DDC3024S15

DDC30 Series DC-DC Power Supplies XP Power 30 Watts xxx Series • 4:1 DC Input Range • 5 V to 24 V DC Output • Low Profile Design • Ambient Operation from -40 °C to +70 °C • Remote On/Off • 1500 VDC Isolation • Class A Conducted and Radiated Emissions • High Efficiency – Up to 85% • 3 Year Warranty The DDC series is a range of DIN Rail mounting DC/DC converters designed to offer additional voltages in DIN Rail power systems, provide isolated outputs & noise immunity or support battery powered or battery backed applications. With a 4:1 wide input range the DDC series converters can be supplied by both a 12V or 24V nominal input and offer output voltages between 5VDC and 24VDC. Dimensions: DDC30: 1.38 x 3.58 x 2.22” (35.0 x 91.0 x 56.5 mm) Models & Ratings Output Voltage 5 9 12 15 24 Output Power V V V V V 22.5 25.0 30.0 30.0 30.0 W W W W W Output Voltage Trim 4.75-5.5 8.55-9.9 11.4-13.8 14.25-16.5 22.8-27.6 V V V V V Output Current(1) 4.5 2.8 2.5 2.0 1.25 A A A A A Input Current Typical, Max Maximum Capacitive Load Efficiency(2) Model Number 1.13 A, 3.1 A 1.25 A, 3.4 A 1.48 A, 4 A 1.48 A, 4 A 1.48 A, 4 A 3500 μF 2200 μF 1000 μF 1000 μF 470 μF 81% 82% 83% 84% 85% DDC3024S05 DDC3024S09 DDC3024S12 DDC3024S15 DDC3024S24 Notes 1. Output current should be limited so that nominal output power is not exceeded 2. Typical efficiency at nominal input and full load. Mechanical Details 2.22 (56.0) 1.96 (49.8) 1.38 (35.0) 1.28 (32.5) 1 2 3 4 Pin Connector 3.58 (91.0) 1.77 (45.0) 3.58 (91.0) 0.43 (11.0) 1 2 3 1 0.47 (12.0) 2.05 (52.0) www.xppower.com Conn Pin 1 DC 2 I/P 3 1 2 DC O/P 3 4 Designation Remote On/Off +Vin -Vin +Vout +Vout -Vout -Vout DDC30 Series DC-DC Power Supplies XP Power Input Characteristic Input Voltage Range Minimum Typical 10 Maximum Units Notes & Conditions 36 VDC Input polarity reversal protection 90 A at 36 V V Turn on 40 VDC No Damage Maximum Units Notes & Conditions 24 V See Models and Ratings table % See Models and Ratings table Input Current See Models and Ratings table Inrush Current Input Filter Pi type Undervoltage Lockout 9.6 Input Surge Input Protection T7.0A/63 VDC Internal Fuse Output Characteristic Minimum Output Voltage 5 Typical Output Voltage Trim Initial Set Accuracy 0 Minimum Load 0 +1 % A Start Up Delay 50 Start Up Rise Time 7 No minimum load required ms ms Line Regulation ±1.0 % Load Regulation ±1.0 % Transient Response Ripple & Noise 0 - 100% load 4 % deviation 100 mV pk-pk Short Circuit Protection Recovery to within 1% in