09670500538

D-Sub IP67 plastic hoods IP67 metallized plastic hoods for rear mount Identification No. of contacts Part number Drawing Dimensions in mm D-Sub Hood1) Ø Black thermoplastic 9 15 25 37 50 09 67 009 043 09 67 015 043 09 67 025 043 09 67 037 043 09 67 050 043 . . . . . 9 15 25 37 50 09 67 009 053 09 67 015 053 09 67 025 053 09 67 037 053 09 67 050 053 . . . . . Metallized thermoplastic Pressure washer Rubber gasket Section A-A Mounting screw O-ring seal Please insert digit for screw option Stripping dimensions Locking screw, thread 4-40 UNC þ 8 Locking screw, þ 9 thread M3 Mounting instructions: – The peeled back cable braiding must not extend over the cable clamp, in order not to damage the gasket or to impair its performance. – Pull back cable until cable clamp snaps into shielding plate. – Snap connector into hood. a 05 136  9 15 25 37 50 1) Not to be used with 9 to 50-pole crimp connectors b c 20 16.5 13.0 24 16.5 13.0 24 20.3 13.0 24 20.3 13.0 29 22.0 16.0 d e f g h i 20.2 20.2 24.0 24.0 27.6 22.1 26.6 26.6 26.6 32.1 36.4 36.4 43.6 52.1 52.1 25.0 33.3 47.0 63.5 61.1 39.8 48.5 62.3 78.6 75.7 18.0 18.0 45.0 60.0 60.0 min. 6.0 6.0 8.0 8.0 9.0 Ø max.  8.0 10.5 12.0 12.0 14.0