250-047

Top PlexiGlas Plate (9 screw holes) Assembly Instructions (Small Philips Screwdriver needed) Step 1: Attach fan to top Plexiglas plate using fan brackets (x2), M3x16 panhead screws (x4), M3x.5 nuts (x4), and lock washers (x2) as shown. Step 2: Attach stand-offs to top Plexiglas plate using acrylic screws. Fan Step 3: Plug FMCOMMS1 board into ML605 board. Attach Fan cable to J33 on ML605 board (near center of board, by FPGA/Fan). Fan Bracket (x2) M3x.5 nut (x4) Step 4: Place top Plexiglas cover upside down on clean surface, and attach FCOMMS/ML605 board to top plate. M3x16 panhead metal screw (x4) Lock washer (x2) Step 5: Attach bottom Plexiglas plate. Step 1: Fan Assembly Detail Step 6: Attach antennas, and attach rubber feet to bottom Plexiglas plate near corners .75" M3x.5 Nylon Standoff (Two locations) 1.25" M3x.5 Nylon Standoff (Five locations) Acrylic Screws (14 locations) ML605 Board FCOMMS1 Board Bottom PlexiGlas Plate (7 screw holes) 1" M3x.5 Nylon Standoff (Two locations) 0.5" M3x.5 Nylon Standoff (Five locations) Mouser Electronics Authorized Distributor Click to View Pricing, Inventory, Delivery & Lifecycle Information: Digilent: 250-047P 240-065P-KIT 240-065