PBM200PT02-C

AC-DC 200 Watts PBM200 Series • • • • • • • Worldwide Medical Approvals xppower.com Single, Dual, Triple and Quad Outputs Small Size - Only 7” x 4” x 1.5” Power Fail Detect & Remote On/Off Universal AC Input with Active PFC High Reliability - 350k Hours MTBF 100 Watt Convection-Cooled Rating Specification Input Input Voltage Input Frequency Input Current • 90-264 VAC • 47-63 Hz • 3.2 A rms at 115 VAC, 1.6 A rms at 230 VAC Inrush Current • 20 A at 115 VAC, 40 A at 230 VAC cold start 25 ºC Power Factor • 0.98 typical Earth Leakage Current • 90 µA max at 115 VAC, 60 Hz 150 µA max at 230 VAC, 50 Hz Input Protection • Both line and neutral fused General Efficiency Isolation • Up to 80% • 4000 VAC Input to Output 1500 VAC Input to Ground 500 VAC Output to Ground • 100 kHz ±12 kHz • 4.76 W/In3 • AC OK = TTL logic high AC not OK = TTL logic low • 350 kHrs per MIL-HDBK-217F at +25 ˚C Switching Frequency Power Density Power Fail Detect MTBF Environmental Operating Temperature • 0 ˚C to +70 ˚C, derate linearly from 100% power at +50 ˚C to 50% power at +70 ˚C Cooling • ‘C’ versions have internal fan, ‘B’ versions are derated with convection cooling or require 25 CFM (see note 4) Operating Humidity • Up to 95% RH, non-condensing Storage Temperature • -40 ˚C to +85 ˚C Operating Altitude • 2500 m Shock • Half sine pulse. acceleration 50 g, 11 ms duration, 3 shocks in each direction, unpackaged, non-operating Vibration • Sinusoidal 10-55 Hz, amplitude 0.15 mm, 30 min/axis, unpackaged, non-operating Output Output Voltage Output Voltage Trim Initial Set Accuracy Minimum Load Start Up Delay Start Up Rise Time Hold Up Time Drift Line Regulation Load Regulation Transient Response Ripple & Noise • • • • • • • • • • • • See table Not user-adjustable ±2% See table & note 5 2 s max 18 ms typical 20 ms minimum at full load & 110 VAC ±0.2% ±0.5% max See note 7 4% max deviation, recovery to within 1% in 500 µs for a 25% load change 2% max pk-pk, 20 MHz BW with a 22 µF electrolytic & a 0.47 µF tantalum capacitor 112-140% Vnom output 1 only, recycle input to reset Shutdown at +85 ºC (singles) or +105 ºC (multi outputs) with auto recovery, measured internally 140-200% typical, auto recovery Trip and restart (Hiccup mode) 0.04%/˚C EMC & Safety Emissions Harmonic Currents Voltage Flicker ESD Immunity Radiated Immunity EFT/Burst Surge Conducted Immunity Dips & Interruptions • EN55011 & FCC Class B conducted & radiated • EN61000-3-2 • EN61000-3-3 • EN61000-4-2, level 3 Perf Criteria A • EN61000-4-3, level 3 Perf Criteria A • EN61000-4-4, level 3 Perf Criteria A • EN61000-4-5, level 3 Perf Criteria A • EN61000-4-6 3 V, Perf Criteria A • EN61000-4-11, 30% 10 ms, 60% 100 ms, >95% 5000 ms, Perf Criteria A, B, B • EN60601-1, UL60601-1, CSA22.2 No. 601-1 per cUL, CE Mark Overvoltage Protection • Overtemperature Protection Overload Protection Short Circuit Protection Temperature Coefficient Remote Sense Remote On/Off • • • • • Single output models only. Compensates for up to 0.5 V drop • On = Logic low or open circuit Off = Logic high Safety Approvals AC-DC Models and Ratings Output Power(4) 150 W 175 W 200 W 200 W 200 W 200 W 200 W 200 W 200 W 200 W 200 W 200 W 200 W 200 W 200 W 200 W 200 W 200 W 200 W 200 W 200 W 175 W Output 1(8) Vnom 3.3 V 5.1 V 12.0 V 15.0 V 24.0 V 30.0 V 48.0 V +5.1 V +5.1 V +5.1 V +12.0 V +5.1 V +5.1 V +5.1 V +5.1 V +5.1 V +5.1 V +5.1 V +5.1 V +5.1 V +5.1 V +3.3 V Imin (5) PBM200 Output 2(2,5) Reg (7) Output 3(5) Reg (7) Output 4(3,5) Reg (7) Imax 46.0 A 35.0 A 16.7 A 13.4 A 8.4 A 6.7 A 4.2 A 30.0 A 30.0 A 30.0 A 8.7 A 30.0 A 30.0 A 30.0 A 30.0 A 30.0 A 30.0 A 30.0 A 30.0 A 30.0 A 30.0 A 30.0 A Vnom Imax Vnom Imax Vnom Imax Reg(7) Model Number(1) PBM200PS3V3-C† PBM200PS05-C† PBM200PS12-C† PBM200PS15-C† PBM200PS24-C† PBM200PS30-C PBM200PS48-C† 3.0 A 3.0 A 1.2 A 1.0 A 0.6 A 0.5 A 0.5 A 3.0 A 3.0 A 3.0 A 1.0 A 3.0 A 3.0 A 3.0 A 3.0 A 3.0 A 3.0 A 3.0 A 3.0 A 3.0 A 3.0 A 3.0 A 3% 2% 2% 2% 2% 2% 2% 2% 2% 2% 2% 2% 2% 2% 2% 2% 2% 2% 2% 2% 2% 3% +12 V +15 V +24 V +24 V +12 V +12 V +15 V +12 V +15 V +12 V +15 V +12 V +12 V +12 V +5.1 V 8.0 A 6.0 A 4.0 A 4.0 A 8.0 A 8.0 A 6.0 A 8.0 A 6.0 A 8.0 A 6.0 A 8.0 A 8.0 A 8.0 A 8.0 A 4% 4% 4% 4% 4% 4% 4% 4% 4% 4% 4% 4% 4% 4% 4% -12 V -12 V -15 V -12 V -15 V -12 V -12 V 4.0 A 4.0 A 4.0 A 4.0 A 4.0 A 4.0 A 4.0 A -5 V -12 V -15 V 6.0 A 4.0 A 4.0 A 4% 4% 4% 4% 4% 4% 4% 4% 4% 4% 4% F5V F 24 V F 12 V F 15 V F 24 V F 12 V 6.0 A 4.0 A 4.0 A 4.0 A 4.0 A 4.0 A 4% 4% 4% 4% 4% 4% F 24 V 4.0 A 4% PBM200PD01-C PBM200PD02-C PBM200PD03-C PBM200PD04-C PBM200PT01-C PBM200PT02-C† PBM200PT03-C† PBM200PT04-C PBM200PT05-C PBM200PQ01-C PBM200PQ02-C† PBM200PQ03-C PBM200PQ04-C PBM200PQ05-C† PBM200PQ06-C† Notes 1. For U-bracket format, replace suffix ‘-C’ with suffix ‘-B’. 2. Output 2 peak current is 12 A on +12 V, 9 A on +15 V, and 6 A on +24 V. Maximum 2 s duration with total load