CHV2411AQDG

CHV2411aQDG RoHS COMPLIANT Fully Integrated HBT K-band VCO GaAs Monolithic Microwave IC In QFN package Description The CHV2411a-QDG is a monolithic multifunction for frequency generation. It integrates a X-band “push-push” oscillator with frequency control (VCO) thanks to basecollector diodes, used as varactors, a K-band buffer amplifiers and a divider by 8. The VCO is fully integrated on HBT process. All the active devices are internally self biased. The circuit is fully integrated on InGaP HBT process: 2µm emitter length, via holes through the substrate and high Q passive elements. The chip is delivered in a 24 Leads RoHS compliant QFN4x4 package. Main Features K-band VCO+K-band buffers+Prescalar/8 Fully integrated VCO (no need for external Resonator Low phase noise High temperature range High frequency stability On chip self biased devices Standard SMD package : 24L-QFN4x4 Main Characteristics Symbol F_out F_vco IF_out Pout PFI PN Parameter Specified output frequency range Oscillator frequency Output Intermediate frequency Output power at F_out Output power at Intermediate frequency (IF) SSB Phase Noise @ F_out @ 100 kHz 13 -3 Min 24 Typ 24.125 F_out/2 F_out/16 16 0 -90 -80 Max 24.25 Unit GHz GHz GHz dBm dBm dBc/Hz ESD Protection : Electrostatic discharge sensitive device. Observe handling precautions ! Ref. : DSCHV2411aQDG7254 - 11 Sept 07 1/10 Specifications subject to change without notice United Monolithic Semiconductors S.A.S. Route Départementale 128 - B.P.46 - 91401 Orsay Cedex France Tel. : +33 (0)1 69 33 03 08 - Fax : +33 (0)1 69 33 03 09 CHV2411aQDG Electrical Characteristics Full temperature range VCO & buffer Part Symbol F_out F_vco V_Tune Parameters Output Frequency range (Operating band) VCO frequency Voltage Tuning range Tuning sensitivity Frequency drift rate Harmonics ½ F_out Harmonics 3/2 F_out Harmonics 2 F_out SSB Phase Noise given @ F_out @ 100 KHz Main Output (RF_Out) VSWR Pulling into 2:1 VSWR for all phases Pushing @ within the V_tune range Output Power on RF_out port Positive supply current 13 Min 24 1 250 Typ F_out/2 400 5 K-band VCO Max 24.25 6 725 -20 -40 -20 -80 8 Unit GHz V MHz/V MHz/° C dBc dBc dBc dBc/Hz MHz MHz/V dBm mA H1 H3 H4 PN -90 2:1 P_out 16 140 250 19 170 Prescalar Part Symbol IF_out Parameters IF Output Frequency Output Power Positive supply current Prescalar Output (IF) VSWR Min -3 Typ F_out/16 0 80 2:1 Max Unit GHz dBm mA 110 General Symbol VB,V1,VB1,V2,V B2,VD +I (IB1+IB2+I1+I2) Top Parameters Positive supply voltage Total Positive supply current Operating temperature range -40 Min Typ 5 220 Max Unit V mA ° C 280 +100 All the parameters are specified between 1V and 6V of Tuning Voltage Remark : The minimum and maximum values take into account the spread due to the operating temperature and process spread. These performance has been obtained with the chip in QFN package assembled on the recommended boards (ref. 96348 B) described in this document. These performances are highly dependent on this environment. Absolute Maximum Ratings (1) Symbol V_tune +V +ID +IB1 / +IB2 +I1 / +I2 +IB Top Tstg Parameters Positive Tuning voltage Positive supply voltage Positive supply current (Prescalar) Positive supply current (buffers 2 & 3) Positive supply current (VCO+ buffer 1) Positive supply current (prescalar‘s buffer) Operating temperature range (2) Storage temperature range Values 10 6 120 50 / 55 35 / 50 15 -40 to +100 -55 to +125 Unit V V mA mA mA mA ° C ° C (1) Operation of this device above anyone of these parameters may cause permanent damage. Duration < 1s (2) temperature of the back side of the QFN package Ref. : DSCHV2411aQDG7254 - 11 Sept 07 2/10 Specifications subject to change without notice Route Départementale 128 , B.P.46 - 91401 ORSAY Cedex - FRANCE Tel.: +33 (0)1 69 33 03 08 - Fax : +33 (0)1 69 33 03 09 K-band VCO CHV2411aQDG Typical QFN measurements on board 95791 (QFN plan) Remark : The temperature mentioned below is taken at the back side of the QFN package. Sensitivity versus Vtune T=100°C T=100°C T=25° C T= - 40° C Output Frequency versus Vtune T= - 40° C T=25° C T=100°C T=100°C Ref. : DSCHV2411aQDG7254 - 11 Sept 07 3/10 Specifications subject to change without notice Route Départementale 128 , B.P.46 - 91401 ORSAY Cedex - FRANCE Tel.: +33 (0)1 69 33 03 08 - Fax : +33 (0)1 69 33 03 09 CHV2411aQDG K-band VCO Output Power @24GHz versus Vtune T=25° C T= - 40° C T=100°C T=100°C IF Output Power versus Vtune T=100°C T=100°C T=25° C T= - 40° C Ref. : DSCHV2411aQDG7254 - 11 Sept 07 4/10 Specifications subject to change without notice Route Départementale 128 , B.P.46 - 91401 ORSAY Cedex - FRANCE Tel.: +33 (0)1 69 33 03 08 - Fax : +33 (0)1 69 33 03 09 K-band VCO CHV2411aQDG Phase Noise vsversus Vtune Phase Noise Tuning Voltage @ 10 kHz from Carrier 10 T=25° C @ 100 kHz from Carrier Phase Noise vs Offset frequency from carrier Phase Noise versus Offset frequency fromcarrier 0,00 -10,00 -20,00 -30,00 -40,00 P hase N oise (dB z) c/H -50,00 -60,00 -70,00 -80,00 -90,00 -100,00 -110,00 -120,00 -130,00 -130,00 1,00 - 40°C Over Operating Tuning Range 100°C 10,00 100,00 1000,00 Offset Frequency from Carrier (kHz) Ref. : DSCHV2411aQDG7254 - 11 Sept 07 5/10 Specifications subject to change without notice Route Départementale 128 , B.P.46 - 91401 ORSAY Cedex - FRANCE Tel.: +33 (0)1 69 33 03 08 - Fax : +33 (0)1 69 33 03 09 CHV2411aQDG QFN Outline K-band VCO Ref. : DSCHV2411aQDG7254 - 11 Sept 07 6/10 Specifications subject to change without notice Route Départementale 128 , B.P.46 - 91401 ORSAY Cedex - FRANCE Tel.: +33 (0)1 69 33 03 08 - Fax : +33 (0)1 69 33 03 09 K-band VCO QFN Pin-out description Pin number 15,17 2 4 5,11,13,20,21,23 5 11,21 13 20 23 16 2 1,3,6,7,8,9,10,12,14,18, 19,22,24 Pin name GND P VT VB, V1, VB1, VB2,V2, VD VB V1,V2 VB1 VB2 VD RF P Nc F_out F_out/16 IF_out V_Tune +V Symbol Name Ground CHV2411aQDG Description IF output at 1.5 GHz Frequency Tuning Port Positive supply voltage Positive supply voltage of 12 GHz prescalar’s buffer Positive supply voltage of the VCO core+1 stage of the 24GHZ buffers nd rd Positive supply voltage of the 2 & 3 stages of the 24GHZ buffers Positive supply voltage of the 4 stages of the 24GHZ buffers Positive supply voltage of the Prescalar RF output at 24 GHz Prescalar output at 1.5 GHz Not connected th st External Components and bias configuration (recommended) Important: Need for a capacitor on the prescalar output port as a DC block (C2). Ref. : DSCHV2411aQDG7254 - 11 Sept 07 7/10 Specifications subject to change without notice Route Départementale 128 , B.P.46 - 91401 ORSAY Cedex - FRANCE Tel.: +33 (0)1 69 33 03 08 - Fax : +33 (0)1 69 33 03 09 CHV2411aQDG K-band VCO Recommended Test Fixture (Ref. 96348 B) for measurements over Temperature Range Ref. : DSCHV2411aQDG7254 - 11 Sept 07 8/10 Specifications subject to change without notice Route Départementale 128 , B.P.46 - 91401 ORSAY Cedex - FRANCE Tel.: +33 (0)1 69 33 03 08 - Fax : +33 (0)1 69 33 03 09 K-band VCO ESD sensitivity Norm MIL-STD-1686C ESD STM5.1-1998 Value HBM Class 1 (