SI7423DN

SPICE Device Model Si7423DN Vishay Siliconix P-Channel 30-V (D-S) MOSFET CHARACTERISTICS • P-Channel Vertical DMOS • Macro Model (Subcircuit Model) • Level 3 MOS • Apply for both Linear and Switching Application • Accurate over the −55 to 125°C Temperature Range • Model the Gate Charge, Transient, and Diode Reverse Recovery Characteristics DESCRIPTION The attached spice model describes the typical electrical characteristics of the p-channel vertical DMOS. The subcircuit model is extracted and optimized over the −55 to 125°C temperature ranges under the pulsed 0 to 10V gate drive. The saturated output impedance is best fit at the gate bias near the threshold voltage. A novel gate-to-drain feedback capacitance network is used to model the gate charge characteristics while avoiding convergence difficulties of the switched Cgd model. All model parameter values are optimized to provide a best fit to the measured electrical data and are not intended as an exact physical interpretation of the device. SUBCIRCUIT MODEL SCHEMATIC This document is intended as a SPICE modeling guideline and does not constitute a commercial product data sheet. Designers should refer to the appropriate data sheet of the same number for guaranteed specification limits. Document Number: 72636 24-May-04 www.vishay.com 1 SPICE Device Model Si7423DN Vishay Siliconix SPECIFICATIONS (TJ = 25°C UNLESS OTHERWISE NOTED) Parameter Static Gate Threshold Voltage On-State Drain Current b Symbol Test Conditions Simulated Data 1.8 60 0.014 0.023 29 −0.83 Measured Data Unit VGS(th) ID(on) rDS(on) gfs VSD VDS = VGS, ID = −250 µA VDS = −5 V, VGS = −10 V VGS = −10 V, ID = −11.7 A VGS = −4.5 V, ID = −9 A VDS = −15 V, ID = −11.7 A IS = −3.2 A, VGS = 0 V V A 0.014 0.023 29 −0.76 Ω S V Drain-Source On-State Resistanceb Forward Transconductanceb Diode Forward Voltageb Dynamica Total Gate Charge Gate-Source Charge Gate-Drain Charge Turn-On Delay Time Rise Time Turn-Off Delay Time Fall Time Qg Qgs Qgd td(on) tr td(off) tf VDD = −15 V, RL = 15 Ω ID ≅ −1 A, VGEN = −10 V, RG = 6 Ω VDS = −15 V, VGS = −10 V, ID = −11.7 A 34 5.8 9.6 15 11 72 25 37.5 5.8 9.6 11 10 74 50 ns nC Notes a. Guaranteed by design, not subject to production testing. b. Pulse test; pulse width ≤ 300 µs, duty cycle ≤ 2%. www.vishay.com 2 Document Number: 72636 24-May-04 SPICE Device Model Si7423DN Vishay Siliconix COMPARISON OF MODEL WITH MEASURED DATA (TJ=25°C UNLESS OTHERWISE NOTED) Document Number: 72636 24-May-04 www.vishay.com 3