TMCM-341

MODULES F O R S T E P P E R M O T O R S M O D U LES TMCM- 3 41 3-Ax is Cont roll er for SPI Driv ers 1 0 mm M A IN CH A R AC T ER IS T IC S INFO The TMCM-341 is a triple axis stepper motor controller module for external power drivers with SPI interface (e.g. TMCM-035). With its very small size it is dedicated to embedded applications, where a compact solution is required. The board can be connected to a baseboard or customized electronics with a pin connector. The TMCM-341 comes with the PC based software development environment TMCL-IDE for the Trinamic Motion Control Language (TMCL). Using predefined TMCL high level com- ELECTRICAL D ATA SUPPORTED M OTORS/ D RIVERS INTERFACE • 5V DC logic supply voltage • two-phase bipolar motors using external SPI drivers (e.g. TMCM-035 or TMC249) • UART (RS-232, RS-485, up to 115200 bit/s) or CAN 2.0b host interface (up to 1Mbit/s) or USB (optional) • inputs for reference and stop switches • general purpose analog and digital I/Os • up to 64 times microstepping • memory for 2048 TMCL commands • ready for CANopen • automatic ramp generation in hardware • on the fly alteration of motion parameters (e.g. position, velocity, acceleration) • supports stallGuard™ option for sensor-less motor stall detection • full step frequencies up to 20kHz • dynamic current control • can be adapted to any SPI driver type • stand-alone operation using TMCL or remote controlled operation • PC-based application development software TMCL-IDE included FEATURES mands like „move to position“ or „constant rotation“ rapid and fast development of motion control applications is guaranteed. The TMCM-341 can be controlled via the serial UART interface (e.g. using a RS-232 or RS-485 level shifter), via CAN or optinal via USB. A user TMCL program can be stored in the on board EEPROM for stand-alone applications. An optional firmware allows to control the TMCM-341 via CANopen. The firmware of the module can be updated via the serial or the CAN interface. Communication traffic is kept very low since all time critical operations, e.g. ramp calculation, are performed on board. SOFTWARE TMCM-341 16 SPI Step Motor Step Motor Step Motor OTHER Driver e.g. TMCM-035 I/Os programmable CAN Motion Controller with TMC428 SPI Driver e.g. TMCM-035 SPI RS-232 or RS-485 5V DC • 68 pin connector carries all signals • RoHS compliant • size: 80 x 50 mm² UART TMCL Memory Driver 6 e.g. TMCM-035 REF-Switches OR DE R C O DE D E SC R I P T IO N TMCM-341 (-option) Related products: OP TI O NS 3-axis controller module with SPI out BB-301, BB-301S, TMCM-EVAL H V Horizontal pin connector (standard) Vertical pin connector (on request) www.trinamic.com – for detailed information and datasheets 82