W3DG6464V-D1

White Electronic Designs 512MB- 64Mx64 SDRAM, UNBUFFERED W/PLL FEATURES PC100 and PC133 compatible Burst Mode Operation Auto and Self Refresh capability LVTTL compatible inputs and outputs Serial Presence Detect with EEPROM Fully synchronous: All signals are registered on the positive edge of the system clock Programmable Burst Lengths: 1, 2, 4, 8 or Full Page 3.3V ± 0.3V Power Supply 144 Pin SO-DIMM JEDEC W3DG6464V-D1 DESCRIPTION The W3DG6464V is a 64Mx64 synchronous DRAM module which consists of eight 64Mx8 stack SDRAM components in TSOP II package, and one 2Kb EEPROM in an 8 pin TSSOP package for Serial Presence Detect which are mounted on a 144 pin SO-DIMM multilayer FR4 Substrate. *This product is subject to change without notice. PIN CONFIGURATIONS (FRONT SIDE/BACK SIDE) PINOUT PIN 1 3 5 7 9 11 13 15 17 19 21 23 25 27 29 31 33 35 37 39 41 43 45 47 FRONT VSS DQ0 DQ1 DQ2 DQ3 VCC DQ4 DQ5 DQ6 DQ7 VSS DQM0 DQM1 VCC A0 A1 A2 VSS DQ8 DQ9 DQ10 DQ11 VCC DQ12 PIN 2 4 6 8 10 12 14 16 18 20 22 24 26 28 30 32 34 36 38 40 42 44 46 48 BACK VSS DQ32 DQ33 DQ34 DQ35 VCC DQ36 DQ37 DQ38 DQ39 VSS DQM4 DQM5 VCC A3 A4 A5 VSS DQ40 DQ41 DQ42 DQ43 VCC DQ44 PIN 49 51 53 55 57 59 61 63 65 67 69 71 73 75 77 79 81 83 85 87 89 91 93 95 FRONT DQ13 DQ14 DQ15 VSS NC NC CK0 VCC RAS# WE# CS0# CS1# NC VSS NC NC VCC DQ16 DQ17 DQ18 DQ19 VSS DQ20 DQ21 PIN 50 52 54 56 58 60 62 64 66 68 70 72 74 76 78 80 82 84 86 88 90 92 94 96 BACK DQ45 DQ46 DQ47 VSS NC NC CKE0 VCC CAS# CKE1 A12 NC NC VSS NC NC VCC DQ48 DQ49 DQ50 DQ51 VSS DQ52 DQ53 PIN 97 99 101 103 105 107 109 111 113 115 117 119 121 123 125 127 129 131 133 135 137 139 141 143 BACK DQ22 DQ23 VCC A6 A8 VSS A9 A10 VCC DQMB2 DQMB3 VSS DQ24 DQ25 DQ26 DQ27 VCC DQ28 DQ29 DQ30 DQ31 VSS SDA VCC PIN 98 100 102 104 106 108 110 112 114 116 118 120 122 124 126 128 130 132 134 136 138 140 142 144 BACK DQ54 DQ55 VCC A7 BA0 VSS BA1 A11 VCC DQMB6 DQMB7 VSS DQ56 DQ57 DQ58 DQ59 VCC DQ60 DQ61 DQ62 DQ63 VSS SCL VCC PIN NAMES A0 – A12 BA0-1 DQ0-63 CK0 CKE0, CKE1 CS0#, CS1# RAS# CAS# WE# DQM0-7 VCC VSS SDA SCL DNU NC Address Input (Multiplexed) Select Bank Data Input/Output Clock Input Clock Enable Input Chip Select Input Row Address Strobe Column Address Strobe Write Enable DQM Power Supply (3.3V) Ground Serial Data I/O Serial Clock Do Not Use No Connect ** These pins should be NC in the system which does not support SPD. White Electronic Designs Corp. reserves the right to change products or specifications without notice. June 2003 Rev. 1 1 White Electronic Designs Corporation • (602) 437-1520 • www.wedc.com White Electronic Designs FUNCTIONAL BLOCK DIAGRAM CS1# CS0# DQM0 DM DQ0 DQ1 DQ2 DQ3 DQ4 DQ5 DQ6 DQ7 CS# DQS DQ32 DQ33 DQ34 DQ35 DQ36 DQ37 DQ38 DQ39 W3DG6464V-D1 DQM4 DM DQ0 DQ1 DQ2 DQ3 DQ4 DQ5 DQ6 DQ7 CS# DQS DQ0 DQ1 DQ2 DQ3 DQ4 DQ5 DQ6 DQ7 U0 U8 U4 U12 DQM1 DM DQ0 DQ1 DQ2 DQ3 DQ4 DQ5 DQ6 DQ7 CS# DQS DQM5 DM DQ0 DQ1 DQ2 DQ3 DQ4 DQ5 DQ6 DQ7 CS# DQS DQ8 DQ9 DQ10 DQ11 DQ12 DQ13 DQ14 DQ15 U1 U9 DQ40 DQ41 DQ42 DQ43 DQ44 DQ45 DQ46 DQ47 U5 U13 DQM2 DM DQ0 DQ1 DQ2 DQ3 DQ4 DQ5 DQ6 DQ7 CS# DQS DQM6 DM DQ0 DQ1 DQ2 DQ3 DQ4 DQ5 DQ6 DQ7 CS# DQS Q16 Q17 Q18 Q19 Q20 Q21 Q22 Q23 U2 U10 DQ48 DQ49 DQ50 DQ51 DQ52 DQ53 DQ54 DQ55 U6 U14 DQM3 DM DQ0 DQ1 DQ2 DQ3 DQ4 DQ5 DQ6 DQ7 CS# DQS DQM7 DM DQ0 DQ1 DQ2 DQ3 DQ4 DQ5 DQ6 DQ7 CS# DQS DQ24 DQ25 DQ26 DQ27 DQ28 DQ29 DQ30 DQ31 U3 U11 DQ56 DQ57 DQ58 DQ59 DQ60 DQ61 DQ62 DQ63 U7 U15 CK0 PLL U0-U15 BA0,BA1 A0-A12 RAS# CAS# CKE0 CKE1 WE# U0-U15 U0-U15 U0-U15 U0-U15 U0-U7 U9-U15 U0-U15 SERIAL PD SCL A0 A1 A2 SDA NOTE: All resistor values are 22 ohms unless otherwise specified. White Electronic Designs Corp. reserves the right to change products or specifications without notice. June 2003 Rev. 1 2 White Electronic Designs Corporation • (602) 437-1520 • www.wedc.com White Electronic Designs ABSOLUTE MAXIMUM RATINGS Parameter Voltage on any pin relative to VSS Voltage on VCC supply relative to VSS Storage Temperature Power Dissipation Short Circuit Current Symbol VIN, VOUT VCC, VCCQ TSTG PD IOS Value -1.0 ~ 4.6 -1.0 ~ 4.6 -55 ~ +150 16 50 W3DG6464V-D1 Units V V °C W mA Note: Permanent device damage may occur if “ABSOLUTE MAXIMUM RATINGS” are exceeded. Functional operation should be restricted to recommended operating condition. Exposure to higher than recommended voltage for extended periods of time could affect device reliability. RECOMMENDED DC OPERATING CONDITIONS (Voltage Referenced to: VSS = 0V, TA = 0°C to +70°C) Parameter Supply Voltage Input High Voltage Input Low Voltage Output High Voltage Output Low Voltage Input Leakage Current Symbol VCC VIH VIL VOH VOL ILI Min 3.0 2.0 -0.3 2.4 — -10 Typ 3.3 3.0 — — — — Max 3.6 VCCQ+0.3 0.8 — 0.4 10 Unit V V V V V µA 1 2 IOH= -2mA IOL= -2mA 3 Note Note: 1. VIH (max)= 5.6V AC. The overshoot voltage duration is ≤ 3ns. 2. VIL (min)= -2.0V AC. The undershoot voltage duration is ≤ 3ns. 3. Any input 0V ≤ VIN ≤ VCCQ Input leakage currents include Hi-Z output leakage for all bi-directional buffers with Tri-State outputs. CAPACITANCE (TA = 23°C, f = 1MHz, VCC = 3.3V, VREF=1.4V ± 200mV) Parameter Input Capacitance (A0-A12) Input Capacitance (RAS#,CAS#,WE#) Input Capacitance (CKE0) Input Capacitance (CK0, CK1) Input Capacitance (CS0#) Input Capacitance (DQM0-DQM7) Input Capacitance (BA0-BA1) Data Input/Output Capacitance (DQ0-DQ63) Data Input/Output Capacitance (CB0-7) Symbol CIN1 CIN2 CIN3 CIN4 CIN5 CIN6 CIN7 CouT CouT1 Max 15 15 15 20 15 15 15 22 22 Unit pF pF pF pF pF pF pF pF pF White Electronic Designs Corp. reserves the right to change products or specifications without notice. June 2003 Rev. 1 3 White Electronic Designs Corporation • (602) 437-1520 • www.wedc.com White Electronic Designs OPERATING CURRENT CHARACTERISTICS (VCC = 3.3V, TA = 0°C to +70°C) W3DG6464V-D1 Version Parameter Operating Current (One bank active) Precharge Standby Current in Power Down Mode Symbol ICC1 Burst Length = 1 tRC ≥ tRC(min) IOL = 0mA CKE ≤ VIL(max), tCC = 10ns CKE & CK ≤ VIL(max), tCC = ∞ CKE ≥ VIH(min), CS ≥ VIH(min), tcc =10ns Input signals are charged one time during 20ns CKE ≥ VIH(min), CK ≤VIL(max), tCC = ∞ Input signals are stable CKE ≥ VIL(max), tCC = 10ns CKE & CK ≤ VIL(max), tCC = ∞ CKE ≥ VIH(min), CS ≥ VIH(min), tcc = 10ns Input signals are changed one time during 20ns CKE ≥ VIH(min), CK ≤ VIL(max), tcc = ∞ Input signals are stable Io = mA Page burst 4 Banks activated tCCD = 2CK tRC ≥ tRC(min) CKE ≤ 0.2V Conditions 133 960 100 880 Units mA Note 1 ICC2P ICC2PS ICC2N 40 40 320 mA Precharge Standby Current in Non-Power Down Mode ICC2NS ICC3P ICC3PS ICC3N mA 160 65 65 400 280 mA mA mA Active Standby Current in Power-Down Mode Active Standby Current in Non-Power Down Mode ICC3NS ICC4 Operating Current (Burst mode) 1,120 1,040 mA 1 Refresh Current Self Refresh Current ICC5 ICC6 1,920 50 1,680 50 mA mA 2 Notes: 1. Measured with outputs open. 2. Refresh period is 64ms. 3. Unless otherwise noticed, input swing level is CMOS (VIH/VIL = VCCQ/VSSQ) White Electronic Designs Corp. reserves the right to change products or specifications without notice. June 2003 Rev. 1 4 White Electronic Designs Corporation • (602) 437-1520 • www.wedc.com White Electronic Designs W3DG6464V-D1 Ordering Information W3DG6464V10D1 W3DG6464V7D1 W3DG6464V75D1 Speed 100MHz 133MHz 133MHz CAS Latency CL=2 CL=2 CL=3 Note: For industrial temperature range product, add an "I" to the end of the part number. PACKAGE DIMENSIONS 2.666 MAX. .079 MIN. .250 MAX. .157 1.255 MAX. .787 .126 MIN. .158 MIN. 1.291 .913 1.112 .181 .059 ALL DIMENSIONS ARE IN INCHES .039 ± .004 White Electronic Designs Corp. reserves the right to change products or specifications without notice. June 2003 Rev. 1 5 White Electronic Designs Corporation • (602) 437-1520 • www.wedc.com