UTCTS391B

UTC TS391/A/B LINEAR INTEGRATED CIRCUIT LOW POWER SINGLE VOLTAGE COMPARATOR DESCRIPTION The UTC TS391/A/B consist of a low power voltage comparator designed specifically to operate from a single supply over a wide range of voltages. Operation from split power supplies is also possible. This comparator also a unique characteristic in that the input common-mode voltage range includes ground even though operated from a single power supply voltage. 3 2 1 4 5 FEATURES *Wide single supply voltage range or dual supplies +2V to *+34V or ±1V to ±18V *Very low supply current (0.2mA) independent of supply voltage (1 mW /comparator at +5V) *Low input bias current: 25nA typ. *Low input offset current: ±5nA typ. *Low input offset voltage: ±1mV typ *Input common-mode voltage range includes ground. *Low output saturation voltage: 250mV typ.(Io=4mA). *Differential input voltage range equal to the supply *voltage. SOT-25 MARKING Part Number TS391 TS391A TS391B Marking S1 SA SB PIN CONNECTIONS (top view) TS391 IN(-) 3 GND 2 Output 1 IN(-) 3 TS391A GND 2 IN(+) 1 - + + 4 IN(+) 5 Vcc 4 Output 5 Vcc UTC UNISONIC TECHNOLOGIES CO. LTD 1 QW-R104-003,B UTC TS391/A/B TS391B IN(+) 3 GND 2 Output 1 LINEAR INTEGRATED CIRCUIT + - 4 IN(-) 5 Vcc Vcc+ BLOCK DIAGRAM 3.5μA 100μA 3.5μA 100μA IN(+) GND IN(-) GND Output GND ABSOLUTE MAXIMUM RATINGS PARAMETER Supply Voltage Differential Input Voltage Input Voltage Output Short-circuit to Ground 1) Power Dissipation 2) Operating Free Air Temperature Range SYMBOL Vcc Vid Vi Pd Topr RATING ±18 or 36 ±36 -0.3 ~ +36 Infinite 500 -40 ~ +125 UNIT V V V mW ℃ -65 ~ +150 ℃ Storage Temperature Range Tstg 1. Short-circuit from the output to Vcc can cause excessive heating and eventual destruction.The maximum output current is approwimately 20mA,independent of the magnitude of Vcc. 2. Tj=150℃, Tamb=25℃ with Rthja=250℃/W for SOT25 Package. UTC UNISONIC TECHNOLOGIES CO. LTD 2 QW-R104-003,B UTC TS391/A/B Input Offset Voltage 1) Input Bias Current 2) LINEAR INTEGRATED CIRCUIT TEST CONDITIONS Tamb=+25℃ Tmin.≤Tamb≤Tmax. Tamb=+25℃ Tmin.≤Tamb≤Tmax. Tamb=+25℃ Tmin.≤Tamb≤Tmax. Vcc=15V,RL=15k,Vo=1 to 11V Vcc=5V,no load Vcc=30V,no load Tamb=+25℃ Tmin.≤Tamb≤Tmax. 50 ELECTRICAL CHARACTERISTICS Vcc=5.0V, All voltage referenced to GND ,Tamb=25°C(unless otherwise specified) PARAMETER SYMBOL Vio Iib Iio Gv Icc Vicm Vid Isink VOL MIN TYP 1 25 5 200 0.2 0.5 MAX 5 9 250 400 50 150 0.5 1.25 Vcc -1.5 Vcc -2 UNITS mV nA nA V/mV mA mV mV mA Input Offset Current Large Signal Voltage Gain Supply Current Input Common Mode Voltage Range 3) Differential Input Voltage 4) 0 0 Vcc Vid=-1V,Vo=1.5V Vid=1V,Vcc=Vo=30V Tamb=+25℃ Tmin.≤Tamb≤Tmax. Vid=1V,Vcc=Vo=30V Tamb=+25℃ Tmin.≤Tamb≤Tmax. RL=5.1kΩ to Vcc 5) Output sink current Low Level Output Voltage 6 16 250 400 700 mV High Level Output Current IOH Response Time Large Signal Response Time tre trel 0.1 1 1.3 300 nA μA μs ns Vi=TTL,Vref=+1.4V,RL=5.1kΩ to Vcc 1.At output switch point, Vo=1.4V,Rs=0Ω with Vcc from 5V to 30V and over the full input common-mode range(0V to Vcc 1.5V). 2.The direction of the input current is out of the IC due to the PN P input stage. This current is essentially constant, independent of the state of the output, so no loading charge exists on the reference or input lines. 3.The input common-mode voltage of either input signal voltage should not be allowed to go negative by more than 0.3V.The upper end of the common-mode voltage range is Vcc+ -1.5V,but either or both inputs can go to +30V without damage. 4.Positive excursions of input voltage may exceed the power supply level. As long as the other voltage remains within the common-mode range the comparator will provide a proper output state. The low input voltage state must not be less than –0.3V(or 0.3V below the negative power supply, if used). 5.The response time specified is for a 100mV input step with 5mV overdrive. For larger overdrive signals 300ns can be obtained. UTC UNISONIC TECHNOLOGIES CO. LTD 3 QW-R104-003,B UTC TS391/A/B LINEAR INTEGRATED CIRCUIT Response time for various input overdrives - negative transition INPUT VOLTAGE (mV) OUTPUT VOLTAGE (V) TYPICAL PERFORMANCE CHARACTERISTICS Supply current vs supply voltage 0.5 0.4 0.3 0.2 0.1 0 0 Tamb=-55℃ Tamb=0℃ Tabm=+25℃ Tamb=+70℃ Tamb=+125℃ R=∞ 6 5 4 3 2 1 0 0 -50 -100 0 Input overdrive:5mV +5V 20mV eI + 100mV 5.1kΩ eo SUPPLY CURRENT (mA) Tamb=+25℃ 0.5 1 TIME(μ S) Response time for various input overdrives - positive transition 1.5 2 10 20 30 SUPPLY VOLTAGE (V) 40 Input current vs supply voltage INPUT VOLTAGE (mV) OUTPUT VOLTAGE (V) 80 Tamb=-55℃ Tamb=0℃ 40 Tamb=+25℃ 6 5 4 3 2 1 0 100 50 0 0 Input overdrive:100mV INPUT CURRENT(nA) 60 5mV 20mV +5V 20 Tamb=+125℃ Tamb=+25℃ eI Tamb=+70℃ 40 + 5.1kΩ eo 0 10 30 20 SUPPLY VOLTAGE (V) Output saturation voltage vs output current Out of saturation 0.5 1 TIME(μS) 1.5 2 10 SATURATION VOLTAGE (V) 1 10 0 Tamb=+125℃ 10 -1 Tamb=+55℃ 10 -2 Tamb=+25℃ 10 -2 10 -2 10 -1 10 10 Output sink current (mA) 0 1 10 2 UTC UNISONIC TECHNOLOGIES CO. LTD 4 QW-R104-003,B UTC TS391/A/B LINEAR INTEGRATED CIRCUIT UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UTC UNISONIC TECHNOLOGIES CO. LTD 5 QW-R104-003,B