RGR5HYA17C10

Product Data Sheet SATCOM / "1 ppm Forever" Temperature Compensated Crystal Oscillators Features Frequency from 0.5 MHz to 160 MHz Stability to ± 0.1 ppm 0 to 50˚C +5Vdc to +24Vdc supply voltage options Sinewave, HCMOS, TTL options Over 500,000 units produced Applications SATCOM Base Stations and Picocells LMDS, WLL, SONET, Stratum 3 Description The SATCOM and "1 ppm Forever" series of Temperature Compensated Crystal Oscillators (TCXO's) are available in frequencies from 0.5 MHz to 160 MHz. These series offer performance for short term stability, phase noise, G sensitivity, aging and temperature stability normally only associated with Oven Controlled Crystal Oscillators (OCXO's), while consuming typically < 20 mA. With over 500,000 units produced, Vectron International has more experience with this type of TCXO then the rest of the industry combined. 1 SATCOM / "1 ppm Forever" TCXO Performance Characteristics Parameter Output Options: Characteristics AC = ACMOS 0.5 to 160 MHz HC = HCMOS 0.5 to 160 MHz TD = 10 TTL 0.5 to 160 MHz RG = 0 dBm 50 ohm 3.0 to 30 MHz RC = +7.0 dBm 50 ohm 3.0 to 90 MHz A17 = ± 0.1 ppm B37 = ± 0.3 ppm C57 = ± 0.5 ppm D16 = ± 1.0 ppm EA6 = ± 1.5 ppm AC HC TD RG RC = = = = = +12 Vdc ± 5% +12 Vdc ± 5% +12 Vdc ± 5% +5 Vdc ± 5% +12 Vdc ± 5% 0˚C 0˚C -20˚C -40˚C -55˚C to to to to to +50˚C +70˚C +70˚C +85˚C +85˚C Stability Options: (Other stability options are available) Supply Voltage: (Other voltage options are available) Allan Variance (typical): Aging (at 10MHz): ± 1 x 10-10 at tau = 1 sec "1 ppm Forever" SATCOM -110 dBc / Hz -135 dBc / Hz -150 dBc / Hz -155 dbc / Hz (SATCOM) < 0.2 ppm / 1st year < 0.7 ppm / 10 years < 0.5 ppm / 1st year < 2.0 ppm / 10 years @ 10 Hz offset @ 100 Hz offset @ 1 kHz offset @ 100 kHz offset RCR7HYA17C 10.00 MHz RGR5HXB37C 15.00 MHz Phase Noise (typical): 10 MHz, RC option Typical P/N: ("1 ppm Forever") HY is predetermined, HX is for "1 ppm Forever" max temp range -20 to +70 Note: Not all stabilities are available with all options. Vectron International does not recommend wave soldering, IR reflow or other elevated temperature processing without consulting the factory. For AC, HC and TD outputs with frequencies above 30 MHz a low phase noise PLL multiplier will be used. Please inform the factory of your phase noise requirements. Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • Fax: 1-888-FAX-VECTRON 2 SATCOM / "1 ppm Forever" TCXO 38.887 max (1.531) Pin 1 2 3 4 5 Function Output +Vdd Gnd, Case Gnd / V tune Gnd 3 12.70 (0.50) 5.842 min (0.23) 13.462 (0.53) max .508 (0.02) 25.4 (1.000) 12.70 (0.500) 0.762 DIA. 5 PLACES (.030) 4 20.320 (0.800) Frequency Adjust: Option Specification HY ± 3 ppm min. via external voltage, 0 to +5 Vdc HX NONE 12.70 38.887 (1.531) max (0.500) C L 25.4 (1.000) 2 5 1 10.160 6.350 (0.400) (0.250) C L R5 PACKAGE mm (in.) Pin 1 2 3 4 5 Function Output +Vdd Gnd, Case Gnd Gnd 3 .508 (0.20) 38.887 max (1.531) FREQUENCY ADJUST ACCESS 13.462 max (0.53) 5.842 min (0.23) 1.270 (0.05) 25.4 (1.000) 12.70 (0.500) .508 (0.02) 0.762 DIA. 5 PLACES (.030) 4 Frequency Adjust: Option Specification HY & HX ± 3 ppm min. via internal mechanical adjust 38.887 max 12.70 (0.500) (1.531) C L 20.320 (0.800) 5 2 1 25.4 (1.000) 10.160 6.350 (0.400) (0.250) C L R7 PACKAGE Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • Fax: 1-888-FAX-VECTRON 3 SATCOM / "1 ppm Forever" TCXO 50.8 ± .762 (2.00 ± .03) FREQUENCY ADJUST ACCESS Pin 1 2 3 4 5 Function Output +Vdd Gnd, Case Gnd Gnd 25.4 (1.000) C L 12.70 (0.500) 3 4 12.192 (0.48) .508 (0.02) 2.54 (0.10) 19.812 max (0.78) 5.842 min (0.23) 1.270 (0.05) C L 0.762 DIA. 5 PLACES (.030) 50.8 ± .762 (2.00 ± .03) 20.320 (0.800) 10.160 (0.400) Frequency Adjust: Option Specification HY & HX ± 3 ppm min. via internal mechanical adjust 2 5 1 6.350 (0.250) 12.70 (0.500) 25.4 (1.000) mm (in.) S5 PACKAGE Pin 1 2 3 4 5 Function Output +Vdd Gnd, Case Gnd / V tune .508 (0.02) 50.8 ± .762 (2.00 ± .03) 19.812 max (0.78) 5.842 min (0.23) C L Gnd 0.762 DIA. 5 PLACES (.030) 50.8 ± .762 (2.00 ± .03) Frequency Adjust: Option Specification HY ± 3 ppm min. via external voltage, 0 to +5 Vdc HX NONE 25.4 (1.000) C L 12.70 (0.500) 3 4 5 1 2 20.320 (0.800) 10.160 (0.400) 6.350 (0.250) 12.70 (0.500) 25.4 (1.000) S7 PACKAGE Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • Fax: 1-888-FAX-VECTRON 4 SATCOM / "1 ppm Forever" TCXO Output Option Output Voh min. Voh max. Load (typical) Duty Cycle Rise and Fall AC ACMOS +4.5 Vdc +0.5 Vdc 100 k ohm // 10 pF 50% ± 10% 3 nS max. HC HCMOS +4.5 Vdc +0.5 Vdc 100 k ohm // 10 pF 50% ± 10% 5 nS max. TD 10 TTL +2.4 Vdc +0.5 Vdc 10 TTL 50% ± 10% 10 nS max. Output Option Output Level Load Harmonics / Sub Other Spurious RG Sinewave 0 dBm to +6 dBm 50 ohm -20 dBc max. -60 dBc max. RC Sinewave +7.0 dBm to +13 dBm 50 ohm -20 dBc max. -60 dBc max. Test Loads: Vdd .01µF TEK 2465B 50Ω TEK 2465B Vdd DUT OUT 50Ω COAX .01µF TEK P6137 PROBE Vdd 50 Ohm Sinewave (RG & RC) TEK 2465B DUT OUT D1 R2 270Ω R1 6k D2 D3 D4 C1 .01µF Vdd .01µF TEK P6137 PROBE DUT OUT Standard TTL (TD) CL RL Standard CMOS (AC & HC) Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • Fax: 1-888-FAX-VECTRON 5 SATCOM / "1 ppm Forever" TCXO Specifying Temperature Stability: RC/R7/HY/A17/C A17 A = X = Temperature Range 1 = N1 = Stability Multiplier 7 = N2 = Stability Scale N1 Stability Multiplier N1 = 1 to 9 and A,B & C 1 = ± 1.0 2 = ± 2.0 3 = ± 3.0 4 = ± 4.0 5 = ± 5.0 6 = ± 6.0 7 = ± 7.0 8 = ± 8.0 9 = ± 9.0 A = ± 1.5 B = ± 2.5 C = ± 3.5 X Temp Range A B C D E = 0 to +50˚C = 0 to +70˚C = -20 to +70˚C = -40 to +85˚C = -55 to +85˚C N2 Stability Scale 10 to the -N2 power 5 = 10-5 = 10 ppm 6 = 10-6 = 7 = 10-7 = 1 ppm 0.1 ppm 8 = 10-8 = 0.01 ppm Examples: XN1N2 A17 B37 C57 D16 EA6 = = = = = X , N1 x N2 = = = = = X , N1N2 ± 0.1 ppm ± 0.3 ppm ± 0.5 ppm ± 1.0 ppm ± 1.5 ppm ± 1 x 10-7 ± 3 x 10-7 -20 to +70˚C, ± 5 x 10-7 -40 to +85˚C, ± 1 x 10-6 -55 to +85˚C, ± 1.5 x 10-6 0 to +50˚C, 0 to +70˚C, 0 to +50˚C, 0 to +70˚C, -20 to +70˚C, -40 to +85˚C, -55 to +85˚C, Note: Temperature stabilities listed on the website are for the best possible stability in that series. Next to quantity, Frequency vs. Temperature is the highest cost multiplier. Please do not over specify temperature stability as we will 100% test units to your requirements. The temperature ranges listed above are industry standards. However, if for example your requirements were for -33 to +55˚C please let us know, by choosing -40 to +85˚C arbitrarily you will be paying more than is required. Custom stabilities are always welcome and recommended. We do not charge extra for custom temperature ranges or stabilities. Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • Fax: 1-888-FAX-VECTRON 6 SATCOM / "1 ppm Forever" TCXO How to Order For HY Option: RC R7 HY A17 C 10.000 MHz Frequency (0.5 to 160 MHz) Commercial Screening (Predetermined) Stability (See "Specifying Temperature Stability") HY - For SATCOM type applications Package Option (R5, R7, S5, S7) Output Option (AC, HC, TD, RG, RC) For HX Option: RG R5 HX B37 C 15.000 MHz Frequency (0.5 to 160 MHz) Commercial Screening (Predetermined) Stability (See "Specifying Temperature Stability") (max. temp. range -20 to +70˚C) HX - For "1 ppm Forever" Package Option (R5, R7, S5, S7) Output Option (AC, HC, TD, RG, RC) Visit Our Website at www.vectron.com For additional information please contact: USA: Vectron International • 267 Lowell Road, Hudson, NH 03051 . . . . . Tel: 1-88-VECTRON-1 • Fax: 1-888-FAX-VECTRON EUROPE: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Tel: 49 (0) 3328 4784 17 • Fax: 49 (0) 3328 4784 30 ASIA: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Tel: +86 21 28909740 / 41 /42 • Fax: +86 21 28909240 / 2890999 www.vectron.com Vectron International reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information 7 Rev. A 042502, 081902