UNISONIC TECHNOLOGIES CO., LTD TL074
LOW NOISE QUAD J-FET OPERATIONAL AMPLIFIER
SOP-14
LINEAR INTEGRATED CIRCUIT
DESCRIPTION
The UTC TL074 is a high speed J-FET input quad operational amplifier. It incorporates well matched, high voltage J-FET and bipolar transistors in a monolithic integrated circuit. The device features high slew rates, low input bias and offset current, and low offset voltage temperature coefficient.
FEATURES
*Low power consumption *Wide common-mode (up to Vcc+ ) and differential voltage range *Low input bias and offset current *Low noise eN = 15nV / √ Hz(typ) *Output short-circuit protection *High input impedance J-FET input stage *Low harmonic distortion:0.01%(typ) *Internal frequency compensation *Latch up free operation *High slewrate:13V/μs(typ)
DIP-14
ORDERING INFORMATION
Ordering Number Lead Free Halogen Free TL074L-D14-T TL074G-D14-T TL074L-S14-R TL074G-S14-R Package DIP-14 SOP-14 Packing Tube Tape Reel
www.unisonic.com.tw Copyright © 2010 Unisonic Technologies Co., Ltd
1 of 10
QW-R105-005.F
TL074
PIN CONFIGURATIONS
LINEAR INTEGRATED CIRCUIT
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
2 of 10
QW-R105-005. F
TL074
SCHEMATIC DIAGRAM
VCC+
LINEAR INTEGRATED CIRCUIT
Non-inverting Input Non-inverting Input
100Ω
200Ω
Output
100Ω 30k
8.2k
1.3k
35k
1.3k
35k
100Ω
VCC-
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
3 of 10
QW-R105-005. F
TL074
ABSOLUTE MAXIMUM RATINGS (Ta=25°C)
LINEAR INTEGRATED CIRCUIT
PARAMETER SYMBOL RATING UNIT Supply Voltage (Note 1) VCC ±18 V Input Voltage (Note 2) VIN ±15 V Differential Input Voltage (Note 3) VI(DIFF) ±30 V Power Dissipation PD 680 mW Output Short-Circuit Duration (Note 4) Infinite Operating Temperature TOPR 0 ~ 70 °C Storage Temperature TSTG -65 ~ 150 °C Notes: 1. All voltage values, except differential voltage, are with respect to the zero reference level (ground) of the supply voltages where the zero reference level is the midpoint between Vcc- and Vcc+. 2. The magnitude of the input voltage must never exceed the magnitude of the supply voltage or 15 volts, whichever is less. 3. Differential voltages are at the non-inverting input terminal with respect to the inverting input terminal. 4. The output may be shorted to ground or to either supply. Temperature and/or supply voltages must be limited to ensure that the dissipation rating is not exceeded. 5. Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied.
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
4 of 10
QW-R105-005. F
TL074
ELECTRICAL CHARACTERISTICS
(Vcc=±15V, Ta=25°C, unless otherwise specified) PARAMETER Input Offset Voltage Temperature Coefficient of Input Offset Voltage Input Offset Current* Input Bias Current* Input Common Mode Voltage Output Voltage Swing SYMBOL VI(OFF) ΔVI(OFF) II(OFF) II(BIAS) VI(CM) VO(SW)
LINEAR INTEGRATED CIRCUIT
TEST CONDITIONS Rs=50Ω Rs=50Ω Ta=25°C TMIN≤Ta≤TMAX Ta=25°C TMIN≤Ta≤TMAX RL=2kΩ Ta=25°C RL=10kΩ RL=2kΩ TMIN≤Ta≤TMAX RL=10kΩ RL=10kΩ, Ta=25°C VOUT=±10V TMIN≤Ta≤T MAX RL=10kΩ, CL=100pF RS=50Ω RS=50Ω No Load Ta=25°C TMIN≤Ta≤T MAX Ta=25°C TMIN≤Ta≤T MAX Ta=25°C TMIN≤Ta≤T MAX Ta=25°C TMIN≤Ta≤TMAX
MIN
TYP 3
MAX 6 7
UNIT mV mV μV/°C
10 5 20 ±11 10 12 10 12 50 25 2 80 80 80 80 -12~+15 12 13.5 100 4 200 20
pA nA pA nA V V V V V V/mV V/mV MHz Ω dB dB dB dB mA mA dB mA mA V/μs μs % %
Large Signal Voltage Gain Gain Bandwidth Product Input Resistance Common Mode Rejection Ratio Supply Voltage Rejection Ratio Supply Current Channel Separation Output Short-circuit Current Slew Rate Rise Time Overshoot Factor Total Harmonic Distortion
GV GBW RIN CMR SVR ICC V01/V02 IO(SC) SR tR Kov THD
200 3 1012 86 86 1.4 120 40 13 0.1 10 0.01 2.5 2.5 60 60
Gv=100 Ta=25°C TMIN≤Ta≤T MAX VIN=10V, RL=2kΩ, CL=100pF, unity gain VIN=20mV, RL=2kΩ, CL=100pF, unity gain VIN=20mV, RL=2kΩ, CL=100pF, unity gain Gv=20dB, f=1kHz, RL=2kΩ, CL=100pF, VOUT=2Vpp)
10 10 8
Phase Margin 45 Deg. Equivalent Input Noise Voltage eN RS=100Ω, f=1KHz 15 *The Input bias currents are junction leakage currents, which approximately double for every 10°C increase in the junction temperature.
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
5 of 10
QW-R105-005. F
TL074
PARAMETER MEASUREMENT INFORMATION
Figure 1. Voltage Follow
LINEAR INTEGRATED CIRCUIT
Figure 2. Gain-of-10 Inverting Amplifier 10KΩ UTC TL074
e1 e0 CL = 100pF RL = 2KΩ
1KΩ
UTC TL074
e1
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
+
+
-
e0 RL CL = 100pF
6 of 10
QW-R105-005. F
TL074
TYPICAL APPLICATION
fO = 100kHz -
LINEAR INTEGRATED CIRCUIT
1MΩ
UTC TL074
Output A
1μF Input
UTC TL074
100kΩ
100kΩ 100kΩ
VCC+
100μF
100kΩ
UTC TL074
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
+ + + UTC TL074
-
+
Output B Output C 7 of 10
QW-R105-005. F
TL074
TYPICAL CHARACTERISTICS
LINEAR INTEGRATED CIRCUIT
Maximum Peak-To-Peak Output Voltage Versus Frequency Maximum Peak-To-Peak Output Voltage (V) ±15 ±12.5 ±10 ±7.5 Ta = -55 ±5 ±2.5 Tamb = +125 0 10K 40K 100K 400K 1M 4M 10M Frequency (Hz) RL = 2KΩ Ta = +25 See Figure 2 Maximum Peak-To-Peak Output Voltage (V) ±15 ±12.5 ±10 ±7.5 ±5 ±2.5 0
Maximum Peak-To-Peak Output Voltage Versus Free Air Temp RL = 10KΩ
RL = 2KΩ
Vcc = ±15V See Figure 2 -75 -50 -25 0 25 50 ) 75 100 125
Temperature (
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
8 of 10
QW-R105-005. F
TL074
TYPICAL CHARACTERISTICS(Cont.)
LINEAR INTEGRATED CIRCUIT
Supply Current Per Amplifier Versus Free Air Temperature 2.0 1.8 1.6 Supply Current (mA) 1.4 1.2 1.0 0.8 0.6 0.4 0.2 0 -75 -50 -25 0 25 50 75 100 125 Vcc = ±15V No signal No load Common Mode Rejection Ratio (dB) 89 88 87 86 85 84
Common Mode Rejection Ratio Versus Free Air Temperature
RL = 10KΩ Vcc = ±15V
83 -75
-50
-25
0
25
50
75
100 125
Temperature (℃)
Temperature (℃)
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
9 of 10
QW-R105-005. F
TL074
TYPICAL CHARACTERISTICS(Cont.)
LINEAR INTEGRATED CIRCUIT
Equivalent Input Noise Voltage (nV/VHz)
UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice.
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
Total Harmonic Distortion (%)
10 of 10
QW-R105-005. F
很抱歉,暂时无法提供与“TL074G-D14-T”相匹配的价格&库存,您可以联系我们找货
免费人工找货