C2260A1-0238
TCXO
Nominal frequency (f0) Frequency stabilities
Parameter Frequency stability Operating temp. range
12.8 MHz
Over all (df/f0) -4.6 to 4.6 ppm Additional information Holdover stability @temp. stab. -20..+70°C, supply voltage + 24h aging: 2.97 V Enable Function Pin 1 high open low
@ 10 to 90 %Vout @ 90 to 10 %Vout @ 1.65 V
output Pin 3 data data no data
Supply voltage
Parameter Value Condition
Supply voltage (Vs) Current consumption steady state
3.3 V ± 5 % < 4 mA
@ Vsnom & 25 °C
Additional Parameters
Parameter Typ. Max. Condition
Phase Noise
-90 -115 -127 -137 -140
Value
dBc/Hz@10Hz dBc/Hz@100Hz dBc/Hz@1000Hz dBc/Hz@10kHz dBc/Hz@100kHz
Condition
Parameter
Additional information This SMD oscillator is designed only for pick and place/reflow soldering process. Manual soldering may damage the part and therefore not recommended for the mounting of this oscillator. Processing & Packing handling&processing note
Additional environmental conditions
Vibration
IEC 60068-2-6, Test Fc
Shock
IEC 60068-2-27, Test Ea
Sealing test A
nicht dicht (not hermetically sealed)
Solderability
DIN IEC 68 T2-20 (Ta) 100% RoHS 6 compliant
Solvent resistance
EN 60068-2-45, Test xA washable device
Vectron International • Product Specifications C2260A1-0238
www.vectron.com
modified 2011-03-09 Index : 5
printed 2011-06-03 • page 1 of 4
C2260A1-0238
TCXO
Absolute Maximum Ratings
Parameter Min Typ Max Units Condition
Operable temperature range Storage temperature range
-40 -55
85 125
°C °C
Enclosure
Type G298 Height 1.8 mm
all units in mm Pin Connections Pin 1: Tristate control Pin 2: GND (Case) Pin 3: RF-Output Pin 4: Vs (supply voltage) Marking 2A-238 12M800 *VAYYWW * pin-1 marking
Vectron International • Product Specifications C2260A1-0238
www.vectron.com
modified 2011-03-09 Index : 5
printed 2011-06-03 • page 2 of 4
C2260A1-0238
TCXO
Reflow profile
Profile Feature
Pb-Free Assembly/Sn-Pb Assembly
Average ramp-up rate (TL to Tp) 3°C/second max. Preheat -Temperature Min (Tsmin) 150°c -Temperature Min (Tsmax) 200°c -Time (min to max) (ts) 60-180 seconds Tsmax to TL - Ramp-up Rate 3°C/second max. Time maintainted above - Temperature (TL) 217°C - Time (tL) 60-150 seconds Peak Temperature (Tp) max 260°C Time within 5°C of actual Peak Temperature (tp) 20-40 seconds Ramp-down Rate 6°C/second max. Time 25°C to Peak Temperature 8 minutes max. Note: All temperatures refer to topside of the package, measured on the package body surface. Additional Information This SMD oscillator has been designed for pick and place reflow soldering.
Vectron International • Product Specifications C2260A1-0238
www.vectron.com
modified 2011-03-09 Index : 5
printed 2011-06-03 • page 3 of 4
C2260A1-0238
TCXO
Standard shipping method
Tape width W [mm]
Quantity per meter
Quantity per reel
P [mm]
A [mm]
B [mm]
K [mm]
16
125
750
8
5.4
7.4
2.7
Notes: Unless otherwise stated all values are valid after warm-up time and refer to typical conditions for supply voltage, frequency control voltage, load, temperature (25°C). Subject to technical modification.
Vectron International • Product Specifications C2260A1-0238
www.vectron.com
modified 2011-03-09 Index : 5
printed 2011-06-03 • page 4 of 4
很抱歉,暂时无法提供与“C2260A1-0238”相匹配的价格&库存,您可以联系我们找货
免费人工找货