CU10-09

ACDC 1015 Watts xppower.com CU1015 Series • Low Cost • Small Size • PCB Mount • 15 Watt Medical Version • Single Output 3.324 V • Peak Load Capability • Nonstandard Outputs Available Specification Input General Input Voltage Input Frequency Input Current • 85-264 VAC (120-370 VDC) • 47-63 Hz • 0.13 A rms at 230 VAC (CU10) 0.20 A rms at 230 VAC (CU15) Inrush Current • 20 A at 115 VAC, 40 A at 230 VAC, cold start 25 º C Earth Leakage Current • Class 2 (no earth) Input Protection • 1A fuse (CU10) 2A fuse (CU15, CU15-M) Output Output Voltage Output Voltage Trim Initial Set Accuracy Minimum Load Start Up Delay Start Up Rise Time Hold Up Time Drift Line Regulation Load Regulation Transient Response • • • • • • • • • • • Ripple & Noise Overvoltage Protection Short Circuit Protection Temperature Coefficient • • • • See table ±5% ±1% No minimum load required 1.5 s max 14 ms max 16 ms typical at full load and 115 VAC 0.6% 0.5% max 1.0% max 10% load to full load 4% max deviation, recovery to within 1% within 500 µs for 25% load change 1% max pk-pk (see note 1) 130-150% of Vnom, recycle input to reset Trip and restart (Hiccup mode) 0.05%/˚ C Efficiency Isolation Switching Frequency Power Density MTBF Environmental Operating Temperature • CU10/15: 0 ˚ C to +65 ˚ C, derate from full load at +45 ˚ C to no load at +65 ˚ C CU15-M: 0 ˚ C to +70 ˚ C, derate from full load at +50 ˚ C to 50% load at +70 ˚ C Cooling • Convection-cooled Operating Humidity • 95% RH, non-condensing Storage Temperature • -20 ˚ C to +85 ˚ C Operating Altitude • 3000 m Vibration • 10 Hz to 500 Hz, 2 g for 10 mins/cycle 60 min each cycle EMC & Safety Emissions ESD Immunity Radiated Immunity EFT/Burst Surge Conducted Immunity Dips & interruptions Safety Approvals 1 • See tables • 3000 VAC Input to Output (CU10/15) 4000 VAC Input to Output (CU15-M) • 100 kHz typical for 10 W models 67 kHz typical for 15 W models • 2.43 W/in3 (CU10); 3.17 W/in3 (CU15) • >500 kHrs per MIL-HDBK-217F (15 & 24 V units >400 kHrs) • CU15-M: EN55011 Level B conducted Others: FCC20780 Level B, EN55022 Class B conducted • EN61000-4-2, level 3, Perf Criteria A • EN61000-4-3, level 3, Perf Criteria A • EN61000-4-4, level 2, Perf Criteria A • EN61000-4-5, level 3, Perf Criteria A • EN61000-4-6, 10 V, Perf Criteria A • EN61000-4-11, 30% 10 ms, 60% 1000 ms, 100% 5000 ms, Perf Criteria A, B, B • CU15-M: EN60601, UL2601-1, CSA22.2 No. 601.1 per cUL Others: EN60950, UL1950, CSA22.2 No. 234 per cUL Output Current Output Voltage(3) Output Power 8.25 W 3.3 5.0 9.0 12.0 15.0 24.0 10 W VDC VDC VDC VDC VDC VDC 10 W 3.3 5.0 9.0 12.0 15.0 24.0 15 W Nominal 3.00 A 3.00 A 1.67 A 1.25 A 1.00 A 0.63 A VDC VDC VDC VDC VDC VDC Notes 1. Measured at 20 MHz bandwidth. 3.3 V models are 50 mV maximum. 2. Peak load lasting