TS5204_07

T S5 2 0 4 150mA Low Noise LDO Voltage Regulator SOT-23 Pin Definition: 1. Output 2. Input 3. Ground SOT-89 Pin Definition: 1. Output 2. Ground 3. Input General Description The TS5204 series is an efficient linear voltage regulator w ith ultra low noise output, very low dropout voltage (typically 20mV at light loads and 350mV at 150mA at 5V version) , and very low power consumption (600uA a t 100mA), providing high output current even w hen the application requires very low dropout voltage. The TS5204 series is included a precision voltage reference, error correction circuit, a current limited output driv er, over temperature shutdow n and revered battery protection. Features ● ● ● ● ● ● Ultra Low Noise Output Output Current up to 150mA (5V Version) Low Dropout Voltage Low Power Consumption Inter nal Current Limit Thermal Shutdown Protection Ordering Information Part No. Package Packi ng TS5204C Xxx RF SOT-23 3Kpcs / 7” Reel TS5204C Yxx RF SOT-89 1Kpcs / 7” Reel Note: W here xx denotes voltage option, available are 50=5.0V, 33=3.3V, 30=3.0V, 25=2.5V Contact factory for additional voltage options. Application ● ● ● ● ● ● ● Cellular Telephones Palmtops, Notebook Computers Battery Powered Equipment Consumer and Personal Electr onics SMPS Post Regulator and DC to DC Modules High-efficiency Linear Power Supplies Portable Application Typical Application Circuit VIN VOUT CIN 1uF COUT 2.2uF Absolute Maximum Rating (Note 1) Parameter Input Supply Voltage Power Dissipation (Note 2) Thermal R esistance SOT-23 SOT-89 Symbol VIN PD ӨJ A TJ TSTG o Limit - 20~ + 20 Inter nal limited 220 180 - 4 0 ~ +1 2 5 - 6 5 ~ +1 5 0 5 Unit V o C/W o o Operating Junction Temperature R ange Storage Temperature Range Lead Soldering Temperature (260 C) C C S Recommend Operating Rating (Note 2) Parameter Input Supply Voltage Symbol VIN Val ue +2.5 ~ +16 Unit V 1/6 Version: A07 T S5 2 0 4 150mA Low Noise LDO Voltage Regulator Electrical Specification (VIN=Vo+1V, Io=100uA, COUT=1uF, Vce≥2V, TJ = 25oC, unless otherwise specified.) Parameter Output Voltage Output Voltage Temp. Coefficient Line R egulation Load R egulation (Note 5) Conditi ons VIN=Vo + 1V VIN=Vo + 1V, Io= 120mA (Note 4) Vo+1V ≤ VIN ≤ 16V 0.1mA ≤ Io ≤ 120mA Io=100uA Io=50mA Io=120mA Io=150mA (5V version) Io=100uA Io=50mA Io=120mA Io=150mA (5V version) VOUT=0V At f=100Hz , Io=100uA, Io=50mA, COUT =2.2uF, Mi n 0.97| Vo| 0.96| Vo| -----------150 ---- Ty p VOUT 50 0.1 1 20 250 350 450 110 500 2600 3500 200 75 0.05 260 Max 1.03| Vo| 1.04| Vo| -0.5 2 -300 400 500 150 1000 3100 4200 ----- Unit V ppm / C % % o Dropout Voltage (Note 6) mV Ground Pin C urrent (Note 7) uA Output Current Limit Power Supply Rejec tion Ratio Thermal R egulation (Note 8) Output Noise mA dB %/W nV√Hz Note: 1. Exceeding the absolute maximum rating may damage the device. 2. The maximum allowable power dissipation at any Ta is Pd( max) = [TJ(MAX) - Ta] + ӨJA. Exceeding the maximum allowable power dissipation will result in excessive die temperature, and the r egulator will go into thermal shutdown. 3. The device is not guaranteed to func tion outside its operating rating. 4: Output voltage temperatur e coefficient is defined as the worst case voltage change divided by the total temperature r a nge. 5: R egulation is measured at constant junction temperature using low duty cycle pulse tes ting. Par ts are tested for load regulation in the load range from 1mA to 150mA (5V version) and 1mA to 120mA (VOUT