORB GND NC NC NC GND Pin No. 31 32 33 34 35 36 37 38 39 40 Pin Name IREQ IOIS16B HA1 PDIAGB HA0 HA2 CE1B CE2B DASPB GND Pin Definition Symbol HD0 ~ HD15 HA0 ~ HA2 RESET IORB IOWB IOIS16B CE1B, CE2B PDIAGB DASPB IREQ NC GND VCC Function Data Bus (Bi-directional) Address Bus (Input) Device Reset (Input) Device I/O Read (Input) Device I/O Write (Input) Transfer Type 8/16 bit (Output) Chip Select (Input) Pass Diagnostic (Bi-directional) Disk Active/Slave Present (Bi-directional) Interrupt Request (Output) No Connection Ground Vcc Power Input 01 RESET 02 GND 03 HD7 04 HD8 05 HD6 06 HD9 07 HD5 08 HD10 09 HD4 10 HD11 Pin Layout Pin1 Bulge Pin43 Pin2 Pin44 Transcend Information Inc. 2 Ver 1.1 Transcend 44-Piin IIDE Fllash Modulle Transcend 44-P n DE F ash Modu e TS32M ~ 64MDOM44H TS32M ~ 64MDOM44H Block Diagram With 1 pcs of Flash Memory: With 2 pcs of Flash Memory: Transcend Information Inc. 3 Ver 1.1 Transcend 44-Piin IIDE Fllash Modulle Transcend 44-P n DE F ash Modu e TS32M ~ 64MDOM44H TS32M ~ 64MDOM44H Absolute Maximum Ratings Symbol VDD VIN VOUT TSTG Parameter Power supply Input voltage Output voltage Storage temperature Rating -0.3 to +6.7 -0.3 to VDD + 0.3 -0.3 to VDD + 0.3 -40 to 125 Units V V V ℃ Recommended Operating Conditions Symbol VDD VIN TOPR Parameter Power supply Input voltage Operating temperature Min 3.0 0 0 Max 5.5 VDD 70 Units V V ℃ DC Characteristics (Ta=0 ℃ to +70 ℃, Vcc = 3.3V ±10%) Parameter Input Voltage Output Voltage IOL = 3mA Input leakage current Sleep current Sector read current Sector write current Symbol VIH VIL VOH VOL ILK ISP ISR (DC) ISR (Peak) ISW (DC) Conditions --IOL = -3mA IOL = 3mA VIH = VDD / VIL = GND Control signal = Vcc – 0.2 Control signal = Vcc – 0.2 Control signal = Vcc – 0.2 Min 0.7x Vcc -0.3 Vcc – 0.4 --1 ----- Typ -----80 20 40 25 Max Vcc + 0.3 0.2 x Vcc -0.4 1 ----- Unit V V V V uA uA mA mA mA ISW (Peak) -- 50 -- mA Transcend Information Inc. 4 Ver 1.1 Transcend 44-Piin IIDE Fllash Modulle Transcend 44-P n DE F ash Modu e TS32M ~ 64MDOM44H TS32M ~ 64MDOM44H True IDE Mode Access Read AC Characteristics Parameter Data delay after IORD Data hold following IORD IORD width time Address setup before IORD Address hold following IORD CE setup before IORD CE hold following IORD IOIS16 delay falling from address IOIS16 delay rising from address Symbol td(IORD) th(IORD) tw(IORD) tsuA(IORD) thA(IORD) tsuCE(IORD) thCE(IORD) tdfIOIS16(ADR) tsfIOIS16(ADR) Min － 0 70 25 10 5 10 － － Typ － － － － － － － － － Max 55 － － － － － － 35 35 Unit ns ns ns ns ns ns ns ns ns True IDE Mode Access Read Timing Transcend Information Inc. 5 Ver 1.1 Transcend 44-Piin IIDE Fllash Modulle Transcend 44-P n DE F ash Modu e TS32M ~ 64MDOM44H TS32M ~ 64MDOM44H True IDE Mode Access Write AC Characteristics Parameter Data setup before IOWR Data hold following IOWR IOWR width time Address setup before IOWR Address hold following IOWR CE setup before IOWR CE hold following IOWR IOIS16 delay falling from address IOIS16 delay rising from address Symbol tsu(IOWR) th(IOWR) tw(IOWR) tsuA(IOWR) thA(IOWR) tsuCE(IOWR) thCE(IOWR) tdfIOIS16(ADR) tsfIOIS16(ADR) Min 20 10 70 25 10 5 10 － － Typ － － － － － － － － － Max － － － － － － － 35 35 Unit ns ns ns ns ns ns ns ns ns True IDE Mode Access Write Timing Transcend Information Inc. 6 Ver 1.1 Transcend 44-Piin IIDE Fllash Modulle Transcend 44-P n DE F ash Modu e TS32M ~ 64MDOM44H TS32M ~ 64MDOM44H Ordering Information TS XXXX DOM 44 H Transcend Product Capacity: 32M-512M = 32 MB up to 512 MB 1G-4G = 1 GB up to 4 GB IDE Flash Module (Disk On Module) Type: V = Vertical H = Horizontal Pin Count: 40 = 40 pin 44 = 44 pin The above technical information is based on industry standard data and has been tested to be reliable. However, Transcend makes no warranty, either expressed or implied, as to its accuracy and assumes no liability in connection with the use of this product. Transcend reserves the right to make changes to the specifications at any time without prior notice. USA Los Angeles: E-mail: sales@transcendusa.com Maryland: E-mail: sales_md@transcendusa.com www.transcendusa.com CHINA E-mail: sales@transcendchina.com www.transcendchina.com TAIWAN No.70, XingZhong Rd., NeiHu Dist., Taipei, Taiwan, R.O.C TEL +886-2-2792-8000 Fax +886-2-2793-2222 E-mail: sales@transcend.com.tw www.transcend.com.tw GERMANY E-mail: vertrieb@transcend.de www.transcend.de HONG KONG E-mail: sales@transcend.com.hk www.transcendchina.com JAPAN E-mail: sales@transcend.co.jp www.transcend.jp THE NETHERLANDS E-mail: sales@transcend.nl www.transcend.nl United Kingdom E-mail: sales@transcend-uk.com www.transcend-uk.com Transcend Information Inc. 7 Ver 1.1