HER104

HER101 THRU HER108 HIGH EFFICIENCY RECTIFIER Reverse Voltage - 50 to 1000 Volts Forward Current - 1.0 Ampere DO-204AL FEATURES * The plastic package carries Underwriters Laboratory Flammability Classification 94V-0 * Low power loss, high efficiency * Low leakage * Low forward voltage * High current capability * High speed switching * High surge capability * High reliability 0.107(2.7) 0.080(2.0) DIA. 0.205(5.2) 0.160(4.1) 1.0(25.4) MIN. 1.0(25.4) MIN. MECHANICAL DATA Case : JEDEC DO-204AL molded plastic Terminals : Plated axial leads , solderable per MIL-STD-750, Method 2026 Polarity : Color band denotes cathode end Mounting Position : Any Weight : 0.012 ounes , 0.3 gram 0.034(0.86) 0.028(0.71) DIA. *Dimensions in inches and (millimeters) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 25 C ambient temperature SYMBOLS HER101 HER102 HER103 HER104 HER105 HER106 HER107 HER108 UNITS unless otherwise specified. Maximum repetitive peak reverse voltage Maximum RMS voltage Maximum DC blocking voltage Maximum average forward rectified current 0.375" (9.5mm) lead length at TL=50 C Peak forward surge current 8.3ms single half sine-wave superimposed on rated load (JEDEC Method) Maximum instantaneous forward voltage at 1.0 A Maximum Full Load Reverse Current Full Cycle average, 0.375" (9.5mm) lead length at TL=55 C Maximum DC reverse current at rated DC blocking voltage Maximum reverse recovery time (NOTE 1) Typical junction capacitance (NOTE 2) Operating junction and storage temperature range o o o VRRM VRMS VDC I(AV) 50 35 50 100 70 100 200 140 200 300 210 300 400 280 400 600 420 600 800 560 800 1000 700 1000 Volts Volts Volts Amps 1.0 IFSM VF IR(AV) 1.0 30 1.3 100 1.7 Amps Volts uA TA=25 C o IR trr CJ TJ,TSTG 50 16 5.0 75 13 -65 to +150 uA nS pF o C NOTES : (1) Reverse recovery test condition : IF 0.5A, IR=1.0A, Irr=0.25A (2) Measured at 1.0 MHz and applied reverse voltage of 4.0 Volts REV. : 0 Zowie Technology Corporation RATINGS AND CHARACTERISTIC CURVES HER101 THRU HER108 FIG.1 - TEST CIRCUIT DIAGRAM AND REVERSE RECOVERY TIME CHARACTERISTICS 1.50 AVERAGE FORWARD RECTIFIED CURRENT, AMPERES 50 NONINDUCTIVE 10 NONINDUCTIVE trr FIG.2 - FORWARD CURRENT DERATING CURVE 1.25 1.00 0.75 0.50 0.25 0.375" (9.5mm) LEAD LENGTH +0.5A (-) PULSE GENERATOR ( NOTE 2 ) Single Phase Half Wave 60Hz Resistive or Inductive Load (+) 25 Vdc ( approx ) (-) D.U.T. 0 -0.25A 1 NONINDUCTIVE OSCILLOSCOPE ( NOTE 1 ) (+) -1.0A NOTES : 1. Rise Time = 7ns max. Input Impedance= 1 megohm. 22pF. 2. Rise Time = 10ns max. Source Impedance= 50 ohms. SET TIME BASE FOR 10/20 ns/cm 0 0 25 50 75 100 125 o 150 175 AMBIENT TEMPERATURE, C FIG.3 - TYPICAL INSTANTANEOUS FORWARD CHARACTERISTICS 10.00 IINSTANTANEOUS FORWARD CURRENT, AMPERES PEAK FORWARD SURGE CURRENT, AMPERES 03 FIG.4 - MAXIMUM NON-REPETITIVE PEAK FORWARD SURGE CURRENT 50 8.3ms SINGLE HALF SINE-WAVE (JEDEC Method) 1~ HE R1 5 4~ HE R1 0 HE R1 0 HE R1 0 HE R1 0 6~ HE R1 0 8 40 1.00 30 20 0.10 10 0 1 PULSE WIDTH=300uS 1% DUTY CYCLE 10 NUMBER OF CYCLES AT 60Hz 100 0.01 0 0.2 0.4 0.6 0.8 1.0 1.2 1.4 1.6 1.8 INSTANTANEOUS FORWARD VOLTAGE, VOLTS FIG.5 - TYPICAL REVERSE CHARACTERISTICS 100 INSTANTANEOUS REVERSE LEAKAGE CURRENT, MICROAMPERES JUNCTION CAPACITANCE, pF FIG.6 - TYPICAL JUNCTION CAPACITANCE 200 100 60 40 20 10 6 4 2 1 .1 .2 .4 1.0 2 4 10 TJ = 25 C o 10 TJ = 150 C TJ = 100 C o o 1.0 TJ = 25 C o HER101~HER105 HER106~HER108 0.1 20 40 100 REVERSE VOLTAGE, VOLTS 0.01 0 20 40 60 80 100 120 140 PERCENT OF RATED PEAK REVERSE VOLTAGE,% REV. : 0 Zowie Technology Corporation