TL062-D08-T

UNISONIC TECHNOLOGIES CO., LTD TL062 LOW POWER DUAL J-FET OPERATIONAL AMPLIFIER DESCRIPTION The UTC TL062 is a high speed J-FET input dual operational amplifier. It incorporates well matched, high voltage J-FET and bipolar transistors in a monolithic integrated circuit. The device features high slew rates, low input bias and offset currents, and low offset voltage temperature coefficient. DIP-8 LINEAR INTEGRATED CIRCUIT FEATURES * Very low power consumption * Wide common-mode (up to VCC+ ) and differential voltage range * Low input bias and offset current * Output short-circuit protection * High input impedance J-FET input stage * Internal frequency compensation * Latch up free operation * Typical supply current: 400μA SOP-8 Lead-free: TL062L Halogen-free: TL062G ORDERING INFORMATION Normal TL062-D08-T TL062-S08-R Ordering Number Lead Free Plating TL062L-D08-T TL062L-S08-R Halogen Free TL062G-D08-T TL062G-S08-R Package DIP-8 SOP-8 Packing Tube Tape Reel www.unisonic.com.tw Copyright © 2009 Unisonic Technologies Co., Ltd 1 of 8 QW-R105-003,C TL062 ■ PIN CONFIGURATIONS LINEAR INTEGRATED CIRCUIT OUTPUT 1 1 8 Vcc+ INVERTING INPUT 1 2 7 OUTPUT 2 NON-INVERTING INPUT 1 3 6 INVERTING INPUT 2 Vcc- 4 5 NON-INVERTING INPUT 2 UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 1 of 8 QW-R105-003,C TL062 ■ BLOCK DIAGRAM LINEAR INTEGRATED CIRCUIT UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 1 of 8 QW-R105-003,C TL062 ■ ABSOLUTE MAXIMUM RATINGS (Ta=25°C) LINEAR INTEGRATED CIRCUIT PARAMETER SYMBOL RATINGS UNIT Supply Voltage (note 2) VCC ±18 V Input Voltage (note 3) VIN ±15 V Differential Input Voltage (note 4) VI(DIFF) ±30 V Power Dissipation PD 680 mW Output Short-Circuit Duration (Note 5) Infinite Operating Temperature TOPR 0 ~ +70 °C Storage Temperature TSTG -65 ~ +150 °C Notes: 1. Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied. 2. All voltage values, except differential voltage, are with respect to the zero reference level (ground) of the supply voltages where the zero reference level is the midpoint between VCC- and VCC+. 3. The magnitude of the input voltage must never exceed the magnitude of the supply voltage or 15 volts, whichever is less. 4. Differential voltages are at the non-inverting input terminal with respect to the inverting input terminal. 5. The output may be shorted to ground or to either supply. Temperature and/or supply voltages must be limited to ensure that the dissipation rating is not exceeded. ELECTRICAL CHARACTERISTICS (VCC=±15V, Ta=25°C, unless otherwise specified) PARAMETER Input Offset Voltage Input Common Mode Voltage Output Voltage Swing Large Signal Voltage Gain SYMBOL VI(OFF) VI(CM) VO(SW) GV RL=10kΩ,CL=100pF RL=10Ω, VOUT=±10V Ta=25°C TMIN ≤Ta ≤TMAX Ta=25°C TMIN ≤Ta ≤TMAX TEST CONDITIONS Ta=25°C RS=50Ω TMIN ≤Ta ≤TMAX MIN MAX UNIT 15 mV 20 mV -12~+15 V 27 V V 6 V/mV V/mV TYP 3 ±11 20 20 3 3 Temperature Coefficient of Input ΔVI(OFF) RS=50Ω 10 μV/°C Offset Voltage Supply Current ICC Ta=25°C, no load, no signal 400 500 μA Ta=25°C 5 200 pA Input Offset Current* II(OFF) 5 nA TMIN ≤Ta ≤TMAX Ta=25°C 30 400 pA Input Bias Current* II(BIAS) 10 nA TMIN ≤Ta ≤TMAX Gain Bandwidth Product GBW Ta=25°C, RL=10kΩ, CL=100Pf 1 MHz Input Resistance RIN 1012 Ω Common Mode Rejection Ratio CMR RS=50Ω 70 76 dB Supply Voltage Rejection Ratio SVR RS=50Ω 70 95 dB Slew Rate SR VIN=10V, RL=10kΩ, CL=100pF, Gv=1 0.91 1.1 V/μs VO1 Channel Separation Gv=100, Ta=25°C 120 dB VO2 Total Power Consumption Ta=25°C, no load, no signal 6 7.5 mW Rise Time tR VIN=20mV, RL=10kΩ, CL=100pF, Gv=1 0.2 μs Overshoot Factor Kov VIN=20mV, RL=10kΩ, CL=100pF, Gv=1 10 % Equivalent Input Noise Voltage eN RS=100Ω, f=1KHz 42 Note: The Input bias currents of a FET-input operational amplifier are normal junction reverse currents, which are temperature sensitive. Pulse techniques must be used that will maintain the junction temperature as closes to the ambient temperature as possible. UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 2 of 8 QW-R105-003,C TL062 PARAMETER MEASUREMENT INFORMATION LINEAR INTEGRATED CIRCUIT UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 3 of 8 QW-R105-003,C TL062 ■ TYPICAL CHARACTERISTICS Maximum Peak-to-Peak Output Voltage vs. Supply Voltage Maximum Peak-to-peak Output Voltage (V) RL = 10kΩ 25 Ta = +25°C See figure 2 20 15 10 5 Maximum Peak-to-peak Output Voltage (V) 30 LINEAR INTEGRATED CIRCUIT Maximum Peak-to-Peak Output Voltage vs. Free Air Temp. 30 25 20 15 10 5 VCC = ±15V RL = 10kΩ See figure 2 -50 -25 0 25 50 75 100 125 0 2 4 6 8 10 12 14 16 0 -75 Supply Voltage, VCC (V) Free Air Temperature (°C) Maximum Peak-to-Peak Output Voltage vs. Load Resistance Maximum Peak-to-peak Output Voltage (V) VCC = ±15V Ta = +25°C Maximum Peak-to-peak Output Voltage (V) 30 25 20 15 10 5 0 100 200 30 25 20 Maximum Peak-to-Peak Output Voltage vs. Frequency RL = 10kΩ Ta = +25°C See figure 2 VCC = ±15V VCC = ±12V 15 VCC = ±5V 10 5 0 1k 10k 100k Frequency (Hz) 1M 10M VCC = ±2V 400 700 1k 2k 4k 7k 10k Load Resistance (kΩ) Differential Voltage Amplification vs. Free Air Temperature 10 Differential Voltage Amplification (V/mV) 7 Input Bias Current (nA) 10 100 Input Bias Current vs. Free Air Temperature VCC = ±15V 4 1 2 VCC = ±15V RL = 10kΩ 1 -75 -50 -25 0 25 50 75 100 125 0.1 0.01 -50 -25 0 25 50 75 100 125 Free Air Temperature (°C) Free Air Temperature (°C) UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 4 of 8 QW-R105-003,C TL062 TYPICAL CHARACTERISTICS(Cont.) LINEAR INTEGRATED CIRCUIT UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 5 of 8 QW-R105-003,C TL062 LINEAR INTEGRATED CIRCUIT UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 1 of 8 QW-R105-003,C