M54133AG-S16-R

UNISONIC TECHNOLOGIES CO., LTD M54133A Preliminary LINEAR INTEGRATED CIRCUIT EARTH LEAKAGE CURRENT DETECTOR  DESCRIPTION The UTC M54133A is a semiconductor integrated circuit developed for use in high-speed earth leakage breakers incorporating functions to protect against voltage surges and inverter noise.  FEATURES * Improvement of ability against unwanted tripping by lightning-surge and lightning impulse. Two times counting system adopted. * Improvement of ability against unwanted tripping by inverter-noise. Built-in operational amplifier (of low current dissipation) for active low-pass filter. Improved high-frequency, high harmonic superposition performance * Internal time delay function * An external capacitor is used to set the delay time. * High input sensitivity: VT=11.5mVrms Typ. * Low-current dissipation (at RIREF=180kΩ) In stand-by condition: IS=610μA Typ. * High stabilities design Adopt the circuits that is not affected by fluctuations of supply voltage/ambient temperature.  ORDERING INFORMATION Ordering Number Lead Free Halogen Free M54133AG-S16-R M54133AL-S16N-R M54133AG-S16N-R M54133AL-S16-R  Package Packing SOP-16 SOP-16N Tape Reel Tape Reel (1)Packing Type (1) R: Tape Reel (2)Package Type (2) S16: SOP-16, S16N: SOP-16N (3)Green Package (3) L: Lead Free, G: Halogen Free and Lead Free MARKING SOP-16 www.unisonic.com.tw Copyright © 2015 Unisonic Technologies Co., Ltd SOP-16N 1 of 7 QW-R122-009.c M54133A   Preliminary LINEAR INTEGRATED CIRCUIT PIN CONFIGURATION GND 1 16 VS IREF 2 15 OPI+ VCC 3 14 C1 OFFC 4 13 OPI- TRC1 5 12 C2 TRC2 6 11 OPAO DLYC 7 10 ILKI SCRT 8 9 VREF PIN DESCRIPTION PIN NO. 1 2 3 PIN NAME GND IREF VCC 4 OFFC 5 TRC1 6 7 8 9 10 11 TRC2 DLYC SCRT VREF ILKI OPAO 12 C2 13 OPI- 14 C1 15 16 OPI+ VS DESCRIPTION Grounding Pin for connecting resistor that sets constant current for internal circuits; approx. 1.3 V. Output pin of the internal constant-voltage circuit. Connect decoupling capacitor. Leakage input signal does not continue. Leakage is detected and SCR turn on. In these cases, this IC will be restored to the initial condition after a predetermined time. Connect capacitor that determines restore time. Pin for connecting capacitor that integrates signal output from discriminator of leak-signal input level. Pin for connecting capacitor to eliminate noise. Pin for connecting capacitor that sets delay time in case of using delay function. Output pin for driving a SCR. Pin for providing input reference level of leakage detection. About 2.4V appears. Other input pin of leakage detection. Output pin of operational amplifier. Pin for connecting capacitor that prevents abnormal oscillations. Connect capacitor across IC at pins 11 and 12. Negative input pins of operational amplifier Pin for connecting capacitor that prevents noise from causing malfunction. Connect capacitors across IC at pins 13 and 14 and across IC at pins 15 and 14. Positive input pins of operational amplifier Power supply UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 2 of 7 QW-R122-009.c M54133A  Preliminary LINEAR INTEGRATED CIRCUIT BLOCK DIAGRAM UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 3 of 7 QW-R122-009.c M54133A  Preliminary LINEAR INTEGRATED CIRCUIT ABSOLUTE MAXIMUM RATING (TA=25°C, unless otherwise noted) PARAMETER SYMBOL RATINGS UNIT Maximum Supply Voltage VS(MAX) 15 V Differential Input Voltage OPI+ to OPIVID -0.8~+0.8 V Supply Current IS 4 mA Differential Input Current OPI+ to OPIllOP -5~+5 mA Input Current VREF to GND llG 10 mA Power Dissipation PD 200 mW Operating Ambient Temperature TOPR -20~+85 °C Storage Temperature TSTG -55~+125 °C Note: Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied.  RECOMMENDED OPERATING CONDITIONS PARAMETER Supply Voltage Range  SYMBOL VS RATINGS 7 ~ 12 UNIT V ELECTRICAL CHARACTERISTICS (TA=25°C, VS =9V, unless otherwise noted) PARAMETER Power Supply Circuit Maximum Supply Voltage VCC-Pin Output Voltage Supply Current (In Standby) Supply Current (While Detecting Leakage) Supply Current (Immediately after Drive a SCR) Ambient Temperature Dependence of IS0 Operational Amplifier Differential Input Clamp Voltage OPOA-Pin “H” Output Current OPOA-Pin “L” Output Current Input Bias Current Voltage Gain Frequency Band Width Maximum Output Voltage Output Offset Voltage Leak Detector Circuit VREF-Pin Output Voltage VREF-GND Clamp Voltage DC Input Voltage of Leakage Detection ILKI-Pin Input Bias Current 3-ms Circuit TRC1 threshold voltage Accuracy of TRC1-Pin “H” Output Current Accuracy of TW1 pulse width Ambient Temperature Dependence of TW1 SYMBOL VS(MAX) VCC IS0 IS1 IS2 MIN IS=4mA IOH=-1mA 520 560 480 TA=-25~+85°C VIC IOH IOL IIC GV BW VO IIDC=±4mA f=1kHz -3dB VO(OFF) VO VRCL VI(ON) IIH VTH1 EIOH1 ETW1 UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw TEST CONDITIONS IOH=-200μA IRCL=5mA With respect to VREF VIN=VREF TYP MAX UNIT 13.9 5.2 610 650 570 -0.2 15 700 740 660 ±0.8 2.8 0.8 125 40 6 3.5 0 V mA mA nA dB kHz VPP mV 2.4 4.7 ±14.0 220 V V mVdc nA 2.4 VO=0V, IOH1=-7.6μA C=0.01μf, TW1=3ms TA=-20~+85°C V V μA μA μA %/°C -10 -15 +10 +15 0 V % % %/°C 4 of 7 QW-R122-009.c M54133A  Preliminary LINEAR INTEGRATED CIRCUIT ELECTRICAL CHARACTERISTICS (Cont.) PARAMETER 1-ms Circuit TRC2 Threshold Voltage Accuracy of TRC2-pin “H” Output Current Accuracy of TW2 Pulse Width SYMBOL VTH2 EIOH2 ETW2 SCRT-Pin “H” Output Current www.unisonic.com.tw 2.4 -10 -15 VTH EIOH ETW3 VO=0V, IOH=-7.6μA C=0.33μF, TW3=75ms -10 -30 VTH EIOH ETW4 VO=0V, IOH=-7.6μA C=1.0μF, TW4=300ms -10 -30 IOL=200μA VT VOL8 VS(OFF) IOHC IOHN IOHH UNISONIC TECHNOLOGIES CO., LTD MIN TYP MAX UNIT VO=0V, IOH2=-7.6μA C=0.0047μF, TW2=1.5ms TA=+25°C~+85°C TA=+25°C~-20°C TA=-20~+85°C 60Hz Ambient Temperature Dependence of VT Ambient Temperature Dependence of Tw2 Total AC Input Voltage of Leakage Detection Reset Circuit OFFC Threshold Voltage Accuracy of OFFC-pin “H” Output Current Accuracy of Reset Time Pulse Width Delay Circuit DLYC Threshold Voltage Accuracy of DLYC-pin “H” Output Current Accuracy of Delay Timer Pulse Width SCR Driver Circuit SCRT-Pin “L” Output Voltage Supply Voltage for IOH Hold TEST CONDITIONS +10 +15 -8.0 +2.0 0 11.5 2.4 +10 +30 V % % +10 +30 V % % 0.1 0.2 3.0 4.0 -100 -160 -50 -130 -33 -100 V V μA μA μA 2.4 VO=8V TA=-20°C TA=+20°C TA=+85°C V % % % % %/°C mVrms 5 of 7 QW-R122-009.c M54133A  WITHOUT DELAY FUNCTION  USING DELAY FUNCTION Preliminary UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw LINEAR INTEGRATED CIRCUIT 6 of 7 QW-R122-009.c M54133A  Preliminary LINEAR INTEGRATED CIRCUIT TYPICAL APPLICATION CIRCUIT ZCT AC-LINE 16 VS 15 OPI+ 14 13 C1 OPI- C2 12 OPAO 11 ILKI 10 VREF 9 AMP + UTC M54133A Power Supply Circuit GND 1 IREF VCC 2 Trip Coil OFFC 3 SCR Driver Leakage Detection Circuit 4 TRC1 TRC2 5 6 DLYC SCRT 7 8 SCR UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 7 of 7 QW-R122-009.c