LM324L-S14-R

UNISONIC TECHNOLOGIES CO., LTD LM324 QUAD OPERATIONAL AMPLIFIERS SOP-14 LINEAR INTEGRATED CIRCUIT DESCRIPTION The UTC LM324 consists of four independent, high gain internally frequency compensated operational amplifiers which are designed specifically to operated from a single power supply over a wide voltage range. Operation from split power supplies is also possible. Application areas include transducer amplifier, DC gain blocks and all the conventional OP amp circuits which now can be easily implemented in single power supply system. D IP-14 FEATURES *Internally frequency compensated for unity gain. *Large DC voltage gain :100dB. *Wide operating supply range (Vcc=3V~40V). *Input common-mode voltage includes ground. *Large output voltage swing: From 0V to Vcc-1.5V. *Power drain suitable for battery operation. TSSOP-14 ORDERING INFORMATION Ordering Number Lead Free Halogen-Free LM324L-D14-T LM324G-D14-T LM324L-P14-R LM324G-P14-R LM324L-S14-R LM324G-S14-R Package DIP-14 TSSOP-14 SOP-14 Packing Tube Tape Reel Tape Reel www.unisonic.com.tw Copyright © 2011 Unisonic Technologies Co., Ltd 1 of 6 QW-R105-006,J LM324 PIN DESCRIPTION LINEAR INTEGRATED CIRCUIT OUT 1 1 IN 1(-) 2 IN 1(+) 3 Vcc 4 IN 2(+) 5 IN 2(-) 6 OUT 2 14 OUT 4 13 IN 4(-) 12 IN 4(+) 11 GND 10 IN 3(+) 9 IN 3(-) 8 OUT 3 7 UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 2 of 6 QW-R105-006,J LM324 BLOCK DIAGRAM Only one section LINEAR INTEGRATED CIRCUIT Vcc IN (-) Output IN (+) GND UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 3 of 6 QW-R105-006,J LM324 ABSOLUTE MAXIMUM RATINGS PARAMETER Supply Voltage Differential Input Voltage Input Voltage SYMBOL VCC VI(DIFF) VIN LINEAR INTEGRATED CIRCUIT RATINGS ±20 UNIT V 40 V -0.3 ~ +40 V DIP-14 800 mW Power Dissipation PD SOP-14 580 mW TSSOP-14 460 mW Operating Temperature TOPR -20 ~ +85 °C Storage Temperature TSTG -40 ~ +150 °C Note: Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied. ELECTRICAL CHARACTERISTICS (VCC=5.0V, All voltage referenced to GND unless otherwise specified.) PARAMETER Input Offset Voltage Input Offset Current Input Bias Current Input Common Mode Voltage Power Supply Current Large Signal Voltage Gain Output Voltage Swing Common Mode Rejection Ratio Power Supply Rejection Ratio Channel Separation Short Circuit Current to Ground SYMBOL VI(OFF) II(OFF) II(BIAS) VI(CM) ICC GV VO(H) VO(L) CMRR PSRR CS ISC ISOURCE Output Current ISINK TEST CONDITIONS VCM=0V toVCC-1.5V VO(P)=1.4V, RS=0Ω MIN TYP MAX 7.0 50 250 VCC=30V RL=∞, VCC=30V VCC=5V VCC=15V, RL≧2KΩ VO(P)=1V ~ 11V VCC=30V, RL=2KΩ VCC=30V, RL=10KΩ VCC=5V, RL>10KΩ 0 VCC-1.5 1.0 0.7 100 28 5 75 100 120 40 40 13 45 VCC 3.0 1.2 UNIT mV nA nA V mA mA V/mV V V mV dB dB dB mA mA mA μA V 25 26 27 65 65 20 f=1KHZ ~ 20KHZ VI(+)=1V, VI(-)=0V VCC=15V, VO(P)=2V VI(+)=0V, VI(-)=1V VCC=15V, VO(P)=2V VI(+)=0V, VI(-)=1V VCC=15V, VO(P)=200mV 20 10 12 60 Differential Input Voltage VI(DIFF) UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 4 of 6 QW-R105-006,J LM324 TYPICAL CHARACTERISTICS Input Voltage Range 15 100 LINEAR INTEGRATED CIRCUIT Input Current Positive Input Voltgae,VIN (±V) Input Current (nA) 10 80 Vcc=+30V 60 Vcc=+15V 40 Vcc=+5V 20 Negative 5 0 0 5 0 10 15 -50 -25 0 25 50 75 100 Supply Voltage (± VDC) Temperature (¢XC) Supply Current 40 Vcc Ic 3 120 160 Voltage Gain RL=20kΩ RL=2kΩ Supply Current (mA) 2 Ta=0~+85¢XC Voltgae Gain (dB) 30 40 80 1 40 Ta=-40¢XC 0 0 10 20 0 0 7.5 15 22.5 30 Supply Voltage (V) Supply Voltage (V) Open Loop Frequency response 120 120 Common-Mode Rejection Ratio 100 0.1µF Vcc 100MΩ 100 80 Voltage Gain (dB) 80 Vcc/2 VCC=+7.5V VEE=-7.5V +7.5V 100kΩ 100Ω CMRR (dB) Vin 60 60 40 Vcc=15V 20 Vcc=30V 40 20 0 100Ω Vin 100kΩ -7.5V 0 10 0 10 1 10 2 10 3 10 4 5 10 6 10 10 7 10 2 10 3 10 4 10 5 10 6 Frequency (Hz) Frequency (Hz) UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 5 of 6 QW-R105-006,J LM324 TYPICAL CHARACTERISTICS(cont.) LINEAR INTEGRATED CIRCUIT Input Voltage (V) Output Voltage (V) UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw Output Refference VCC (V) Output Swing (VP-P) Output voltgae (V) 6 of 6 QW-R105-006,J