STC22K33N38-19.200MT

Ceramic SMT 4 Pad Clipped Sinewave (VC)TCXO STC22K Series 2.5mm x 2.0mm Features Applications • ±0.5ppm (Frequency Stability) Available • GPS • Clipped Sinewave • Mobile Communication Equipment • (VC)TCXO • Cellular And Cordless Phones • Tape and Reel • IP Networking Part Numbering Guide STC 22 K 30 R 48 V E - 26.000M SUNTSU TCXO FREQUENCY MHz 2.5mm x 2.0mm CLIPPED SINEWAVE CO M P L I A N T SUPPLY VOLTAGE 18 : 1.8V±5% 25 : 2.5V±5% 27 : 2.7V±5% 28 : 2.8V±5% 30 : 3.0V±5% 33 : 3.3V±5% Cage Code: 4GUT4 To customize your parameters contact a Suntsu representative. Electrical Parameters FREQUENCY STABILITY N : ±5.0ppm O : ±2.5ppm P : ±2.0ppm Q : ±1.5ppm R : ±1.0ppm F : ±0.5ppm TCXO/VCTCXO BLANK : TCXO V : VCTCXO Units Minimum Frequency Range MHz 13 Frequency Tolerance at +25ºC ppm -2.0 +2.0 1 Hour after reflow Freq. Stability vs. Op Temp. ppm -0.5 +0.5 See part numbering guide for options. Freq. Stability vs. Supply Voltage ppm -0.2 +0.2 VDD±5% change. Freq. Stability vs. Load ppm -0.2 +0.2 ±10% change Freq. Stability vs. Aging ppm -1.0 +1.0 1 Year Operating Temperature °C -40 +85 See part numbering guide for options. Storage Temperature °C -55 +125 V 2.985 Supply Voltage (VDD) - 3.0V Option Current (IDD) Control Voltage (VC, VCTCXO) Typical OPERATING TEMPERATURE RANGE 07 : 0°C - +70°C 16 : -10°C - +60°C 17 : -10°C - +70°C 27 : -20°C - +70°C 38 : -30°C - +85°C 48 : -40°C - +85°C Maximum PULLABILITY BLANK : TCXO E : ±12.00ppm F : ±8.0ppm G : ±5.0ppm Remarks 52 3.0 mA 3.015 See part numbering guide for options. 2 V 0 VDD Center Voltage: VDD*50%. Pullability (VCTCXO) ppm ±5.0 ±12.0 See part numbering guide for options. Linearity (VCTCXO) % Output Load (Clipped Sinewave) Output Logic Levels Symmetry (Duty Cycle) 10 kΩ//pF 10//10 VP-P 0.8 % 40 Start-Up Time ms VC Input Impedance (VCTCXO) kΩ 50 2.0 100 Phase Noise (Typical) 10Hz Offset dBc/Hz -85 Phase Noise (Typical) 100Hz Offset dBc/Hz -115 Phase Noise (Typical) 1KHz Offset dBc/Hz -135 Phase Noise (Typical) 10KHz Offset dBc/Hz -145 Phase Noise (Typical) 100KHz Offset dBc/Hz -150 www.suntsu.com Specifications are subject to change without notice. 60 Suntsu Electronics, Inc. 142 TECHNOLOGY DR., SUITE 150 IRVINE, CA 92618 Call: +1-949-783-7300 | Fax: +1-949-783-7301 Ceramic SMT 4 Pad Clipped Sinewave (VC)TCXO STC22K Series 2.5mm x 2.0mm Outline Drawing All dimensions are in millimeters (mm) unless otherwise noted. Drawings are not to scale. 0.8 1 3 2 0.78 1.73 4 0.9 0.65 1.85 0.9 MAX 2.5±0.1 2.0±0.1 0.68 1.45 Top Side Bottom Test Circuit (Clipped Sinewave) Mounting Layout Waveform (Clipped Sinewave) Typical Phase Noise (Measured By Agilent E5052A) Frequency - 26.000MHz www.suntsu.com Specifications are subject to change without notice. Frequency - 40.000MHz Suntsu Electronics, Inc. 142 TECHNOLOGY DR., SUITE 150 IRVINE, CA 92618 Call: +1-949-783-7300 | Fax: +1-949-783-7301 Ceramic SMT 4 Pad Clipped Sinewave (VC)TCXO STC22K Series 2.5mm x 2.0mm Jitter Performance (Measured By Agilent E5052A) Frequency - 26.000MHz Frequency - 40.000MHz Tape And Reel Dimensions All dimensions are in millimeters (mm) unless otherwise noted. Drawings are not to scale. 3,000pcs/Reel Reflow Profile & Part Marking Tp (Time At 260°C. 20-40 Sec) 260 Rup (Ramp Up, 3°C/Sec Max) 217 Temperature (°C) 200 TI (Time Above 217°C. 60-150Sec) 150 Rdn (Ramp Down, 6°C/Sec Max) Ts (Preheat Time. 60-180Sec) T 25°C to Peak (480Sec Max) Time (sec) www.suntsu.com Specifications are subject to change without notice. Suntsu Electronics, Inc. 142 TECHNOLOGY DR., SUITE 150 IRVINE, CA 92618 Call: +1-949-783-7300 | Fax: +1-949-783-7301