AFE220PS19

ACDC 220 Watts AFE220 Series xppower.com • Energy Efficiency Level V • CEC2008, EISA2007 & ErP Compliant • High Power Density • Single Outputs from 12 V to 48 V • High Efficiency • Low Earth Leakage Current • 3 Year Warranty Specification Input General • 90-264 VAC • 47-63 Hz • 2.1 A rms at 115 VAC, 1.1 A rms at 230 VAC Inrush Current • 110 A typical at 115 VAC, cold start +25 °C Power Factor • 0.95 typical at full load, 230 VAC Earth Leakage Current • 400 µA max at 264 VAC, 60 Hz Input Protection • Internal T4 A/250 V fuse Standby Power • 100 kHrs to MIL-HDBK-217F at 25 °C, GB Environmental Output See table Not user-adjustable ±2% maximum at 100% load No minimum load required 3 s maximum at 100 VAC 5 ms minimum at 100 VAC ±0.5% maximum See table 4% max. deviation, recovery to within 1% in 500 µs for a 25% load change Ripple & Noise • 2% max pk-pk (see note 1) Overvoltage Protection • 110-140% Vnom, recycle input to reset Overtemperature • Unit shuts down, auto recovery Protection Overload Protection • 110-150%, auto recovery Short Circuit Protection • Trip and restart (Hiccup mode) Temperature • 0.04%/°C maximum Coefficient Output Voltage Output Voltage Trim Initial Set Accuracy Minimum Load Start Up Delay Hold Up Time Line Regulation Load Regulation Transient Response Efficiency Energy Efficiency Isolation • • • • • • • • • Operating Temperature • 0 °C to 60 °C, derate from 100% power at 40 °C to 50% power at 60 °C Operating Humidity • 10-95% RH, non-condensing Storage Temperature • -20 °C to +80 °C Operating Altitude • 3000 m Shock • 30 g, 10 ms on 3 axes Vibration • 5-100 Hz, 2.31 m/s2, 20 mins, 3 axes EMC & Safety Emissions Harmonic Currents Voltage Flicker ESD Immunity Radiated Immunity EFT/Burst Surge Conducted Immunity Magnetic Field Dips & Interruptions Safety Approvals • EN55022, Class B conducted EN55022, Class B radiated • EN61000-3-2, Class A • EN61000-3-3 • EN61000-4-2, ±8 kV contact, ±15 kV air discharge Perf Criteria A • EN61000-4-3, 3 V/m Perf Criteria A • EN61000-4-4, level 3 Perf Criteria A • EN61000-4-5, installation class 3 Perf Criteria A • EN61000-4-6, 3 Vrms Perf Criteria A • EN61000-4-8, 1 A/m Perf Criteria A • EN55024, 100% for 10 ms, 30% 500 ms, 100% 5000 ms, Perf Criteria A, A, B High line, A,B,B Low line • EN60950-1, UL60950-1, CSA22.2 No. 60950-1 per cUL, CE Mark Output Power 180 220 220 220 Output Voltage W W W W 12 19 24 48 V V V V Output Current Total Regulation(2) Efficiency(4) 15.00 A 11.57 A 9.16 A 4.58 A 5% 5% 5% 5% 90% 91% 91% 93% Model Number AFE220PS12 (3) AFE220PS19 AFE220PS24 AFE220PS48 Notes 1. 2. 3. 4. Ripple and noise measured at 20 MHz bandwidth with a 47 µF tantalum and 0.1 µF ceramic cap connected at the measurement point. Total regulation includes initial set accuracy, line and load regulation. For optional IEC320-C6 input connector, add suffix ‘ C6’ to end of part number (Available on 12 V model only). Average of efficiencies measured at 25%, 50%, 75% and 100% load and 230 VAC input. Mechanical Details Mains Leads Order Part: UK - C14 inlet: UK-MAINS-IEC, C6 inlet: UK-MAINS-5 European - C14 inlet: EU-MAINS-IEC, C6 inlet: EU-MAINS-5 US - C14 inlet: US-MAINS-IEC, C6 inlet: US-MAINS-5 6 5 4 3 2 1 AFE220PS19/24/48 1 3 1.73 AFE220PS12 4 2 Power On Indicator (44.0) Pin Connector AFE220PS12 7.76 (197) Rubber foot (4 places.) Pin 1 2 3 4 Shell Function Output + Output + Return/Input Earth Return/Input Earth Return/Input Earth AFE220PS19/24/48 Pin 1 2 3 4 5 6 Function Return/Input Earth Return/Input Earth Return/Input Earth Output + Output + Output + 3.46 (88.0) 0.02 (0.5) Cable Length Optional IEC 320/C6 Inlet (12 V model only) AC Input IEC 320/C14 Inlet PS12 PS19 PS24 PS48 - 37.4” 37.4” 70.9” 70.9” ± ± ± ± 1.97” 1.97” 1.97” 1.97” (950 ± 50mm) (950 ± 50mm) (1800 ± 50mm) (1800 ± 50mm) Notes 1. Dimensions shown in inches (mm). Tolerance is 0.02 (0.5) maximum, except output cable length. 2. Weight: 2.31 lb (1050 g). 3. Optional output connectors available. Consult sales. 4. Output connector for AFE220PS12 is non locking 4 pin DC power plug and mates with Kycon KPJX-4S or equivalent. Output connector for AFE220PS19/24/48 is molex Mini-Fit part number 39-01-2060 with 5556 terminals and mates with molex plug 39-01-2066 and 5558 terminals or equivalent. 5. Mains lead length is 76” (1930 mm) approx 05-Aug-13 ACDC AFE220 Models and Ratings