SFS6900A-LF

SFS6900A-LF Rev A1 Fixed Frequency Synthesizer Surface Mount Module Applications • Point to point transmission • Satellite Communications • Performance Specifications Frequency Phase Noise @ 10 kHz offset (1 Hz BW) Harmonic Suppression (2nd) Spurious Suppression Power Output Load Impedance Settling Time Operating Temperature Range Package Style Power Supply Requirements Supply Voltage 1: PLL (Vcc, nom) Supply Voltage 2: VCO (Vcc, nom) Supply Current 1: PLL (Icc, typ) Supply Current 2: VCO (Icc, typ) Reference Oscillator Signal Frequency Phase Noise @1 kHz offset Additional Notes Note1: Phase noise measurement was performed using a 10MHz CMOS reference oscillator with a phase noise of -145dBc/Hz @1KHz. Pin 7,8,9 are N/C Application Notes • AN-107: Manual Soldering Technique • AN-205: Measuring Phase Noise for SFS Series Min 6900 Typ Max 6900 Units MHz dBc/Hz dBc dBc -90 -20 -65 0 3 50 .3 0 PLL-V12N Min Typ 3 5 11 33 Min Typ 10 -145 Max Max 70 6 dBm mS °C Units Vdc Vdc mA mA Units MHz dBc/Hz LFSuffix = RoHS Compliant. All specifications are subject to change without notice. © Z-Communications, Inc. All Rights Reserved. 14118 Stowe Drive, Suite B | Poway, CA 92064 | TEL: (858) 621-2700 | FAX: (858) 486-1927 URL: www.zcomm.com | EMAIL: applications@zcomm.com Page 1 of 2 FRM-S-002 B Fixed Frequency Synthesizer Surface Mount Module SFS6900A-LF Rev A1 Phase Noise, typ. PHASE NOISE (1 Hz BW, typical) RECOMMENDED FOOTPRINT Footprint SEVERAL HOLES OF O 0.015 ON GND. PLANE ARE RECOMMENDED FOR GOOD GROUNDING. £(f) (dBc/Hz) 0.030 MIN. CUTBACK FROM LIVE PADS OFFSET (Hz) Physical Dimensions PIN CONFIGURATION 1 2 3 4 5 6 12 1 3 5 6 7 8 9 10 REST Vcc(VCO) RF OUT MUX OUT Vcc(CHIP) CLOCK DATA ENABLE REF IN GROUND Z-COMM XXXXXXXX-LF W/O# D/C 11 10 9 8 7 NOTE: ALL DIMENSIONS ARE IN INCHES TOL: XXX: +/- 0.010 LFSuffix = RoHS Compliant. All specifications are subject to change without notice. © Z-Communications, Inc. All Rights Reserved. URL: www.zcomm.com | EMAIL: applications@zcomm.com Page 2 of 2 FRM-S-002 B