2730750000

    Data sheet VPU AC II US 4 R 400/50 Weidmüller Interface GmbH & Co. KG Klingenbergstraße 26 D-32758 Detmold Germany   www.weidmueller.com     Abb.ähnlich • compact SPD to install in application by NFPA 79 • no additional overcurrent protection devices needed • short circuit current rating (SCCR) up to 200 kA • tested according to IEC/EN 61643-11 and UL 1449 4.Ed General ordering data   Version Order No. Type GTIN (EAN) Qty.   Surge voltage arrester, Low voltage, Surge protection, with remote contact, TN-C-S, TN-S, UP(L/N-PE) ≤ 2.3 kV 2730750000 VPU AC II US 4 R 400/50 4050118807356 1 pc(s). Creation date March 1, 2021 6:45:07 PM CET   Catalogue status 26.02.2021 / We reserve the right to make technical changes. 1     Data sheet VPU AC II US 4 R 400/50   Weidmüller Interface GmbH & Co. KG Klingenbergstraße 26 D-32758 Detmold Germany   www.weidmueller.com Technical data Dimensions and weights   Depth Depth including DIN rail Height (inches) Net weight Width (inches)   68 mm 76 mm 4.114 inch 513 g 2.835 inch           Depth (inches) Height Mounting dimension - height Width   2.677 inch 104.5 mm 75 mm 72 mm -40 °C...85 °C 5 - 95% rel. humidity     Operating temperature   -40 °C...85 °C ≤ 4000 m 400 V 480 V 20 kA AWG 14 -40 °C 3,000 V 1,500 V 3-phase WYE                   Ambient temperature (operational), max. 85 °C VPR (N-PE) 1,500 V SCCR 200 kA Category SPD TYPE 1CA Connection cross-section AWG, max. AWG 6 MODE all modes VPR (L-N) 3,000 V Voltage type AC       Cross-section for connected wire, solid core, max. Cross-section for connected wire, solid core, min. Stripping length   Design   Optical function display       Rail UL 94 flammability rating       Pollution severity   Temperatures   Storage temperature Humidity   Rated data UL   Operating altitude Rated Voltage UN MCOV (L/N-PE) In Connection cross-section AWG, min. Ambient temperature (operational), min. VPR (L-L) VPR (L-PE) UL Energy Networks   Connection data, remote alert   Connection type Cross-section for connected wire, solid core, max. (AWG) Cross-section for connected wire, solid core, min. (AWG)   PUSH IN AWG 10 AWG 30   1.5 mm² 0.14 mm² 12 mm General data   Colour Operating altitude Protection degree Segment Version   orange, black ≤ 4000 m IP20 in installed state Power distribution Surge protection, with remote contact Installation housing, Insta IP 20 green = OK; red = arrester is defective - replace TS 35 V-0 Insulation coordination acc. to EN 50178   Operating altitude Surge voltage category   ≤ 4000 m III 2 Creation date March 1, 2021 6:45:07 PM CET   Catalogue status 26.02.2021 / We reserve the right to make technical changes. 2     Data sheet VPU AC II US 4 R 400/50   Weidmüller Interface GmbH & Co. KG Klingenbergstraße 26 D-32758 Detmold Germany   www.weidmueller.com Technical data Rated data IEC / EN   Discharge current Imax (8/20µs) wire-PE 50 kA Discharge current In (8/20µs) N-PE 40 kA Energy coordination (≤10 m) Type II, Type III Frequency range, max. 60 Hz Fuse No Fuse neccessary ≤315 A gG, 250 A gG @50 kA Isccr, 315 A gG @25 kA Isccr Low voltage network TN-C-S, TN-S Max. continuous voltage, Uc (AC) 480 V Protection level UP (typ.) ≤ 2.3 kV Requirements category acc. to IEC 61643-11 Type II Response time ≤ 25 ns Short-circuit current rating ISCCR 50 kA Standards IEC61643-11, EN61643-11, UL 1449 Ed.4, NFPA 79 Voltage type AC                         Discharge current Imax (8/20µs) N-PE Discharge current In (8/20µs) wire-PE Follow-on current extinguishing capability Ifi Frequency range, min. Leakage current at Un Mains voltage Number of poles Rated voltage (AC) Requirements class, acc. to EN 61643-11 SPD type Signalling contact Temporary surge voltage (over-voltage) TOV               Type of connection Tightening torque, min. Clamping range, rated connection Clamping range, max. Wire connection cross section AWG, max. Wire cross-section, solid, max. Wire connection cross section, finely stranded, max. Conductor cross-section, flexible, AEH (DIN 46228-1), max. Connection cross-section, stranded, max.   50 kA 20 kA Follow current need not be taken into account 50 Hz 0.9 mA 400 V / 690 V 4 400 V T2 T2 250 V 1A 1CO 581 V Connection data   Wire connection method Screw connection Stripping length, rated connection 18 mm Tightening torque, max. 4.5 Nm Clamping range, min. 4 mm² Wire connection cross section AWG, min. AWG 14 Wire cross-section, solid, min. 2.5 mm² Wire connection cross section, finely stranded, min. 4 mm² Conductor cross-section, flexible, AEH (DIN 46228-1), min. 2.5 mm² Connection cross-section, stranded, min. 2.5 mm²           Screw connection 2 Nm 16 mm² 35 mm² AWG 6 35 mm² 35 mm² 35 mm² 35 mm² Ratings IECEx/ATEX/cUL   Certificate no. (cULus)   E354261     5 years     EC000941 27-13-08-05 27-13-08-05       ETIM 7.0 ECLASS 9.1 ECLASS 11.0 Guarantee   Time interval   Classifications   ETIM 6.0 ECLASS 9.0 ECLASS 10.0   EC000941 27-13-08-05 27-13-08-05 Creation date March 1, 2021 6:45:07 PM CET   Catalogue status 26.02.2021 / We reserve the right to make technical changes. 3     Data sheet VPU AC II US 4 R 400/50   Technical data Weidmüller Interface GmbH & Co. KG Klingenbergstraße 26 D-32758 Detmold Germany   www.weidmueller.com Approvals   Approvals ROHS UL File Number Search   Conform E354261 Downloads   Approval/Certificate/Document of Conformity Engineering Data User Documentation   Declaration of Conformity STEP IS VPU AC II US Creation date March 1, 2021 6:45:07 PM CET   Catalogue status 26.02.2021 / We reserve the right to make technical changes. 4     Data sheet VPU AC II US 4 R 400/50   Drawings Weidmüller Interface GmbH & Co. KG Klingenbergstraße 26 D-32758 Detmold Germany   www.weidmueller.com Electric symbol Schematic circuit diagram Creation date March 1, 2021 6:45:07 PM CET   Catalogue status 26.02.2021 / We reserve the right to make technical changes. 5