TS4558CS

TS4558 Dual General Purpose Operational Amplifier Pin Assignment 1. Out A 2. Input A (-) 3. Input A (+) 4. Ground 5. Input B (+) 6. Input B (-) 7. Output B 8. Vcc Supply Voltage Range -18 V to 18V Unity Gain Bandwidth 3MHz Dual Channel Amplifier General Description The TS4558 is dual general purpose operational amplifier, and provide the high common-mode input voltage range and the absence of latch-up make these amplifiers ideal for voltage follower application. The devices are short circuit protected and the internal frequency compensation ensures stability without external components. The TS4558 is offered in 8 pin SOP-8 and DIP-8 package. Features Short circuit protection Wide common-mode and differential ranges No frequency compensation required Low power consumption No latch-up 3MHz unity gain bandwidth guaranteed Gain and phase match between amplifiers Block Diagram Applications DVD player Audio application Ordering Information Part No. TS4558CD TS4558CS Operating Temp. 0 ~ +70 oC Package DIP-8 SOP-8 Schematic (each amplifier) TS4558 1-5 2003/12 rev. A Absolute Maximum Rating Supply Voltage Supply Voltage Differential Input Voltage Input Voltage Package Thermal Impedance SOP-8 DIP-8 Operating Junction Temperature Range Storage Temperature Range Lead Temperature 1.6mm(1/16”) from case for 10Sec. TJ TSTG TLEAD Vcc + Vcc VIDR Vin θja 18 - 18 ±30 30 97 85 0 ~ +125 -65 ~ +150 260 o o o o V V V V C/W C C C Note: Maximum ratings are those values beyond which damage to the device may occur, and functional operation should be restricted to the recommended operating condition. Recommended Operating Conditions Supply Voltage Supply Voltage Vcc + Vcc 15 - 15 V V Electrical Characteristics (VCC = ±15V, Ta =25 C; unless otherwise specified.) o Parameter Input Offset Voltage Input Offset Current Input Bias Current Input Resistance Unity Gain Bandwidth Large-Signal Voltage Gain Output Voltage Swing Input Common-Mode Voltage Range Common-Mode Rejection Ratio Supply Voltage Rejection Ratio Slew Rate Supply Current Power Consumption Input Noise Voltage Source Current Symbol Vio Iio Iib Ri B1 Av Vom Vicr Test Conditions Rs ≤ 10kΩ Min Typ 0.5 20 150 Max ±6 ±200 500 Unit mV nA nA MΩ MHz V/mV V 0.3 5 3 RL ≥ 2kΩ, Vc = ±10V RL ≥ 10kΩ RL ≥ 2kΩ 20 ±12 ±10 ±12 300 ±14 ±14 ±13 V CMRR PSRR SR I ,I Pc Vn Isource + - Rs ≤ 10kΩ Rs ≤ 10kΩ RL = 2kΩ, Vin=10V, L=100pF 70 90 30 150 dB uV/V V/uS 5.6 170 3.5 mA mV uVrms mA 0.8 1.6 2.5 RL = ∞ Rs = 1kΩ, f = 30Hz~30KHz - 20 75 Sink Current Isink 20 mA Note 1: All characteristics are measured under open-loop conditions with zero common-mode input voltage, unless otherwise specified. TS4558 2-5 2003/12 rev. A Electrical Characteristics Curve TS4558 3-5 2003/12 rev. A Electrical Characteristics Curve TS4558 4-5 2003/12 rev. A SOP-8 Mechanical Drawing A SOP-8 DIMENSION DIM MILLIMETERS MIN 4.80 3.80 1.35 0.35 0.40 MAX 5.00 4.00 1.75 0.49 1.25 INCHES MIN 0.189 0.150 0.054 0.014 0.016 MAX 0.196 0.157 0.068 0.019 0.049 16 9 B P A B C D F G K M F 1 8 G C D K M R 1.27 (typ) 0.10 0.25 0o 5.80 0.25 7o 6.20 0.50 0.05 (typ) 0.004 0.009 0o 0.229 0.010 7o 0.244 0.019 P R DIP-8 Mechanical Drawing A SOP-8 DIMENSION MILLIMETERS INCHES MIN 9.07 6.22 3.18 MAX 9.32 6.48 4.45 MIN 0.357 0.245 0.125 MAX 0.367 0.255 0.135 8 5 DIM B 1 4 A B C D G J K L M L 0.35 0.55 2.54 (typ) 0.29 3.25 7.75 0.31 3.35 8.00 10o 0.019 0.020 0.10 (typ) 0.011 0.128 0.305 0.012 0.132 0.315 10o C K G D M J TS4558 5-5 2003/12 rev. A