AG102-PCB

High Dynamic Range Gain Block AG102 The Communications Edge TM Product Information Product Features x x x x x x x 60 – 3000 MHz 14 dB Gain 2.4 dB Noise Figure +36 dBm OIP3 Single +3.3 or +4.5 Supply Internally matched to 50 : Lead-free/Green/RoHScompliant SOT-89 Package x MTTF > 1000 years Product Description The AG102 is a general-purpose gain block that offers good dynamic range and low noise figure in a low-cost surface-mount package. The combination of near-constant OIP3 and low noise figure performance over frequency makes it attractive for both narrowband and broadband applications. The device combines dependable performance with superb quality to maintain MTTF values exceeding 1000 years at mounting temperatures of +85 qC and is available in the environmentally-friendly lead-free/green /RoHS-compliant SOT-89 package. The AG102 uses a high reliability GaAs MMIC technology and only requires DC-blocking and bypass capacitors, and an inductive RF choke for operation. Internal matching provides a 50 ohm input / output impedance minimizing the number of required external components. The broadband MMIC amplifier is well suited for various current and next generation wireless technologies such as GPRS, GSM, CDMA, and W-CDMA. In addition, the AG102 will work for other applications within the 60 to 3000 MHz frequency range such as fixed wireless. Functional Diagram GND 4 1 RF IN 2 GND 3 RF OUT Applications x x x x x x Mobile Infrastructure CATV / DBS W-LAN / ISM RFID Defense / Homeland Security Fixed Wireless Function Input Output/Bias Ground Pin No. 1 3 2, 4 Specifications (1) Parameter Operational Bandwidth Test Frequency Gain Input Return Loss(5) Output Return Loss Output P1dB Output IP3 (2) Noise Figure (3) Operating Current Range Supply Voltage Typical Performance (4) Units MHz MHz dB dB dB dBm dBm dB mA V ¡ Min 60 13 Typ 800 14 8.5 20 +18 +36 2.4 70 4.5 Max 3000 16 Parameter Frequency S21 S11 (5) S22 Output P1dB Output IP3 Noise Figure Supply Voltage Device Current Units MHz dB dB dB dBm dBm dB V mA 900 14 -10 -27 +18 +36 2.4 +4.5 70 Typical 1900 12.8 -9 -22 +18 +36 2.6 900 14 -10 -28 +16 +35 2.3 +3.3 68 1900 12.5 -9 -19 +16 +35 2.6 +33 55 90 1. Test conditions unless otherwise noted: T = 25º C, 50 system. 2. 3OIP measured with two tones at an output power of +2.5 dBm/tone separated by 10 MHz. The suppression on the largest IM3 product is used to calculate the 3OIP using a 2:1 rule. 3. Noise figure can be optimized by matching the input for optimal return loss. 4. Parameters reflect performance in an AG102-PCB application circuit, as shown on page 4. 5. Input return loss can be dramatically improved (