PBM300PS05-C

AC-DC 300 Watts xppower.com PBM300 Series • Worldwide Medical Approvals • Single, Dual, Triple and Quad Outputs • Power Fail Detect • Remote On/Off • U Channel and Enclosed Versions • 150 Watt Convection-cooled Rating • 3 Year Warranty Specification Input General Input Voltage Input Frequency Input Current • 90-264 VAC • 47-63 Hz • 4.7 A rms at 115 VAC, 2.3 A rms for 230 VAC Inrush Current • 30 A at 115 VAC, 60 A at 230 VAC cold start +25 °C Power Factor • 0.98 typical Earth Leakage Current • 100 μA max at 115 VAC/60 Hz 220 μA max at 230 VAC/50 Hz Input Protection • Internal F6.3 A/250 V in line and neutral lines Efficiency Isolation Switching Frequency Signals Power Density Power Fail Detect MTBF • 80% maximum • 4000 VAC Input to Output 1500 VAC Input to Ground 500 VAC Output to Ground • 70 kHz ±10 kHz • Power fail detect, remote on/off • 5.08 W/In3 • AC OK = TTL logic high AC not OK = TTL logic low • 300 kHrs to MIL-HDBK-217F at +25 °C, GB Environmental Output Output Voltage Output Voltage Trim Initial Set Accuracy Minimum Load Start Up Delay Start Up Rise Time Hold Up Time Drift Line Regulation Load Regulation Transient Response • • • • • • • • • • • Ripple & Noise • Overvoltage Protection • Overtemperature Protection • Overload Protection Short Circuit Protection Temperature Coefficient Remote Sense Remote On/Off • • • See table ±5% for outputs 1 & 2 ±2% See table and note 5 2 s max 18 ms typical 12 ms min at full load and 110 VAC ±0.2% ±0.2% max See note 6 4% max deviation, recovery to within 1% in 500 μs for a 25% load change 2% max pk-pk, 20 MHz bandwidth, with a 22 μF electrolytic & a 0.47 μF tantalum capacitor 115-140% Vnom output 1 only, recycle input to reset Shutdown at +95 °C (singles) or +105 °C (multi-outputs) with auto recovery, measured internally 110-150% typical, auto recovery Trip and restart (Hiccup mode) 0.04%/°C • Compensates for up to 0.5 V drop • On = Logic low or open circuit Off = Logic high Operating Temperature • 0 °C to +70 °C, derate linearly from 100% power at +50 °C to 50% power at +70 °C Cooling • ‘C’ versions have internal fan, ‘B’ versions are derated with convection cooling or require 35 CFM (see note 4) Operating Humidity • up to 95% RH, non-condensing Storage Temperature • -40 °C to +85 °C Operating Altitude • 2500 m Shock • Half sine pulse. acceleration 50 g, 11 ms duration, 3 shocks in each direction, unpackaged, non-operating Vibration • Sinusoidal 10-50 Hz, amplitude 0.15 mm, 30 min/axis, unpackaged, non-operating EMC & Safety Emissions Harmonic Currents Voltage Flicker ESD Immunity Radiated Immunity EFT/Burst Surge Conducted Immunity Dips & Interruptions Safety Approvals • EN55011 and FCC Class B conducted & radiated • EN61000-3-2, Class A • EN61000-3-3 • EN61000-4-2, level 3 Perf Criteria A • EN61000-4-3, level 3 Perf Criteria A • EN61000-4-4, level 3 Perf Criteria A • EN61000-4-5, level 3 Perf Criteria A • EN61000-4-6, 3 V Perf Criteria A • EN61000-4-11, 30% 10 ms, 60% 100 ms, >95% 5000 ms, Perf Criteria A, A, B • EN60601-1, UL60601-1, CSA22.2 No. 601-1 per cUL, CE & UKCA meets all applicable directives & legislation. Output Power(4) Vnom(3) Output 1 Output 2 Imin Imax Reg (5) (6) Vnom (3) Imin Output 3 (2) Imax Reg Vnom (6) Output 4 (2) Imax Reg (6) Vnom Imax (2) Reg(6) Model Number(1) 200 W 3.3 V 3.0 A 60.0 A 3% PBM300PS03-C 300 W 5.1 V 3.0 A 60.0 A 2% PBM300PS05-C 300 W 12.0 V 1.2 A 25.0 A 2% PBM300PS12-C 300 W 15.0 V 1.0 A 20.0 A 2% PBM300PS15-C 300 W 24.0 V 0.6 A 12.5 A 2% PBM300PS24-C 300 W 30.0 V 0.5 A 10.0 A 2% PBM300PS30-C 300 W 48.0 V 0.5 A 6.3 A 2% 250 W 3.3 V 3.0 A 35.0 A 3% 5.1 V 2.0 A 22.0 A 2% 12.0 V 4.0 A 4% 12.0 V 4.0 A 4% PBM300PQ01-C 300 W 5.1 V 2.0 A 35.0 A 2% 12.0 V 1.0 A 10.0 A 2% 12.0 V 4.0 A 4% 5.1 V 4.0 A 4% PBM300PQ02-C 300 W 5.1 V 2.0 A 35.0 A 2% 15.0 V 0.8 A 8.0 A 2% 15.0 V 4.0 A 4% 24.0 V 2.5 A 4% PBM300PQ03-C 300 W 5.1 V 2.0 A 35.0 A 2% 12.0 V 1.0 A 10.0 A 2% 12.0 V 4.0 A 4% 12.0 V 4.0 A 4% PBM300PQ04-C 300 W 5.1 V 2.0 A 35.0 A 2% 12.0 V 1.0 A 10.0 A 2% 12.0 V 4.0 A 4% 24.0 V 2.5 A 4% PBM300PQ05-C 300 W 5.1 V 2.0 A 35.0 A 2% 12.0 V 1.0 A 10.0 A 2% 12.0 V 4.0 A 4% 15.0 V 4.0 A 4% PBM300PQ06-C 300 W 5.1 V 2.0 A 35.0 A 2% 24.0 V 0.5 A 5.0 A 2% 12.0 V 4.0 A 4% 12.0 V 4.0 A 4% PBM300PQ07-C 300 W 5.1 V 2.0 A 35.0 A 2% 24.0 V 0.5 A 5.0 A 2% 5.1 V 4.0 A 4% 15.0 V 4.0 A 4% PBM300PQ08-C 300 W 5.1 V 2.0 A 35.0 A 2% 12.0 V 1.0 A 10.0 A 2% 5.1 V 4.0 A 4% 24.0 V 2.5 A 4% PBM300PQ09-C 300 W 24.0 V 0.5 A 6.3 A 2% 12.0 V 1.0 A 10.0 A 2% 5.1 V 4.0 A 4% 12.0 V 4.0 A 4% PBM300PQ10-C 300 W 24.0 V 0.5 A 6.3 A 2% 12.0 V 1.0 A 10.0 A 2% 5.1 V 4.0 A 4% 24.0 V 2.5 A 4% PBM300PQ11-C 300 W 24.0 V 0.5 A 6.3 A 2% 12.0 V 1.0 A 10.0 A 2% 12.0 V 4.0 A 4% 12.0 V 4.0 A 4% PBM300PQ12-C 300 W 24.0 V 0.5 A 6.3 A 2% 24.0 V 0.5 A 5.0 A 2% 5.1 V 4.0 A 4% 15.0 V 4.0 A 4% PBM300PQ13-C 300 W 24.0 V 0.5 A 6.3 A 2% 24.0 V 0.5 A 5.0 A 2% 12.0 V 4.0 A 4% 12.0 V 4.0 A 4% PBM300PQ14-C PBM300PS48-C Notes 1. For U-bracket format replace suffix ‘-C’ with suffix ‘-B’. 2. All auxiliary outputs are floating and can be connected externally for either positive or negative output. 3. Output 1 & 2 can be adjusted within ±5% of their nominal voltage. 4. 300 W for ‘C’ version with cover and fan assembly. 150 watts for ‘B’ version with convection cooling (maximum current of output 1 & 2 derated by 50%). 300 W for ‘B’ version with 35 CFM forced air provided by user. PBM300PS03 is rated 200 W with 35 CFM forced air cooling or 100 W convection-cooled. PBM300PQ01 is rated 250 W with 35 CFM forced air cooling or 125 W with convection cooling. 5. Zero minimum load for outputs 3 & 4. 10% minimum load required on output 1 for all outputs to meet regulation. 6. Total regulation includes initial tolerance, line regulation and load regulation. Mechanical Details Weight: 2.40 lb (1.09 kg) approx. for '-B' version, 2.75 lb (1.25g) approx. for '-C' version. Conn 0.63 (16.0) B B A A P1 1.00 (25.4) P2 P3 1.75 (44.45) 10 0.94 (24.0) 1.34 (34.2) P4 Voltage adj., single 4.50 (114.3) A A B B 1.80 (45.7) 2.60 (66.0) P4 P4 P2 Voltage adj., multi 1 P1 L N P3 B B A A P2 1 P3 PCB P4 P5 P5 P6 P6 P5 P6 P7 1 P7 G 3 0.95 (24.1) 5.70 (144.8) Multi Output Models Single Output Models FAN 1.00 (25.4) 0.63 (16.0) A A B B 0.25 (6.35) 7.00 (177.8) 7.50 (190.5) 1.75 (44.45) Pin 1 2 3 1 1 1 2 3 4 5 6 7 8 9 10 1 1 1 2 3 4 Model Number(s) PSXX PQXX Line Line Neutral Neutral Ground Ground OP1 OP1 OP1 OP1 Return Signal Ground Signal Ground +sense +sense OP1 -sense -sense OP1 PFD PFD Remote On/Off Remote On/Off N.C. N.C. N.C. +sense OP2 N.C. -sense OP2 0V (fan) 0V (fan) 12V (fan) 12V (fan) OP1 Return OP2 OP1 Return OP2 Return n/a OP3 n/a OP3 Return n/a OP4 n/a OP4 Return Notes 1. Dimensions shown in inches (mm). Tolerance 0.02 (0.5) max. 2. Mounting Holes A: #6-32 Mounting Screw, B: M3 x 0.5, Maximum mounting screw length from surface of chassis is 0.14 inch (3.5 mm) 3. Input connector P1 is Dinkle P/N DT-35-B01W-03. Screws are M3 x 0.5 on 0.375” centres. 4. Connector P4 mates with Molex housing 50-37-5103 & pins 5263. 5. Connectors P2. P3, P5 & P6: M3x0.5 screw connections. 6. Connector P7 mates with Molex housing 09-50-3041 & 2878 series crimp terminals. 7. DC fan on P4 is rated at 12 V/0.1 A. 03 Aug 2022 AC-DC PBM300 Models and Ratings