AZ764H

AZ764H 16 AMP HIGH TEMPERATURE MINIATURE POWER RELAY FEATURES • • • • • • • • Ambient Temperature up to 105°C (221°F) Sensitive coil Dielectric strength 5000 Vrms Low height: 15.7 mm 16 Amp switching Isolation spacing greater than 10 mm Proof tracking index (PTI/CTI) 250 Reinforced insulation, EN 60730-1 (VDE 0631, part 1) EN 60335-1 (VDE 0700, part 1) • UL, CUR file E43203 • VDE file 40012572 CONTACTS Arrangement Ratings SPST (1 Form A) Resistive load: Max. switched power: 480 W or 4000 VA Max. switched current: 16 A Max. switched voltage: 300 VDC* or 400 VAC * Note: If switching voltage is greater than 30 VDC, GENERAL DATA Life Expectancy Mechanical Electrical (ohmic load at 105°C / 221°F) Operate Time (typical) Release Time (typical) Minimum operations 3 x 107 1.7 x 105 at 10 A 230 VAC res. 2.8 x 105 at 8 A 230 VAC res. 3.2 x 105 at 6 A 230 VAC res. 7 ms at nominal coil voltage 3 ms at nominal coil voltage (with no coil suppression) special precautions must be taken. Please contact the factory. Rated Load UL, CUR VDE Material Resistance 10 A at 250 VAC general use 10 A at 250 VAC resistive, 105 °C, 150k cycles 16 A at 250 VAC resistive, 105 °C, 10k cycles Silver silver tin oxide < 100 milliohms initially Dielectric Strength 5000 Vrms coil to contact (at sea level for 1 min.) 1000 Vrms between open contacts Insulation Resistance Insulation (according to DIN VDE 0110, IEC 60664-1) Dropout DC coils 105 megohms min. at 20°C 500 VDC 50% RH C250 Overvoltage category: III Pollution degree: 3 Nominal voltage: 250 VAC Greater than 10% of nominal coil voltage At nominal coil voltage -40°C (-40°F) to 105°C (221°F) -40°C (-40°F) to 105°C (221°F) 20 g at 30…500 Hz 30 g P.B.T. polyester, UL-94 ; V0 Tinned copper alloy, P. C. 270°C (518°F) 5 seconds 80°C (176°F) 30 seconds 14 grams 20 per carton tube / 1000 per carton box COIL Power At Pickup Voltage (typical) Max. Continuous Dissipation Temperature Rise Max. Temperature 140 mW (DC coil) 2.2 W at 20°C (68°F) ambient 16°C (29°F) at nominal coil voltage 155°C (311°F) Ambient Temperature Operating Storage Vibration Shock Enclosure Terminals Max. Solder Temp. Max. Solder Time NOTES 1. All values at 20°C (68°F). 2. Relay may pull in with less than “Must Operate” value. 3. Specifications subject to change without notice. Max. Solvent Temp. Max. Immersion Time Weight Packing unit in pcs ZETTLER electronics GmbH Tel. +49 89 800 97 0 Fax +49 89 800 97 200 office@ZETTLERelectronics.com www.ZETTLERelectronics.com 2005-08-04 Junkersstrasse 3, D-82178 Puchheim, Germany AZ764H RELAY ORDERING DATA COIL SPECIFICATIONS - DC COIL Nominal Coil VDC 5 6 9 10 12 18 24 48 Must Operate VDC 3.75 4.5 6.75 7.5 9.0 13.5 18.0 36.0 Max. Continuous VDC 15.0 18.0 27.0 30.0 36.0 54.0 72.0 144.0 Coil Resistance Ohm ±10% 102 144 330 400 580 1,300 2,300 9,340 AZ764H–1AE–5DS AZ764H–1AE–6DS AZ764H–1AE–9DS AZ764H–1AE–10DS AZ764H–1AE–12DS AZ764H–1AE–18DS AZ764H–1AE–24DS AZ764H–1AE–48DS ORDER NUMBER MECHANICAL DATA PC BOARD LAYOUT 1.142 [29.0] Max. 0.500 Max. [12.7] .197 [5.0] .794 [20.16] .098 [2.5] .618 Max. [15.7] .295 [7.5] .098 [2.5] 6 x ø .050 [ø 1.3] .295 [7.5] 4 x .020 [0.5] 2 x ø .024 [ø 0.6] 5 4 x .035 [0.9] .295 [7.5] .154 [3.9] Viewed toward terminals WIRING DIAGRAM 4 2 .197 [5.0] .794 [20.16] .098 [2.5] 8 7 1 Viewed toward terminals Dimensions in inches with metric equivalents in parentheses. Tolerance: ± .010" DC - Coil operating range 3.0 2.6 DC current [A] 16 10 5 50 Max. DC resistive load breaking capacity UB / U N 2.2 1.8 1.4 1.0 0.6 0 20 40 60 80 100 120 Ambient temperature [°C] 1 - no load on contacts, cold coil 2 - no load on contacts 3 - contact load 10A 2 1 0,5 0,1 10 20 30 40 50 100 200 300 DC voltage [V] ZETTLER electronics GmbH Tel. +49 89 800 97 0 Fax +49 89 800 97 200 office@ZETTLERelectronics.com www.ZETTLERelectronics.com 2005-08-04 Junkersstrasse 3, D-82178 Puchheim, Germany